SGS提供专业AS
1577-1993澳洲脚手架踏板检测服务
AS 1577-1993为澳洲专门针对脚手架踏板制定的检测标准,SGS厦门检测中心是SGS建在中国厦门的本地实验室,实验室具备专业的设备,可检测脚手架踏板的刚度(Stiffness
test),强度(Strength
test),滑移(Sliding
test),防滑(Slip
test)等各项测试,为您的脚手架踏板顺利出口澳洲提供有力保障。
主要测试项目 Main Testing Items
刚度测试 Stiffness test
强度测试 Strength test
滑移测试 Sliding test
防滑测试 Slip test
性能要求 Properties
requirements
2.2.1
Stiffness test When tested in accordance with Appendix
A, the
deflection of the
plank
shall not exceed span/100, to a maximum of 25 mm.
刚度测试的变形量不能超过跨距的1/100,最大不超过25mm
2.2.2
Strength test When tested in accordance with Appendix
B,
planks shall comply
with
the following requirements:
强度测试的要求有如下:
(a)
When tested to Paragraph B4(a) to (e),
planks shall not show visual signs of
distress,
buckling or permanent deformation exceeding span/500. In addition timber
planks
shall not show audible signs of distress.
永久变形量不能超过跨距的1/500,且不能在施加力中听到样品中发出声音
(b)
When tested to Paragraph B4(f) and (g),
the failure load shall be not less than
1.1
Ft, where Ft is the test load, in kilonewtons.
破坏力不能低于1.1倍的Ft
(c)
The mode of failure shall be to fail progressively and not break into separate
parts.
样品不能直接断成两半
2.2.3
Sliding test When tested in accordance with Appendix
C,
the force required to
produce
sliding shall be not less than 250 N.
滑移力不能小于250N
2.2.4
Slip test When tested in accordance with Appendix
D,
the plank surface shall
have a static coefficient
of friction of not less than 0.7.
静态摩擦系数不能低于0.7
详细信息请联系SGS:
联系人:吴先生
电话:+86-592 576 5865 /+86 13950102781
传真:+86-592 576 5380
E-Mail: Ray.wu@SGS.COM
地址:中国·福建省厦门市火炬高新区新丰二路8号日华大厦一层A单元