共找到 711 条与 运动用设备及其配合性 相关的标准,共 48 页
Wheelchairs -- Specifications of test dummies
This document specifies requirements and associated test methods for the power, and control systems of electrically powered wheelchairs and scooters. It sets safety and performance requirements that apply during normal use and some conditions of abuse and failure. It also specifies methods of measurement of the forces necessary to operate controls and sets limits on the forces needed for some operations. This document is applicable to electrically powered wheelchairs and scooters with a maximum speed no greater than 15 km/h intended to provide indoor and/or outdoor mobility for one disabled person whose mass lies in the range specified in ISO 7176-11.
Wheelchairs — Part 14: Power and control systems for electrically powered wheelchairs and scooters — Requirements and test methods
What is ISO 16840-12 about? ISO 16840 series has been prepared for wheelchair seating. ISO 16840-12 is one of a series of documents focuses on envelopment and immersion characterization of seat cushions. ISO 16840-12 specifies apparatus, test methods, and disclosure requirements for characterization of wheelchair seat cushion immersion and envelopment properties using indenters instrumented with pressure sensors. ISO 16840-12 includes a method that is specific to 220 mm and 255 mm indenters. Dimensions are provided for 380 mm indenter to allow for the extension of the method to larger patient simulation. Note: ISO 16840-12 does not provide information specific to cushion performance for a particular individual user, nor is it intended to characterize envelopment or immersion under higher loading conditions, nor to assess the weight capacity of a cushion. Who is ISO 16840-12 for?
Wheelchair seating. Envelopment and immersion characterization of seat cushions using a dual semispherical indenter
Wheelchair seating — Part 4: Seating systems for use in motor vehicles
Wheelchairs — Part 10: Determination of obstacle-climbing ability of electrically powered wheelchairs
Wheelchairs — Part 1: Guidelines for the application of the ISO 7176 series on wheelchairs
Wheelchairs — Part 5: Determination of dimensions,mass and manoeuvring space
Wheelchairs — Part 1: Guidelines for the application of the ISO 7176 series on wheelchairs
Wheelchair seating — Part 4: Seating systems for use in motor vehicles
Wheelchairs — Part 10: Determination of obstacle-climbing ability of electrically powered wheelchairs
Wheelchairs — Part 5: Determination of dimensions,mass and manoeuvring space
Tips for assistive products for walking-Requirements and test methods-Part 1:Friction of tips
Tips for assistive products for walking-Requirements and test methods-Part 1:Friction of tips
Orthopedic shoes for children with cerebral palsy
Guide rail lift for people with disabilities
General technical conditions for limb linkage rehabilitation training equipment
1.1 This test method covers the determination of the static load capacity of treestand seats in terms of a factor of safety relative to the manufacturers rated capacity. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Load Capacity of Treestand Seats
Assistive products. Hoists for the transfer of persons. Requirements and test methods
Assistive products for walking manipulated by both arms - Requirements and test methods - Part 2: Rollators (ISO 11199-2:2021)
Assistive products - Hoists for the transfer of persons - Requirements and test methods (ISO 10535:2021)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号