29.035.30 陶瓷和玻璃绝缘材料 标准查询与下载

JB/T 10111-1999 灭弧罩陶瓷件及其材料

本标准规定了灭弧罩陶瓷件及其材料的基本要求，包括：术语、主要性能和技术要求、试验、试验方法及检验规则。 本标准适用于以半干压法或热压铸法制造的工业用交流50Hz（或60Hz），电压至1200V或直流1500V及以下的低压电器灭弧罩陶瓷件及其材料。

Arc chamber ceramic parts and materials

JB/T 8178-1999 悬式绝缘子铁帽.技术条件

本标准主要规定了悬式绝缘子铁帽的技术要求、试验方法、检验规则、标志与包装。 本标准适用于交流架空电力线路盘形悬式瓷或玻璃绝缘子使用的铁帽。

Technical specification of cap for cap and pin insulators

JB/T 1542-1999 110及22kV户外少油断路器用磁套

　　本标准适用于工频额定电压110kV及220kV户外少油断路器用的灭弧室瓷套和支柱瓷套。 本标准不适用于严重污秽地区使用的瓷套。

Ceramic envelope for outdoor low-oil-content circuit-breaker with nominal voltage 110 Kv and 220 Kv

ASTM D5642-99 密封管化学相容性试验的标准试验方法

1.1 This test method covers procedures for evaluating the interaction of electrical insulation components used, or intended to be used, in electrical insulation systems. 1.2 This test method is useful for determining compatibility but additional testing may be required depending upon application. 1.3 This test method may also provide useful information about the behavior of selected insulating materials when compared to a reference value as opposed to a reference system. 1.4 This test method does not cover systems which operate in liquids or gases other than air. 1.5 The values stated in SI units are the standard in this test method. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See also Notes 3, 4 and 8.3.2.1.

Standard Test Method for Sealed Tube Chemical Compatibility Test

DIN EN 60672-3:1999 陶瓷和玻璃绝缘材料.第3部分:单项材料规范

Ceramic and glass-insulating materials - Part 3: Specifications for individual materials (IEC 60672-3:1997); German version EN 60672-3:1997

SNI 04-6127-1999 高压陶瓷绝缘子

Feldspars for middle and high voltage ceramic insulators

ASTM D2400-99(2004) 电绝缘用浸漆玻璃聚酯布的标准规范

1.1 This specification applies to black and yellow varnished woven cloth and tape for electrical insulation, having as a base fabric poly(ethylene terephthalate) yarns in the warp direction and glass yarns in the filler direction.1.2 The values stated in inch-pound units are to be regarded as the standard.

Standard Specification for Varnished Glass-Polyester Cloth Used for Electrical Insulation

BS EN 60454-3-8:1998 电气用压敏胶带规范.单材料规范.带压敏胶粘剂的玻璃纤维

This sheet of IEC 60454-3 contains the requirements for pressure-sensitive adhesive tapes made with glass fabric. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application, and not based on this specification alone.

Specifications for pressure-sensitive adhesive tapes for electrical purposes - Specifications for individual materials - Glass fabric with pressure-sensitive adhesive

NF C26-148-8:1998 电工用压敏胶带.第3部分:专用材料规范.活页8:涂覆压敏胶的玻璃纤维

Pressure-sensitive adhesive tapes for electrical purposes. Part 3 : specifications for individual materials. Sheet 8 : glass fabric with pressure-sensitive adhesive.

DS/EN 60672-3:1998 陶瓷和玻璃绝缘材料 第3部分：个别材料的规范

The part of IEC 60672 is applicable to ceramic, glass-ceramic, glass-mica and glass materials for electrical insulation purposes. It provides, for guidance, a classification of materials for general electrical insulating purposes, and indicates, typical numerical values for the characteristics relevant to each subgroup or type of material as determined by the test methods defined in IEC 60672-2.

Ceramic and glass-insulating materials - Part 3: Specifications for individual materials

IEC 60454-3-8:1998 电工用压敏粘带 第3部分:单项材料规范 活页8:涂压敏粘合剂的玻璃布

This sheet of IEC 60454-3 contains the requirements for pressure-sensitive adhesive tapes made with glass fabric. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application, and not based on this specification alone.

Pressure-sensitive adhesive tapes for electrical purposes - Part 3: Specifications for individual materials - Sheet 8: Glass fabric with pressure-sensitive adhesive

NF C26-401-3*NF EN 60672-3:1998 陶瓷和玻璃绝缘材料.第3部分:专用材料规范

Ceramic and glass-insulating materials. Part 3 : specifications for individual materials.

DIN EN 61067-2:1998 玻璃和玻璃聚酯纤维编织带规范.第2部分:试验方法

Specification for glass and glass polyester fibre woven tapes - Part 2: Methods of test (IEC 61067-2:1992); German version EN 61067-2:1997

DIN EN 61067-3-1:1998 玻璃和玻璃聚酯纤维编织带规范.第3部分:各型材料规范.第1节:1、2、3型织带

Glass and glass polyester fibre woven tapes - Part 3: Specifications for individual materials; Sheet 1: Type 1, 2 and 3 tapes (IEC 61067-3-1:1995); German version EN 61067-3-1:1995

BS EN 60672-3:1998 陶瓷和玻璃绝缘材料 个别材料的规格

This part of IEC 60672 is applicable to ceramic, glass-ceramic, glass-mica and glass materials for electrical insulating purposes. It provides, for guidance, a classification of materials for general electrical insulating purposes, and indicates typical numerical values for the characteristics relevant to each subgroup or type of material as determined by the test methods defined in IEC 60672-2. These numerical values apply only to the specified test specimens and test methods. They cannot necessarily be extended to test specimens and products of other shapes and dimensions or methods of fabrication.

Ceramic and glass insulating materials. Specifications for individual materials

NF C26-156*NF EN 61067-2:1997 玻璃和玻璃聚酯纤维机织带规范.第2部分:试验方法

Specification for glass and glass polyester fibre woven tapes. Part 2 : methods of test.

BS EN 61067-2:1997 玻璃和玻璃聚酯纤维编织带 测试方法

Specifies the test for continuous filament tapes woven on shuttleless looms in order to demonstrate compliance with Parts 1 & 2 of this standard.

Glass and glass polyester fibre woven tapes. Methods of test

GSO IEC 60672-3:1997 陶瓷和玻璃绝缘材料的规范 第 (3) 部分：个别材料

This standard is applicable to ceramic, glass and glass-ceramic materials to be used for electrical insulation purposes.

Specification for ceramic and glass insulating materials - Part 3:Individual materials.

GSO IEC 60672-1:1997 陶瓷和玻璃绝缘材料的规范 第1部分：定义和分类

This standard is applicable to ceramic, glass and glass-ceramic materials to be used for electrical insulation purposes.

Specification for ceramic and glass insulating materials - Part1: Definitions and classification.

IEC 60672-3:1997 陶瓷和玻璃绝缘材料 第3部分:单项材料规范

This part of IEC 60672 is applicable to ceramic, glass-ceramic, glass-mica and glass materials for electrical insulating purposes. It provides, for guidance, a classification of materials for general electrical insulating purposes, and indicates typical numerical values for the characteristics relevant to each subgroup or type of material as determined by the test methods defined in IEC 60672-2. These numerical values apply only to the specified test specimens and test methods. They cannot necessarily be extended to test specimens and products of other shapes and dimensions or methods of fabrication.

Ceramic and glass-insulating materials - Part 3: Specifications for individual materials