29.035.30 陶瓷和玻璃绝缘材料 标准查询与下载

ASTM D2149-97(2004) 频率为10MHz温度至500℃的固体陶瓷电介质电容率(介电常数)及损耗因数的测试方法

Permittivity and dissipation factor are sensitive to changes in chemical composition, impurities, and homogeneity. Measurement of these properties is, therefore, useful for quality control and for determining the effect of environments such as moisture, heat, or radiation.1.1 This test method covers the determination of the relative permittivity (dielectric constant) and dissipation factor of solid ceramic dielectrics from 50 Hz to 10 MHz over a range of temperatures from -80 to 500176C. Two procedures are included as follows: 1.1.1 Procedure A8212;Using Micrometer Electrode. 1.1.2 Procedure B8212;Using Precision Capacitor. Note 18212;In common usage the word "relative" is frequently dropped. 1.2 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Permittivity (Dielectric Constant) And Dissipation Factor Of Solid Ceramic Dielectrics At Frequencies To 10 MHz And Temperatures To 500&176C

BS EN 60371-3-8:1996 以云母为基础的绝缘材料 个别材料的规格 阻燃安全电缆用云母纸带

This International Standard specifies the requirements for an electrical insulating material containing mica paper with glass fabric or plastic film and impregnated with a suitable resin. The material is supplied in a flexible state. It may be supplied in the form of sheets or rolls. The product is designed for use in cables capable of operating after a fire. This specification covers material having a nominal thickness from 0,05 mm to 0,15 mm. Materials which conform to this specification meet established levels of performance. However, the selection of a material for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.

Insulating materials based on mica. Specifications for individual materials. Mica paper tapes for flame-resistant security cables

BS EN 60672-1:1996 陶瓷和玻璃绝缘材料 定义和分类

Gives definitions of terms and classifications applicable to ceramic, glass-ceramic, glass-mica and glass materials for electrical insulating purposes.

Ceramic and glass insulating materials. Definitions and classification

BS 5689-3.2:1995 电气用途的涂漆织物 个别材料的规格 基于玻璃纤维的清漆织物 带有环氧树脂、聚氨酯、硅树脂、聚酯、沥青或油树脂清漆

For glass fabrics with a varnish base using resins categories EP/G, PUR/G, SI/G, PE/G, BT/G and OR/G

Varnished fabrics for electrical purposes. Specifications for individual materials. Glass fabric based varnished fabrics with epoxy, polyurethane, silicone, polyester, bituminous or oleoresinous varnish

BS EN 61067-3-1:1995 玻璃和玻璃聚酯纤维编织带 个别材料的规格 1、2 和 3 型胶带

Specifies requirements for the following tapes. Type 1 - woven on conventional looms with glass fibres. Type 2 - woven on shuttleless looms with glass fibres. Type 3 - woven on shuttleless looms with warp glass fibres and weft polyester fibres.

Glass and glass polyester fibre woven tapes. Specifications for individual materials. Type 1, 2 and 3 tapes

NF C26-111:1995 云母基绝缘材料规范.第1部分:定义和一般要求

Specification for insulating materials based on mica. Part 1 : definitions and general requirements.

IEC 60672-1:1995 陶瓷和玻璃绝缘材料 第1部分:定义和分类

Cancels and replaces the first edition (1980). Applicable to ceramic, glass-ceramic, glass-mica and glass materials for electrical insulating purposes. Gives definitions of terms used, and provides tables classifying the various material types into group

Ceramic and glass insulating materials - Part 1: Definitions and classification

IEC 61067-3-1:1995 玻璃和玻璃聚酯纤维编织带 第3部分:单项材料规范 活页1:1、2、3型织带

Gives the requirements for glass and glass polyester fibre woven tapes.

Glass and glass polyester fibre woven tapes - Part 3: Specifications for individual materials - Sheet 1: Type 1, 2 and 3 tapes

IEC 60371-2/AMD1:1994 以云母为基材的绝缘材料规范 第2部分:试验方法 修改1

Specification for insulating materials based on mica - Part 2: Methods of test; Amendment 1

NF C93-643-300:1993 挠性绝缘套管规范.第3部分:专用套管规范要求.活页300:编织,无涂层玻璃纤维套管

Specification for flexible insulating sleeving. Part 3 : specification requirements for individual types of sleeving. Sheet 300 : glass textile fibre sleeving, braided, uncoated.

JB/T 6746.2-1993 电除尘器用瓷绝缘子.瓷转轴

本标准规定了电除尘器用瓷转轴的型式尺寸、技术要求、试验方法、检验规则以及标志和包装等。 本标准适用于直流额定电压为72、80、90、100kV，工作温度为正值150、250℃，安装地点海拔不超过1000m。 本标准不适用于在足以降低瓷转轴性能和使瓷转轴表面产生凝露的工作环境下使用的绝缘子。

Porcelain insulators for electric precipitation Ceramic rotating shafts

JB/T 6746.1-1993 电除尘器用瓷绝缘子.瓷套

本标准规定了电除尘器用瓷套的型式尺寸、技术要求、试验方法、检验规则以及标志和包装等。 本标准适用于直流额定电压为72、80、90、100kV，工作温度为正值150、200、250℃，安装地点海拔不超过1000m。 本标准不适用于在足以降低瓷套性能和使瓷套表面产生凝露的工作环境下使用的绝缘子。

Porcelain insulators for electric precipitation Ceramic sleeves

NF C26-205:1993 电绝缘液体玻璃转变温度测定的试验方法

Methods of test for the determination of the galss transition temperature of electrical insulationg liquids.

SJ 20386-1993 陶瓷电绝缘材料规范.L级

Insulating compound,eletrical,ceramic.class L

GOST R 50623-1993 云母质绝缘材料.测试方法

Настоящий стандарт распространяется на электроизоляционные материалы, изготовленные из щипаной слюды или слюдяной бумаги с подложкой ил

Insulating materials based on mica. Methods of test

JIS C 2141:1992 电气和电子装置用陶磁绝缘子的试验方法

この規格は，電気機器及び電子機器に使用するセラミック絶縁材料(以下,セラミックスという。)の試験方法について規定する。

Testing methods of ceramic insulators for electrical and electronic applications

IEC 61067-2:1992 玻璃和玻璃聚酯纤维编织带规范 第2部分:试验方法

Gives methods of test to demonstrate compliance with the general requirements of Part 1 (Definitions, classification and general requirements) and Part 3 (Specifications for individual materials). Specifies requirements for loomstate, continuous filament

Specification for glass and glass polyester fibre woven tapes; part 2: methods of test

JB/T 5893.6-1991 电瓷用原料.钾长石化学分析方法

本标准规定了钾长石的烧失量、二氧化硅、三氧化二铁、二氧化钛、三氧化二铝、氧化钙、氧化镁、氧化钾、氧化钠的化学分析方法。 本标准适于电瓷用钾长石化学成分的分析。

Raw materials of electrotechnical porcelain Chemical analysis method of potash feldspar

JB/T 5893.5-1991 电瓷用原料.物理性能试验方法

本标准规定了电磁用原料长石、石英、粘土、高铝矾土的物理性能试验方法。 本标准适用于电磁用原料长石、石英、粘土、高铝矾土的物理性能测定，也适用于电瓷坯、釉材料部分物理性能测定。

Raw materials of electrotechnical porcelain Test method of physical property

IEC 60684-3-400 to 402:1991 绝缘软套管规范.第3部分:各种型号套管的规范要求.第400至402活页:有机硅橡胶涂层的玻璃纤维织物软套管

Specification for flexible insulating sleeving; part 3: specification requirements for individual types of sleeving; sheets 400 to 402: glass textile sleeving with silicone elastomer coating