29.140.50 照明安装系统 标准查询与下载
共找到 144 条与 照明安装系统 相关的标准，共 10 页
This part of IEC 61534 specifies general requirements and tests for powertrack (PT) systems with a rated voltage not exceeding 277 V a.c. single phase@ or 480 V a.c. two or three phase 50 Hz/60 Hz with a rated current not exceeding 63 A. These systems are used for distributing electricity in household@ commercial and industrial premises. Powertrack systems@ according to this standard@ are intended for use under the following conditions: ?C an ambient temperature in the range ?C5 ??to + 40 ?? the average value over a 24 h period not exceeding 35 ?? ?C a situation not subject to a source of heat likely to raise temperatures above the limits specified above; ?C an altitude not exceeding 2000 m above sea level; ?C an atmosphere not subject to excessive pollution by smoke@ chemical fumes@ prolonged periods of high humidity or other abnormal conditions. In locations where special conditions prevail@ as in ships@ vehicles and the like and in hazardous locations@ for instance@ where explosions are liable to occur@ special constructions may be necessary. This standard does not apply to ?C cable trunking systems and cable ducting systems covered by IEC 61084 [8] 1; ?C busbar trunking systems covered by IEC 60439-2 [5]; ?C electrical supply track systems for luminaires covered by IEC 60570 [6].
Powertrack systems - Part 1: General requirements
- ICS
- 29.140.50
- CCS
- P91
- 发布
- 2011-05
- 实施
- 2011-05-20
Stage lighting system process design guidelines
- ICS
- 29.140.50
- CCS
- P91
- 发布
- 2011-03-23
- 实施
- 2011-06-01
本标准规定了采用风能和太阳能互补发电、蓄电池储能供电、以LED为光源的道路和街路照明装置的安全和性能要求。 本标准适用于离网型、以风光互补供电的照明装置。
Wind-solar photovoltaic hybrid energized road and street lighting equipment with LED
- ICS
- 29.140.50
- CCS
- K70
- 发布
- 2010-12-29
- 实施
- 2011-04-01
规定了LED路灯施工要求、LED高杆灯、半高杆灯施工要求;LED路灯验收要求、LED高杆灯、半高杆灯验收要求
Norm of Engineering,Checking and Acceptance For LED Illumination Project PartⅢ：Checking and Acceptance for Roading LED Illumination
- ICS
- 29.140.50
- CCS
- K70
- 发布
- 2010-08-27
- 实施
- 2010-12-01
规定了LED照明工程的验收原则、验收组织、验收程序、验收内容和方法
Norm of Engineering,Checking and Acceptance For LED Illumination Project PartⅡ：Checking and Acceptance
- ICS
- 29.140.50
- CCS
- K70
- 发布
- 2010-08-27
- 实施
- 2010-12-01
Specifications for making and installing advertising plaque facilities
- ICS
- 29.140.50
- CCS
- K72
- 发布
- 2010-07-27
- 实施
- 2011-05-01
This International Standard specifies a protocol for control by digital signals of electronic lighting equipment used on a.c. or d.c. supplies.
Digital addressable lighting interface - Part 101: General requirements - System
- ICS
- 29.140.50
- CCS
- 发布
- 2009-12-04
- 实施
- 2009-12-04
IEC 62386-206:2009 specifies a protocol and test methods for the control by digital signals of electronic control gear, associated with the conversion from digital signal into d.c. voltage. This Part 206 is intended to be used in conjunction with IEC 62386-101 and IEC 62386-102, which contain general requirements for the relevant product type (control gear or control devices).
Digital addressable lighting interface - Part 206: Particular requirements for control gear - Conversion from digital signal into d. c. voltage (device type 5)
- ICS
- 29.140.50
- CCS
- 发布
- 2009-11-05
- 实施
- 2009-12-01 (7)
IEC 62386-205:2009 specifies a protocol and test procedures for the control by digital signals of electronic control gear associated with incandescent lamps. This Part 205 is intended to be used in conjunction with IEC 62386-101 and IEC 62386-102, which contain general requirements for the relevant product type (control gear or control devices).
Digital addressable lighting interface - Part 205: Particular requirements for control gear - Supply voltage controller for incandescent lamps (device type 4)
- ICS
- 29.140.50
- CCS
- 发布
- 2009-11-05
- 实施
- 2009-12-01 (7)
Powertrack systems - Part 22: Particular requirements for powertrack systems intended for on floor or under floor installation (IEC 61534-22:2009); German version EN 61534-22:2009
- ICS
- 29.140.50
- CCS
- P91
- 发布
- 2009-11
- 实施
- 2009-11-01
IEC 62386-204:2009 specifies a protocol and methods of test for the control by digital signals of electronic control gear for use on a.c. or d.c. supplies, associated with low voltage halogen lamps. This part 204 is intended to be used in conjunction with IEC 62386-101 and IEC 62386-102, which contain general requirements for the relevant product type (control gear or control devices).
Digital addressable lighting interface - Part 204: Particular requirements for control gear - Low voltage halogen lamps (device type 3)
- ICS
- 29.140.50
- CCS
- 发布
- 2009-08-27
- 实施
- 2009-10-01 (7)
IEC 62386-202:2009 specifies a protocol and test procedures for the control by digital signals of electronic control gear for use on a.c. or d.c. supplies, associated with self-contained emergency lighting. This Part 202 is intended to be used in conjunction with IEC 62386-101 and IEC 62386-102, which contain general requirements for the relevant product type (control gear or control devices).
Digital addressable lighting interface - Part 202: Particular requirements for control gear - Self-contained emergency lighting (device type 1)
- ICS
- 29.140.50
- CCS
- 发布
- 2009-08-27
- 实施
- 2009-10-01 (7)
IEC 62386-208:2009 specifies a protocol and test methods for the control by digital signals of electronic control gear that switches its output only on and off. This Part 208 is intended to be used in conjunction with IEC 62386-101 and IEC 62386-102, which contain general requirements for the relevant product type (control gear or control devices).
Digital addressable lighting Interface - Part 208: Particular requirements for control gear - Switching function (device type 7)
- ICS
- 29.140.50
- CCS
- 发布
- 2009-08-27
- 实施
- 2009-10-01 (7)
IEC 62386-203:2009 specifies a protocol and test procedures for the control of electronic control gear by digital signals used on a.c. or d.c. supplies, associated with discharge lamps (excluding fluorescent lamps). This Part 203 is intended to be used in conjunction with IEC 62386-101 and IEC 62386-102, which contain general requirements for the relevant product type (control gear or control devices).
Digital addressable lighting interface - Part 203: Particular requirements for control gear - Discharge lamps (excluding fluorescent lamps) (device type 2)
- ICS
- 29.140.50
- CCS
- 发布
- 2009-08-27
- 实施
- 2009-10-01 (7)
IEC 61822:2009 specifies the requirements for a Constant Current Regulator (CCR) having a nominal output of 6,6 A for use in an aeronautical ground lighting constant current series circuit. However, CCRs may be manufactured which have a different power rating (kVA) and current steps than those specified in this standard in order to be used on existing circuits. This standard should be applied where appropriate for these CCRs. This second edition cancels and replaces the first edition published in 2002. It is a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) revision and update of terms and definitions; b) addition of new paragraphs, such as 'Nominal output current range and tolerances'; c) modification of some paragraphs, such as those related to 'Local control' and 'Remote control'; d) deletion of some paragraphs, in particular 'Power transformers' and 'Output current indicator'.
Electrical installations for lighting and beaconing of aerodromes - Constant current regulators
- ICS
- 29.140.50
- CCS
- 发布
- 2009-07-15
- 实施
- 2009-09-01 (7)
Powertrack systems - Part 22 : particular requirements for powertrack systems intended for on floor or under floor installation.
- ICS
- 29.140.50
- CCS
- P91
- 发布
- 2009-06-01
- 实施
- 2009-06-13
이 표준은 건물의 옥내 주차장, 천장 내부, 전시장 등에 사용되는 조명 기구를 지지 및 보
Raceway
- ICS
- 29.140.50
- CCS
- K10
- 发布
- 2008-09-29
- 实施
- 2008-09-29
本标准规定了火力发电厂和变电站照明设计的基本要求。 本标准适用于火力发电厂和变电站的新建、扩建和改建的照 明设计。
Lighting technical code for designing fossil fuel power plants and substations
- ICS
- 29.140.50
- CCS
- P60;K70
- 发布
- 2007-07-20
- 实施
- 2007-12-01
