29.160.40 发电机组 标准查询与下载

T/CEEIA 586-2022 风力发电机组 运行及并网性能检验检测评价方法

本文件规定了风力发电机组的性能参数的定义、测量程序和评价方法，内容包括： ——对并网型风力发电机组运行性能参数的定义和定量描述； ——对并网型风力发电机组并网性能参数的定义和定量描述； ——量化性能特性参数的检验检测程序； ——性能特性参数符合性评估要求。 本文件适用于与电网三相连接的风轮扫略面积大于200㎡的单台水平轴风力、任何容量的发电机组的测试。同时包含了可用于风电场测试的信息。测量程序也可作为其他风力发电机组（例如，小型风力发电机组、管道式风力发电机组、垂直轴风力发电机组）性能特性测试的指南。测量得到的性能特性参数仅对特定配置和运行模式的被测风力发电机组类型有效。其他机组配置,包括改变控制参数会引起风力发电机组的性能特性发生变化，需要另行评估。测量程序是尽可能的按照非特定场地的要求进行设计的，因此，在某一测试场地的测量结果同样适用于其他场地。

Wind energy generation systems - integrated inspection, test and evaluation method of operation and grid connection performance

T/CEEMA 001-2022 煤电机组汽轮机节能、供热和灵活性改造技术导则

本导则主要规范了以下内容： 煤电机组汽轮机节能、供热、灵活性改造相关术语和定义。 煤电机组汽轮机节能、供热、灵活性改造的总体和具体要求。

Technical guide for energy conservation, heating, flexibility retrofits of coal-fired power steam turbines

ASTM D6224-22 辅助发电厂设备用润滑油运行监测的标准实施规程

1.1 This practice covers the requirements for the effective monitoring of mineral oil and phosphate ester fluid lubricating oils in service auxiliary (non-turbine) equipment used for power generation. Auxiliary equipment covered includes gears, hydraulic systems, diesel engines, pumps, compressors, and electrohydraulic control (EHC) systems. It includes sampling and testing schedules and recommended action steps, as well as information on how oils degrade. NOTE 1—Other types of synthetic lubricants are sometimes used but are not addressed in this practice because they represent only a small fraction of the fluids in use. Users of these fluids should consult the manufacturer to determine recommended monitoring practices. 1.2 This practice does not cover the monitoring of lubricating oil for steam and gas turbines. Rather, it is intended to complement Practice D4378. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for In-Service Monitoring of Lubricating Oil for Auxiliary Power Plant Equipment

22/30435992 DC BS EN 60364-7-751 Ed.1.0 低压电气装置 第 7-751 部分 特殊安装或位置的要求 低压发电机组

BS EN 60364-7-751 Ed.1.0. Low-voltage electrical installations - Part 7-751. Requirements for special installations or locations. Low voltage generating sets

T/JSQA 116-2021 汽油/液化石油气/天然气 三燃料发电机组

本文件适用于额定功率15kW及以下的汽油/液化石油气/天然气三燃料发电机组。

Gasoline/LPG/NG Tri-Fuel Portable Generator Set

T/ZZB 2566-2021 往复式内燃机驱动的小功率交流发电机组用发电机

本文件规定了往复式内燃机驱动的小功率交流发电机组用发电机的术语和定义、型式、 分类与基本参数、基本要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存及质量承诺。 本文件适用于额定电压690 V及以下，额定频率为50 Hz或60 Hz，额定有功功率不大于10 kW，由往复式内燃机驱动的小功率交流发电机组用发电机（以下简称发电机） 。

Generators for reciprocating internal combustion engine driven low power alternating current generating sets

DIN EN IEC 62040-1/A11:2021 不间断电源系统（UPS） 第1部分：安全要求；德文版 EN IEC 62040-1:2019/A11:2021

This European Standard has been prepared under a Commission´s standardization request relating to harmonized standards in the field of the Low Voltage Directive, M/511, to provide one voluntary means of conforming to safety objectives of Directive 2014/35/EU of the European Parli

Uninterruptible power systems (UPS) - Part 1: Safety requirements; German version EN IEC 62040-1:2019/A11:2021

GSO ASTM D6224:2021 辅助发电厂设备润滑油在役监测的标准实施规程

1.1 This practice covers the requirements for the effective monitoring of mineral oil and phosphate ester fluid lubricating oils in service auxiliary (non-turbine) equipment used for power generation. Auxiliary equipment covered includes gears, hydraulic systems, diesel engines, pumps, compressors, and electrohydraulic control (EHC) systems. It includes sampling and testing schedules and recommended action steps, as well as information on how oils degrade. NOTE 1—Other types of synthetic lubricants are sometimes used but are not addressed in this practice because they represent only a small fraction of the fluids in use. Users of these fluids should consult the manufacturer to determine recommended monitoring practices. 1.2 This practice does not cover the monitoring of lubricating oil for steam and gas turbines. Rather, it is intended to complement Practice D4378. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for In-Service Monitoring of Lubricating Oil for Auxiliary Power Plant Equipment

T/CEEIA 501-2021 陆上风力发电机组基础及塔架结构监测系统技术规范

本文件规定了风力发电机组基础和塔架结构监测项目的总则、系统设计、监测点布置、施工、数据处理与信息反馈、监测报警、维护等要求。 本文件适用于新建、改扩建陆上风电场的风力发电机组基础及塔架结构的监测系统。

Onshore Wind Turbine Foundation and Tower Structure Monitoring System Techinal Specifications

IEC 62040-3:2021 不间断电源系统(UPS). 第3部分: 规定性能的方法和试验要求

This part of IEC 62040 establishes the performance and test requirements applied to movable, stationary and fixed electronic uninterruptible power systems (UPS) that are supplied from AC voltage not exceeding 1000 V; deliver AC output voltage not exceeding 1000 V; incorporate an

Uninterruptible power systems (UPS) - Part 3: Method of specifying the performance and test requirements

T/CICEIA /CAMS25-2021 应急和备用柴油发电机组 通用技术条件

本文件规定了应急和备用柴油发电机组的技术要求、成套性、标志、包装、运输和贮存、试验项目和方法、检验规则。 本文件适用于功率小于或等于3 200 kW，额定频率为50 Hz的应急和备用柴油发电机组（以下简称柴油发电机组）。60 Hz的柴油发电机组也可参照使用。 具体技术内容见标准文本。

General specification for emergency and standby diesel generating set

ANSI/CAN/UL/ULC 2200:2022 固定式发动机发电机组件

Scope 1.1 These requirements cover stationary engine generator assemblies that are intended for installation and use in ordinary locations in accordance with the following: a) The National Electrical Code, NFPA 70; b) The Canadian Electrical Code, Part I, CSA C22.1; c) The Standard for the Installation and Use of Stationary Combustion Engines and Gas Turbines, NFPA 37; d) Natural Gas and Propane Installation Code, CSA B149.1; e) The Code for Digester Gas, Landfill Gas, Biogas Generation and Utilization, ANSI/CSA B149.6; f) The Installation Code for Oil-Burning Equipment, CSA B139; g) The Standard for Health Care Facilities, NFPA 99; h) The Code for Canadian Health Care Facilities, CSA Z8000; i) The Standard for Emergency, Standby Power Systems, NFPA 110; and j) Emergency Electrical Power Supply for Building, CSA C282. 1.2 Units that incorporate a pressure vessel shall comply with the following: a) ASME Boiler and Pressure Vessel Code; b) Boiler, Pressure Vessel, and Pressure Piping Code, CSA B51; c) Process Piping, ASME B31.3; and d) Gas-Fired Low Pressure Steam and Hot Water Boilers, ANSI Z21.13 / CSA 4.9 1.3 Hazards addressed by this Standard include electrical (energy, shock, explosion, and fire), mechanical (enclosures and moving parts), fuel related (containment and flow control for liquid and gaseous fuels including purge / dilution functions), and prime mover related hazards. 1.4 These requirements do not cover engine generator assemblies for use in hazardous (Classified) locations. 1.5 These requirements do not cover engine generator assemblies for shipboard marine applications.

Stationary Engine Generator Assemblies

JB/T 10304-2020 工频汽油发电机组技术条件

Technical conditions of power frequency gasoline generator set

JB/T 1403-2020 移动电站 产品型号编制规则

Mobile power station product model compilation rules

JB/T 13919-2020 低噪声内燃机电站通用规范

General specifications for low-noise internal combustion engine power stations

JB/T 8182-2020 交流移动电站用控制屏 通用技术条件

　　本标准规定了用内燃机驱动交流工频(50Hz)、中频(400Hz)、双频(50Hz、400Hz)发电机的内燃机电站(含汽车电站、挂车电站、移动式发电机组、固定式发电机组)用控制屏的技术要求、试验方法、检验规则、标志及储运要求等。 本标准适用于额定电压不高于500V，额定频率不大于1200kW的电站用控制屏。 60Hz电站用控制屏可参照使用。

General technical conditions for control panel of AC movable power plant

JB/T 13918-2020 内燃机电站 可靠性考核评定方法

Internal combustion engine power station reliability assessment and evaluation method

JB/T 7605-2020 移动电站额定功率、电压及转速

　　本标准规定了用燃机为原动机的下列类型的一般用途的移动电站（含汽车电站、挂车电站、移动式发电机组）的额定功率、额定电压和额定转速的等级： a. 工频（50Hz）电站（60Hz电站可参考使用）； b. 中频（400Hz）电站； c. 双频（50Hz、400Hz）电站； d. 直流电站（含内燃机组经整流装置供电的类型）； 本标准适用于0.3～1250kW的电站。

Rated power, voltage and rotation rate of mobile generator sets

JB/T 9583.2-2020 气体燃料发电机组 第2部分：额定功率、电压及转速

　　本标准规定了燃烧气体燃料的工频交流发电机组的额定功率、额定电压和额定转速的等级。 本标准适用于频率为50Hz，单相机组功率因数为0.9(滞后)或1.0、三相机组功率因数为0.8(滞后)，燃烧天然气、沼气、发生炉煤气、城市煤气的交流单相机组。 60Hz机组可参照使用。

Rated output, voltage and speed for gas fuel generating sets

JB/T 10303-2020 工频柴油发电机组 技术条件

Technical conditions of power frequency diesel generator set