共找到 351 条与 输电网和配电网 相关的标准,共 24 页
IEC 61643-31:2018 is applicable to Surge Protective Devices (SPDs), intended for surge protection against indirect and direct effects of lightning or other transient overvoltages. These devices are designed to be connected to the DC side of photovoltaic installations rated up to 1 500 V DC. These devices contain at least one non-linear component and are intended to limit surge voltages and divert surge currents. Performance characteristics, safety requirements, standard methods for testing and ratings are established. SPDs complying with this standard are exclusively dedicated to be installed on the DC side of photovoltaic generators and the DC side of inverters. SPDs for PV systems with energy storage (e.g. batteries, capacitor banks) are not covered. SPDs with separate input and output terminals that contain specific series impedance between these terminal(s) (so called two-port SPDs according to IEC 61643-11:2011) are not covered. SPDs compliant with this standard are designed to be permanently connected where connection and disconnection of fixed SPDs can only be done using a tool. This standard does not apply to portable SPDs Keywords: photovoltaic installations, lightning or other transient overvoltages
Low-voltage surge protective devices - Part 31: Requirements and test methods for SPDs for photovoltaic installations
Specification for construction quality checkout and evaluation of electric equipment installation Part 15:Electric device of explosion atmospheres
Test method for energy consumption of overhead conductors
Specification for construction quality checkout and evaluation of electric equipment installation Part 6:Earthing device
General technical requirements for robot inspection system for overhead transmission lines
General technical requirements for transformer winding deformation tester
Specification for construction quality checkout and evaluation of electric equipment installation Part 16:1kV and under feeder cable engineering
Specification for construction quality checkout and evaluation of electric equipment installation Part 13:Power converter equipment
Calibration specification for transformer winding deformation tester
Technical conditions of sulfur hexafluoride detector - decomposition product detector
Specification for construction quality checkout and evaluation of electric equipment installation Part 9:Battery
Provisions on the content depth of preliminary design documents for electric power data communication network engineering
Time Synchronization System for Power System Part 3: Technical Specifications for Time Synchronization Based on Digital Synchronization Network
Standardized Interface Specifications for Converter Transformers in HVDC Transmission Systems
General technical requirements for capacitance current tester
On-site pollution measurement and assessment part 1: general principles
Grid DC Bias Risk Assessment and Defense Guidelines
Specification for construction quality checkout and evaluation of electric equipment installation Part 7:Electrical rotating machines
Stacker reclaimer operation and maintenance guidelines
Calibration specification for partial discharge detector based on transient earth voltage method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号