29.240.10 标准查询与下载

IEC 60099-4:2004 避雷器.第4部分:交流电系统用无间隙金属氧化物避雷器

Applies to non-linear metal-oxide resistor type surge arresters without spark gaps designed to limit voltage surges on a.c. power circuits.

Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems

NF C61-740F1:2004 2002年9月NF EN 61643-11号标准第61643-11 F1号说明书

September 2002 NF EN 61643-11 Standard No. 61643-11 F1 Instruction

JIS C 5381-1:2004 接到低压配电系统的电涌保护设备.性能要求和试验方法

この規格は，50/60Hzの交流1000V以下又は直流1500V以下の電源回路及び機器に接続するサージ防護デバイス(SPD)の所要性能，標準試験方法及び定格について規定する。

Surge protective devices connected to low-voltage power distribution systems -- Performance requirements and testing methods

ANSI/IEEE 1573:2003 电子大功率子系统的推荐规程:参数、接口、元件和性能

Provides a technical basis for implementation of electronic power subsystems. It is intended for electronic systems engineers and integrators, electronic power subsystem designers and integrators, as well as power element manufacturers and suppliers. It addresses system-level issues in element or subsystem integration, adaptation, and accommodation. It also defines system interface parameters, test methods, and test conditions.

Recommended Practice for Electronic Power Subsystems: Parameters, Interfaces, Elements, and Performance

UL 1640 BULLETINS-2004

These requirements cover portable power-distribution equipment intended to distribute power in accordance with the National Electrical Code, NFPA 70(NEC).

3/29/2004 (8p)

DS/EN 61643-11:2003 低压电涌保护器 第11部分：连接到低压电力系统的电涌保护器 要求和测试

This part of IEC 61643 is applicable to devices for surge protection against indirect and direct effects of lightning or other transient overvoltages. These devices are packaged to be connected to 50/60 Hz a.c. and d.c. power circuits, and equipment rated up to 1 000 V r.m.s. or 1 5000 V d.c. Performance characteristics, standard methods for testing, and ratings are established for these devices that contain at least one nonlinear component that is intended to limit surge voltages and divert surge currents.

Low-voltage surge protective devices - Part 11: Surge protective devices connected to low-voltage power systems - Requirements and tests

LST EN 61643-11-2003 低压电涌保护器 第11部分：连接到低压电力系统的电涌保护器 要求和测试（IEC 61643-1:1998+AC:1998，已修改）

Low-voltage surge protective devices. Part 11: Surge protective devices connected to low-voltage power systems. Requirements and tests (IEC 61643-1:1998+AC:1998, modified)

UL 1640 BULLETIN-2003

These requirements cover portable power-distribution equipment intended to distribute power in accordance with the National Electrical Code, NFPA 70(NEC).

9/5/2003 (2p); 6/2/2003 (8p); 3/19/2003 (10p)

ANSI/IEEE C37.122.1:2002 气体绝缘变电站导则

Provides information of special relevance to the planning, desing, testing, installation, operation, and maintenance of gas-insulated substations and equipment.

Guide for Gas-Insulated Substations

IEC 60099-6:2002 避雷器.第6部分:额定电压等于或低于52kV的含有串联及并联间隙结构的避雷器

This part of IEC 60099 applies to non-linear metal-oxide resistor type surge arresters with spark gaps designed to limit voltage surges on a.c. power circuits. It applies to all metal-oxide surge arresters with gaps and housed in either porcelain or poly

Surge arresters - Part 6: Surge arresters containing both series and parallel gapped structures; Rated 52 kV and less

DS/EN 61643-311:2002 低压电涌保护器元件 第311部分：气体放电管（GDT）规范

Gas discharge tubes (GDTs) are used for applications up to 1 000 V a.c. or 1 500 V d.c. in communication or signalling circuits. They are defined as a gap, or series of gaps, in an enclosed discharge medium other than air. They are designed to protect apparatus or personnel, or both, from high transient voltages. This standard does not specify requirements applicable to complete surge protective devices, nor does it specify total requirements for GDTs employed within electronic devices, where precise coordination between GDT performance and surge protective device withstand capability is highly critical. This part of IEC 61643 - deals with GDTs having two o

Components for low-voltage surge protective devices - Part 311: Specification for gas discharge tubes (GDT)

DS/EN 61643-341:2002 低压电涌保护器元件 第341部分：晶闸管电涌抑制器（TSS）规范

This part of IEC 61647 is a test specification standard for Thyristor Surge Suppressor, TSS, components. These components are designed to limit overvoltages and divert surge currents by clipping and crowbarring actions. These components are used in the construction of surge protective devices, particularly in the telecommunications area. This present publication contains information on: - terms, letters, symbols and definitions; - basic function and component description; - service conditions and fault modes; - rating verification and characteristic meausurement.

Components for low-voltage surge protective devices - Part 341: Specification for thyristor surge suppressors (TSS)

DS/EN 61643-21:2002 低压电涌保护器 第21部分：连接到电信和信号网络的电涌保护器 性能要求和测试方法

This standard is applicable to devices for surge protection of telecommunication and signalling networks against indirect and direct effects of lightning or other transient overvoltages.

Low voltage surge protective devices - Part 21: Surge protective devices connected to telecommunications and signalling networks - Performance requirements and testing methods

SANS 61643-12:2002 低压电涌保护装置．第12部分．连接到低压配电系统的电涌保护装置．选择和应用原则

This parts of IEC 61643 describes the principles for selection, operation, location and co-ordination of SPDs to be connected to 50 Hz to 60 Hz a.c. and to d.c. povver circuits and equipment rated up to 1 000 V r.m.s. or 1 500 V d.c. NOTE 1 Additional requirements may be necessary for special applications such as electrical traction, etc. NOTE 2 It should be remembered that IEC 60364 is also applicable. NOTE 3 This standard deals only with SPDs and not with SPDs components integrated inside equipment.

Low-voltage surge protective devices Part 12: Surge protective devices connected to low-voltage power distribution systems -Selection and application principles

IEC 61643-12:2002 低压电涌保护装置.第12部分:连接到低压配电系统的电涌保护装置.选择和应用原理

This parts of IEC 61643 describes the principles for selection, operation, location and co-ordination of SPDs to be connected to 50 Hz to 60 Hz a.c. and to de. power circuits and equipment rated up to 1 000 V r.m.s, or 1 500 V d.c. NOTE 1 Additional requirements may be necessary for special applications such as electrical traction, etc. NOTE 2 It should be remembered that IEC 60364 is also applicable. NOTE 3 This standard deals only with SPDs and not with SPDs components integrated inside equipment.

Low-voltage surge protective devices - Part 12: Surge protective devices connected to low-voltage power distribution systems; Selection and application principles

IEEE 837-2002 变电站接地用永久性连接件的鉴定

Provides direction and methods for qualifying permanent connections used for substation grounding. Particulary addresses the connection used within the grid system, the connection used to join ground leads to the grid system, and the connection used to join the ground leads to equipment and structures.

Qualifying permanent connections used in substation grounding

DS/EN 60099-1+A1:2001 电涌放电器 第1部分：用于交流系统的非线性电阻器型间隙电涌放电器

This part of International Standard IEC 99 applies to surge protective devices designed for repeated operation to limit voltage surges on a.c. power circuits and to interrupt power-follow current. In particular, it applies to surge arresters consisting of single or multiple spark gaps in series with one or more non-linear resistors.

Surge arresters - Part 1: Non-linear resistor type gapped surge arresters for a.c. systems

DIN EN 60099-1 Berichtigung 1:2000 DIN EN 60099-1技术勘误

Corrigendum to DIN EN 60099-1 (VDE 0675 Teil 1):2000-08

DIN EN 60099-5:2000 电涌放电器.第5部分:选用推荐标准

Surge arresters - Part 5: Selection and application recommendations (IEC 60099-5:1996, modified + A1:1999); German version EN 60099-5:1996 + A1:1999

DS/EN 60099-5/A1:2000 电涌放电器 第5部分：选择和应用建议

This part of IEC 60099 provides recommendations for the selection and application of surge arresters to be used in three-phase systems with nominal voltages above 1 kV. It applies to non-linear resistor type gapped surge arresters as defined in IEC 60099-1 and to gapless metal-oxide surge arresters as defined in IEC 60099-4.

Surge arresters - Part 5: Selection and application recommendations