共找到 23 条与 相关的标准,共 2 页
The standard contains pictographs used as symbols for marking controls of powered support. By assigning a standard meaning to such pictographs, a marking independent on spoken or written language is arrived at.#,,#
Mine support; graphical symbols for the open loop control of powered support
The inspectorate's regulations require marking of support components made of steel, cast iron, or light alloys. DIN 21549 contains the terms and definitions of powered-support components. DIN 21546 contains the markings of said components.
Mine support; strut support; marking
The specifications of this standard relate to the accuracy of clamping plates on steel supports. They ar part of the securing system, primarily for rails on rail switches. These clamping plates are characterized by pins serving as additional arrestors.#,,#
Clamping plates for securing rails onto steel supports
Planks and beams according to this standard are used for lagging as well as for setting-up of explosion barriers, stowage cofferings, ventilation doors, chocks and shutterings.#,,#
Sawn pit timber; boards and planks
This standard applies to props and canopies made from round timber as per DIN 21316 and DIN 21320 for mine support pueposes, and contains the calculation route for the determination of the supporting capacity of round timber in the critical ranges of bending and buckling.#,,#
Round pit timber; load bearing capacity of props and bars; calculation
This standard is to set the dimensions and qualitities for chock wood which is to be used for supporting purposes.
Round pit timber; pillar, supports
Sawn pit timber; boards, planks and square-sawn timber for working platforms
This standard sets dimensions for struts. Struts are round timbers used for the prevention of longitudinal displacement and deflection of mine support.
Round pit timber; bolts
This standard sets the requirements for rails used for the manufacture for supports.
Rails for mine supports
Mine support; roof bars for single props; testing, requirements
For better understanding, the terms within powered support need to be defined. This standard contains systems and definitions of terms for components, working cycles, and forces in handling and operation of powered support.#,,#
Mine supports; powered walking supports; terminology
This standard applies to slabbing offcut used underground for lagging. Slabbing offcuts are produced when squaring round timber. Round slabbs are offcut with one smooth surface. Facing boards exhibit cut surface (in parallel) over their whole length the width of the smaller cut surface corresponding to less of two thirds of the greatest width of the broader cut surface.
Cut pit timber; slabs
These quality specifications and terms of delivery apply mainly to props, canopies and half-round pieces of timber as per DIN 21316, for bars and split bars as per DIN 21317, and for struts as per DIN 21319, made from leaf or pinewood and used in mining; in their original round shape, cut over their length once or several times, squared, with or without their bark. Squared timber is round timber sawn over the whole length, the width of the cut surface being approximately equal to half the diameter of the round timber.
Round pit timber; technical quality and delivery requirements
These quality specifications and terms of delivery for cut mine timber apply to leafwood and pinewood used in mining e.g. as dressed timber as per DIN 21321 or as tramboards, planks or dressed timber as per DIN 21327. For shaftguides DIN 21341 applies.#,,#
Cut pit timber; technical terms of delivery and quality
This standard applies to round timber in form of bars and split bars used unterground for lagging.
Round pit timber; timber for lagging
Mine support; valves for individual props; identification code
The standard contains requirements for identification marking.
Mine support; yield valves for powered support; identification code
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号