H63 稀有高熔点金属及其合金 标准查询与下载

ASTM B760-07 钨制厚板材、薄板材和箔的标准规范

1.1 This specification covers wrought unalloyed tungsten plate, sheet, and foil.1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.1.3 The following precautionary caveat pertains only to the test method portions of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Tungsten Plate, Sheet, and Foil

KS D 8543-2006 电解黑色铬及镍镀金

이 규격은 전착 흑색 크롬 및 니켈 도금(이하 도금이라 한다.)에 대하여 규정한다.

Black chromium and nickel plating(electrodeposited)

YS/T 540.4-2006 钒化学分析方法 邻菲罗啉光度法测定铁量

Vanadium chemical analysis method o-phenanthroline spectrophotometric determination of iron content

YS/T 573-2006 钽粉

Tantalum powder

YS/T 516-2006 钨丝二次再结晶温度测量方法

Measuring method of secondary recrystallization temperature of tungsten wire

YS/T 547-2006 高纯五氧化二钽

High-purity tantalum pentoxide

YS/T 548-2006 高纯五氧化二铌

High-purity niobium pentoxide

YS/T 558-2006 钼的发射光谱分析方法

Molybdenum Emission Spectroscopy Analysis Method

YS/T 515-2006 钨丝下垂试验方法

Tungsten wire sagging test method

YS/T 557-2006 压电铌酸锂单晶体声波衰减测试方法

Test method for acoustic wave attenuation of piezoelectric lithium niobate single crystal

YB/T 5304-2006 五氧化二钒

Vanadium pentoxide

SJ 20964-2006 钨37铼合金规范

本规范规定了钨37铼合金（以下简称钨铼合金）的要求、质量保证规定、交货准备及有关规定。 本规范适用于制造军用真空电子器件中电子束或离子束溅射用钨铼合金棒材或条材。

Specification for tungsten-37 rhenium alloy

YS/T 579-2006 钒铝中间合金

本标准规定了钒铝中间合金的要求、试验方法、检验规则及标志、包装、运输、贮存等。 本标准适用于采用金属热还原法生产的、作为钛合金添加剂使用的钒铝合金。高温合金和其他特殊合金可参照使用。

Vandium-Aluminum master alloy

YS/T 578-2006 氟钽酸钾

本标准规定了氟钽酸钾的要求、试验方法、检验规则和标志、包装、运输、贮存及订货单内容等。 本标准适用于液-液萃取法制得的氟钽酸钾。产品只要用于制取金属钽粉。

Potassium fluorotantalate

ASTM B776-06 铪及铪合金带材、薄板和中厚板标准规范

1.1 This specification covers two grades of wrought hafnium and hafnium alloy strip, sheet, and plate as follows:1.1.1 Grade R1 for nuclear applications, and1.1.2 Grade R3 for commercial applications.1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Hafnium and Hafnium Alloy Strip, Sheet, and Plate

ASTM B658/B658M-06 无缝和焊接锆和锆合金管标准规范

1.1 This specification covers three grades of seamless and welded zirconium pipe.1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.The following precautionary caveat pertains only to the test methods portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Seamless and Welded Zirconium and Zirconium Alloy Pipe

KS D 2555-2005 钽中氮含量测定方法

이 규격은 탄탈럼의 질소 정량 방법에 대하여 규정한다.

Methods for determination of nitrogen in tantalum

KS D 2552-2005 钽中硅含量测定方法

이 규격은 탄탈럼의 규소 정량 방법에 대하여 규정한다.

Method for determination of silicon in tantalum

KS D 2560-2005 钽中氢含量测定方法

이 규격은 탄탈럼의 수소 정량 방법에 대하여 규정한다.

Determination of hydrogen in tantalum

KS D 2569-2005 钽ICP发射光谱的分析方法

이 규격은 탄탈럼의 ICP 방출 분광 분석 방법에 대하여 규정한다.

Methods for ICP emission spectrometric analysis of tantalum