K41 变压器 标准查询与下载

DL/T 1798-2018 换流变压器交接及预防性试验规程

Converter Transformer Handover and Preventive Test Regulations

DL/T 1799-2018 电力变压器直流偏磁耐受能力试验方法

Test method for DC bias withstand capability of power transformers

DL/T 1805-2018 电力变压器用有载分接开关选用导则

Guidelines for selection of on-load tap-changers for power transformers

DL/T 1814-2018 油浸式电力变压器工厂试验油中溶解气体分析判断导则

Guidelines for analysis and judgment of dissolved gas in oil-immersed power transformer factory test oil

DL/T 1813-2018 油浸式非晶合金铁心配电变压器选用导则

Guidelines for selection of oil-immersed amorphous alloy core distribution transformers

DL/T 363-2018 超、特高压电力变压器（电抗器）设备监造导则

Guidelines for Supervision of Ultra- and UHV Power Transformer (Reactor) Equipment

DL/T 1806-2018 油浸式电力变压器用绝缘纸板及绝缘件选用导则

Guidelines for selection of insulating cardboard and insulating parts for oil-immersed power transformers

DL/T 1810-2018 110（66）kV六氟化硫气体绝缘电力变压器使用技术条件

Technical conditions for use of 110 (66) kV sulfur hexafluoride gas-insulated power transformers

DL/T 1811-2018 电力变压器用天然酯绝缘油选用导则

Guidelines for selection of natural ester insulating oils for power transformers

DL/T 1095-2018 变压器油带电度现场测试方法

On-site test method for transformer oil electrification

DL/T 984-2018 油浸式变压器绝缘老化判断导则

Guidelines for judging insulation aging of oil-immersed transformers

DL/T 1807-2018 油浸式电力变压器、电抗器局部放电超声波检测与定位导则

Oil-immersed power transformer, reactor partial discharge ultrasonic detection and location guidelines

DL/T 1808-2018 干式空心电抗器匝间过电压现场试验导则

Guidelines for field test of inter-turn overvoltage of dry-type air-core reactor

DL/T 1093-2018 电力变压器绕组变形的电抗法检测判断导则

本标准规定了电力变压器绕组变形的电抗法（低电压）检测的时机、参数和方法，指出了判断的原理、方法和要。 本标准适用于容量2500kVA以上的电力变压器。 容量小于上述规定的电力变压器可参照执行。

Guide for reactance method to detect and diagnose windging deformation of power transformer

DL/T 1812-2018 低功耗电容式电压互感器选用导则

Guidelines for Selection of Low Power Consumption Capacitive Voltage Transformers

DL/T 1817-2018 变压器低压侧用绝缘铜管母使用技术条件

Technical conditions for the use of insulated copper tube mothers for the low-voltage side of transformers

BS IEC 60076-7:2018 电源变压器 矿物油浸式电力变压器加载指南

Power transformers. Loading guide for mineral-oil-immersed power transformers

ISO 18095:2018 电力变压器状态监测与诊断

This document gives guidelines for the monitoring techniques to be considered when setting up a condition monitoring programme for power transformers and includes references to associated standards required in this process. It is intended to help in the implementation of a coherent condition monitoring and condition-based maintenance programme, such as described following ISO 17359. This document is applicable to single-phase alternating current power transformers of ≥ 1 kVA and three phase alternating current power transformers of ≥ 5 kVA.

Condition monitoring and diagnostics of power transformers

IEC 60076-7:2018 电力变压器.第7部分:矿物油浸电力变压器加载指南

This part of IEC 60076 is applicable to mineral-oil-immersed transformers. It describes the effect of operation under various ambient temperatures and load conditions on transformer life. NOTE For furnace transformers, the manufacturer is consulted in view of the peculiar loading profile.

Power transformers - Part 7: Loading guide for mineral-oil-immersed power transformers

BS EN 50588-1:2017 设备最高电压不超过36kV的50Hz中等功率变压器.第1部分:通用要求

Medium power transformers 50 Hz, with highest voltage for equipment not exceeding 36 kV. General requirements