N22 电能测量和负荷控制系统 标准查询与下载

IEC 62056-3-1:2013 电表数据交换.DLMS/COSEM套件.第3-1部分:带载波信号传输双绞线上的局域网使用

This part of IEC 62056 describes three profiles for local bus data exchange with stations either energized or not. For non-energized stations@ the bus supplies energy for data exchange. Three different profiles are supported: ? base profile: this three-layer profile provides remote communication services; NOTE This first profile has been published in IEC 61142:1993 and became known as the Euridis standard. ? profile with DLMS: this profile allows using DLMS services as specified in IEC 61334-4-41; NOTE This second profile has been published in IEC 62056-31 Ed. 1.0:1999; ? profile with DLMS/COSEM: this profile allows using the DLMS/COSEM Application layer and the COSEM object model as specified in IEC 62056-5-3 Ed. 1.0:?? and in IEC 62056- 6-2 Ed. 1.0:?? respectively. The three profiles use the same physical layer and they are fully compatible@ meaning that devices implementing any of these profiles can be operated on the same bus. The transmission medium is twisted pair using carrier signalling and it is known as the Euridis Bus.

Electricity metering data exchange - The DLMS/COSEM suite - Part 3-1: Use of local area networks on twisted pair with carrier signalling

JJG 1085-2013 标准电能表检定规程

本规程适用于额定频率为50 Hz或60 Hz的电子式标准电能表的首次检定、后续检定和使用中检查。

Verification Regulation of Reference Meters for Electrical Energy

IEC 62056-8-3:2013 电量测量数据交换.DLMS/COSEM套件.第8-3部分:社区网络PLC S-FSK通讯配置文件

This part of IEC 62056 specifies the DLMS/COSEM PLC S-SFK communication profile for neighbourhood networks. It uses standards established by IEC TC 57 in the IEC 61334 series,Distribution automation using distribution line carrier systems and it specifies extensions to some of those standards

Electricity metering data exchange.The DLMS/COSEM suite.Part 8-3: PLC S-FSK communication profile for neighbourhood networks

IEC 62056-6-2:2013 电量测量数据交换.DLMS/COSEM套件.第6-2部分:COSEM接口类

This part of IEC 62056 specifies a model of a meter as it is seen through its communication interface(s). Generic building blocks are defined using object-oriented methods, in the form of interface classes to model meters from simple up to very complex functionality.

Electricity metering data exchange.The DLMS/COSEM suite.Part 6-2: COSEM Interface classes

IEC 62056-7-6:2013 电量测量数据交换.DLMS/COSEM套件.第7-6部分:3层面向连接的HDLC基础通讯配置文件

This part of IEC 62056 specifies the DLMS/COSEM 3-layer,connection-oriented HDLC based communication profile.

Electricity metering data exchange.The DLMS/COSEM suite.Part 7-6: The 3-layer, connection-oriented HDLC based communication profile

IEC 62056-6-1:2013 电量测量数据交换.DLMS/COSEM套件.第6-1部分:目标识别系统(OBIS)

This part of IEC 62056 specifies the overall structure of the OBject Identification System (OBIS) and the mapping of all commonly used data items in metering equipment to their identification codes.

Electricity metering data exchange.The DLMS/COSEM suite.Part 6-1: Object identification system (OBIS)

DL/T 698.42-2013 电能信息采集与管理系统 第4-2部分：通信协议－集中器下行通信

本部分规定了电能信息采集与管理系统中集中器与本地通信模块接口间进行数据传输的帧格式、数据编码及传输规则。本部分适用于采用低压电力线载波、微功率无线通信、以太网传输通道的本地通信组网方式,适用于集中器与本地通信模块间数据交换。

Data acquisition and management system for electrical energy.Part 4-2: communication protocol-concentrator downward communication

DL/T 698.36-2013 电能信息采集与管理系统 第3-6部分：电能信息采集终端技术规范-通信单元要求

本部分规定了电能信息采集与管理系统中采集终端通信单元的技术要求和试验方法,包括结构、工作环境、基本传输特性、电气安全以及电磁兼容性等技术要求和试验方法。安装在电能信息采集终端中的通信单元同时应符合相应采集终端的技术规范要求。本部分适用于电能信息采集与管理系统中的独立通信单元以及安装在采集终端和电能表中的通信单元的制造、检验、使用和验收。

Data acquisition and management system for electrical energy.part 3-6: technical specification of electrical energy data acquisition terminal-communication unit requirement

IEC 61083-2:2013 高压和高电流冲击试验中测量用仪器和软件.第2部分:电压和电流冲击试验用软件的要求

This part of IEC 61083 is applicable to software used for evaluation of impulse parameters from recorded impulse voltages and currents. It provides test waveforms and reference values for the software required to meet the measuring uncertainties and procedures specified in IEC 60060-1@ IEC 60060-2@ IEC 60060-3 and IEC 62475. Hardware with built-in firmware that cannot accept external numerical input data is not covered by this standard. The object of this standard is to ? establish the tests which are necessary to show that the performance of the software complies with the requirements of the relevant IEC standards; ? define the terms specifically related to digital processing; ? specify reference values and the acceptance limits for the reference impulses; ? specify the requirements for the record of performance; ? define the methods to assess the contribution of software to the measurement uncertainty.

Instruments and software used for measurement in high-voltage and high-current tests - Part 2: Requirements for software for tests with impulse voltages and currents

IEEE Std C37.242-2013 电力系统保护和控制用相量测量单元(PMU)的同步化、校准、测试和安装用IEEE指南

IEEE Guide for Synchronization, Calibration, Testing, and Installation of Phasor Measurement Units (PMUs) for Power System Protection and Control

IEEE Std C37.244-2013 电力系统保护、控制和监测的相量数据集中器的要求用IEEE指南

IEEE Guide for Phasor Data Concentrator Requirements for Power System Protection, Control, and Monitoring

JJG 596-2012 电子式交流电能表

本规程适用于参比频率为50Hz或60Hz单相、三相电子式(静止式)交流电能表(简称电子式电能表或电能表)的首次检定、后续检定。 对于具有其他功能的电子式电能表,其相同的检定项目执行本规程。 本规程不适用于机电式(感应系)交流电能表、标准电能表、数字电能表(被测电压、电流为数字量的电能表)的检定及电能表的现场检验。

Electrical Meters for Measuring Alternating-current Eletrical Energy

BS EN 62059-32-1:2012 电力计量设备.可靠性.耐久性.通过提高温度测试计量特性的稳定性

Electricity metering equipment. Dependability. Durability. Testing of the stability of metrological characteristics by applying elevated temperature

DIN 43863-5:2012 所有制造商使用的测量仪器的识别号

Identification number for measuring devices applying for all manufacturers

DL/T 280-2012 电力系统同步相量测量装置通用技术条件

本标准规定了电力系统同步相量测量装置的技术要求及对标志、包装、运输、贮存的要求。 本标准适用于电力系统同步相量测量装置，作为产品设计、制造、试验和应用的依据。

General specifications for synchrophasors measurement unit for power system

JIS C 1273-1:2011 电抗能用交流静态测量仪表.第1部分:一般测量仪表

Alternating-current static meters for reactive energy -- Part 1: General measuring instrument

JIS C 1272-1:2011 有源能量用交流静态测量仪表.0.2 S和0.5 S级.第1部分:一般测量仪表

Alternating-current static meters for active energy -- Classes 0.2 S and 0.5 S -- Part 1: General measuring instrument

JIS C 1271-1:2011 有源能量用交流静态测量仪表.1和2级.第1部分:一般测量仪表

Alternating-current static meters for active energy -- Classes 1 and 2 -- Part 1: General measuring instrument

JJF 1283-2011 剩余电流动作保护器动作特性检测仪校准规范

本规范适用于剩余电流动作保护器动作特性检测仪（以下简称RCD检测仪）的校准。

Calibration Specification for Residual Current Operated Protective Device Operated Characteristic Tester

DIN EN 62058-21:2011 电能测量设备(交流).验收检查.第21部分:机电式有功电能表的特殊要求(0.5,1和2级及指数A和B级)(IEC 62058-21-2008, 修订版);德文版本EN 62058-21-2010

Electricity metering equipment (a.c.) - Acceptance inspection - Part 21: Particular requirements for electromechanical meters for active energy (classes 0,5, 1 and 2 and class indexes A and B) (IEC 62058-21:2008, modified); German version EN 62058-21:2010