P53 园林绿化与市容卫生 标准查询与下载

CJ/T 12-1999 城市容貌标准

本标准适用于全国设市城市，县镇可参照执行。各地可根据本标准结合具体情况制订实施细则。

City Appearance Standards

CJJ/T 82-1999 城市绿化工程施工及验收规范

Code for construction and acceptance of planting engineering in city and town

ASTM D6454-99(2011) 检测增强型草皮(TRMs)短期耐压特性的标准试验方法

The compression behavior test for TRMs is intended to be an index test. It is anticipated that the results of the compression behavior test will be used to evaluate product. The results of the analyses also may be used to compare the relative compressive yield points of materials that exhibit a detectable compressive yield point. It is anticipated that this test will be used for quality control testing to evaluate uniformity and consistency within a lot or between lots where sample geometry factors, for example, thickness, or materials may have changed. Note 18212;This is a one-dimensional test for compressive loading of a TRM in one plane. The compressive yield point of TRMs may be evaluated from the stress/strain relationship. Many materials exhibit compressive deformation but may not show a distinct compressive yield point. This test method can be used to evaluate the short-term stress/strain behavior of TRMs under compressive stress while loaded at a constant rate of deformation. This test method may be used for acceptance testing of commercial shipments of TRMs but caution is advised because interlaboratory testing is incomplete. In the case of a dispute arising from differences in reported test results when using this test method for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is statistically bias between their laboratories. Competent statistical assistance is recommended for the investigations of bias. As a minimum, two parties should take a group of test specimens from material shipped to project. The test specimens then should be assigned randomly in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using the Student''s t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If bias is found, either its cause must be found and corrected, or the purchaser and supplier must agree to interpret future test results in the light of the known bias.1.1 The test method establishes the procedures for evaluation of the deformations of a turf reinforcement mat (TRM) under short-term compressive loading. This test method is strictly an index test method to be used to verify the compressive strength consistency of a given manufactured geosynthetic. Results from this test method should not be considered as an indication of actual or long-term performance of the TRM in field applications. 1.2 Since these TRMs experience multidirectional compressive loadings in the field, this test method will not show actual field performance and should not be used for this specific objective. The evaluation of the results also should recognize that the determination of the short term single plane compressive behavior of geosynthetics does not reflect the installed performance of TRMs and, therefore, should not be used as the only method of product or performance specification. 1.3 The values in SI units are to be regarded as the standard. The values stated in inch-pound units are provided in parentheses for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Determining the Short-Term Compression Behavior of Turf Reinforcement Mats (TRMs)

BS 3969:1998 通用草皮推荐规范

Characteristics and handling of various types of turf for use in different situations.

Recommendations for turf for general purposes

DB61/T 249-1997 日光温室建造与配套设备标准

本标准适用于日光温室设计、建造与规划布局

Solar greenhouse construction and supporting equipment standards

CJJ 75-1997 城市道路绿化规划与设计规范

Code for planting planning and design on urban roads

CJJ 67-1995 风景园林图例图示标准

Standard for graphics of landscape architecture

ASTM F355-95 运动表面系统和材料减震性能的标准试验方法

1.1 This test method covers the measurement of certain shock-absorbing characteristics, the impact force-time relationships, and the rebound properties of playing surface systems. This test method is applicable to natural and artificial playing surface systems and to components thereof. Typical playing surfaces are wrestling mats, football fields, soccer fields, playgrounds, and so forth.Note 18212;This test method may also be used to measure the shock-attenuation properties of materials used as protective padding, such as the padding on trampoline frames, football goal posts, gymnasium wall, shoulder pads, body padding, and so forth. It should not be used, without some modifications, to test the finished products.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Shock-Absorbing Properties of Playing Surface Systems and Materials

BS 7370-2:1994 地面保养.坚硬区域保养推荐方法(不包括运动场地面)

Provides recommendations and a checklist for the inspection, maintenance and minor repair of hard areas, including reinstatement after disturbance.

Grounds maintenance - Recommendations for the maintenance of hard areas (excluding sports surfaces)

ASTM F1551-94 合成草地使用表面和材料综合特性的标准试验方法

1.1 These test methods establish a recommended list of test methods to be used for the identification of physical property characteristics and comparison of the performance properties of synthetic turf systems or components for athletic and recreational uses, or both. 1.2 The test procedures included in these test methods apply as a group to the description of synthetic turf playing surfaces. 1.3 Some of the test procedures are specific for components of the synthetic turf system, and others apply to the complete synthetic turf playing surface. 1.4 Some of the test procedures are suitable only for the laboratory characterization of either components or the complete system; others are suitable for tests on installed sports fields; and some tests may be applied in both the laboratory and the field. 1.5 Reference to the methods for testing the synthetic turf playing surface and its components contained herein should state specifically the particular test or tests desired and not necessarily refer to these test methods as a whole. 1.6 This is a physical property characterization standard, and it shall not be construed as a safety standard. 1.7 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Comprehensive Characterization of Synthetic Turf Playing Surfaces and Materials

BS 7370-4:1993 地面保养.柔和景观保养推荐标准(舒适型草地除外)

Describes categories recommending, where possible, maintenance objectives for each category.

Grounds maintenance - Recommendations for maintenance of soft landscape (other than amenity turf)

CJJ/T 52-1993 城市生活垃圾好氧静态堆肥处理技术规程

Technical specification for static aerobic composting of municipal solid waste

NF P99-650:1991 城市环境与清洁设施.城市公共设施整洁和环境的维护.维护的连续性和管理

Street and cleanness furniture. Maintenance of street and cleanness furniture. How to make and control the maintenance.

BS 7370-3:1991 地面保养.舒适型和功能型草地(运动场草地除外)保养推荐标准

Categories of turf (other than sports turf), recommending maintenance objectives.

Grounds maintenance - Recommendations for maintenance of amenity and functional turf (other than sports turf)

BS 7370-1:1991 地面保养.地面保养组织的建立和管理以及与保养有关的设计考虑的推荐规范

Gives guidance on landscape planning.

Grounds maintenance. Recommendations for establishing and managing grounds maintenance organizations and for design considerations related to maintenance

BS 4428:1989 一般园林经营管理的实用规程(不包括硬质地面)

Preliminary investigations, drainage, grading and cultivation, seeding of grass areas, turfing, tree planting, woodland planting, planting of shrubs, herbaceous plants and bulbs.

Code of practice for general landscape operations (excluding hard surfaces)

CJJ 20-1989 城市园林工人技术等级标准

Technical level standard for workers of urban gardens

CJJ 21-1989 古建筑修建工人技术等级标准

Technical level standard for ancient building constructors

CJJ 25-1989 环卫工人技术等级标准

Technical level standard for workers of environmental sanitation

CJJ 48-1992 公园设计规范

Code for design of parks