S35 牵引电气设备 标准查询与下载

TB/T 3061-2008 机车车辆用阀控密封式铅酸蓄电池

本标准规定了内燃机车、电力机车、铁道客车用闸控密封式铅酸蓄电池（以下简称蓄电池）的产品型号及基本参数、技术要求、试验方法、检验规则及标志、包装、运输、贮存。 本标准适用于内燃机车、电力机车、铁道客车照明、应急电源及辅助用电设备所使用的蓄电池。其他类型阀控式蓄电池也可参照采用。

Valve-regulated lead-acid batteries for locomotive and rolling stock

TB/T 3197-2008 车载控制自动过分相系统技术条件

本标准规定了车载控制自动过分相系统的使用环境条件、安装要求、技术要求、试验方法和标志、包装、运输及存储要求。 本标准适用于由交流接触网供电的电力机车、电动车组。 本标准不适用于地铁、城轨车辆以及其他由直流接触网供电的机车车辆。

Specification of automatic on-board control netural-section passing system

BS DD CLC/TS 50467:2008 轨道交通.全部车辆.电连接器的要求和试验方法

Railway applications - Rolling stock - Electrical connectors, requirements and test methods

BS EN 50152-1:2007 轨道交通.固定装置.交流开关装置的特殊要求.电压大于1KV的单相电路断路器

This EN 50152-1 is applicable to single-phase a.c. one-pole circuit-breakers designed for indoor or outdoor fixed installations for operation at frequencies of 16,7 Hz and 50 Hz on traction systems having an UNm above 1 kV up to 52 kV. This EN 50152-1 is also applicable to two-pole circuit-breakers when connected in the following manner: one pole supplying the connection to the contact line of the track, the second pole supplying the connection to the feeder cable which runs alongside the same track and which is used to boost the track voltage at regular intervals in combination with autotransformers. The centre of this circuit is connected to earth. This European Standard is also applicable to the operating devices of circuit-breakers and to their auxiliary equipment. This European Standard does not address circuit-breakers with dependent manual operating mechanism. NOTE A rated short-circuit making current cannot be specified for these circuit-breakers and the use of these mechanisms may give reasons for the objection based on their safety in operation.

Railway applications — Fixed installations — Particular requirements for a.c. switchgear — Part 1: Single-phase circuit-breakers with Un above 1 kV

BS EN 50152-2:2007 轨道交通.固定装置.交流开关装置的特殊要求.接地开关及高于1kV开关的单相断路器

This EN 50152-2 is applicable to single-phase a.c. one-pole disconnectors, earthing switches and switches (switch-disconnectors and general purpose switches) designed for indoor or outdoor fixed installations for operation at frequencies of 16,7 Hz and 50 Hz on traction systems having an UNm above 1 kV up to 52 kV. This EN 50152-2 is also applicable to two-pole disconnectors, earthing switches and switches (switchdisconnectors and general purpose switches) connected in the following manner either: a) one pole supplying the connection to the contact line of the track, the other supplying the connection to the feeder cable which runs alongside the same track and is used to boost the track voltage at regular intervals in combination with autotransformers; or b) the two poles of the disconnector, earthing switch or switch (switch-disconnector or general purpose switch) are connected in series to provide secure isolation (i.e. two breaks in series).

Railway applications - Fixed installations - Particular requirements for a.c. switchgear - Single-phase disconnectors, earthing switches and switches with Un above 1 kV

JIS E 5008 ERRATUM 1:2008 勘误表

ERRATUM

NF F42-152-1:2008 轨道交通.固定装置.交流开关装置的特殊要求.第1部分:电压大于1kV的单相断路器

Railway applications - Fixed installations - Particular requirements for a.c. switchgear - Part 1 : single-phase circuit-breakers with Un above 1 kV.

NF F42-152-2:2008 轨道交通.固定装置.交流开关装置的特殊要求.第2部分:带电压大于1KV的接地开关和开关的单相断路器

Railway applications - Fixed installations - Particular requirements for a.c. switchgear - Part 2 : single-phase disconnectors, earthing switches and switches with Un above 1 kV.

DIN EN 50122-1 Berichtigung 1:2007 轨道交通.固定设备.第1部分:电气安全和接地相关的保护性措施

Railway applications - Fixed installations - Part 1: Protective provisions relating to electrical safety and earthing; German version EN 50122-1:1997 Corrigenda to DIN EN 50122-1 (VDE 0115-3):1997-12; German version CENELEC-Cor. :2007 to EN 50122-1:1997

IEC 62427:2007 轨道交通.全部车辆和火车探测系统间的兼容性

This International Standard describes a procedure for mutual acceptance of rolling stock to run over specific routes．It describes the methods of measurement of interference currents， the methods of measurement of the susceptibility of train detection systems，the characterisation of traction power supplies and the procedure for acceptance．The result of the acceptance procedure is a structured justification document referred to as a“compatibility case”，which documents the evidence that the conditions for compatibility have been satisfied The procedure is also applied to modifications of rolling stock，traction power supply or train detection systems which are considered to affect compatibility． The scope of the compatibility case is restricted to the demonstration of compatibility of rolling stock with a train detection system’s characterisation(e．g．gabarit)．Train detection system in this standard refers only to a track circuit or those using wheel detector．

Railway applications - Compatibility between rolling stock and train detection systems

TB/T 3153-2007 轨道交通.机车车辆布线规则

本标准规定了铁道机车车辆（包括磁悬浮列车与无轨电车）以及安装在铁道机车车辆上的电气柜（箱）内部的电缆布线要求。 本标准适用于在铁道机车车辆电气设备间及其电气柜（箱）内部完成各项产品（包括电缆、汇流排、端子与插头、插座）电气连接所进行的布线。 本标准规定的材料选取标准适用于含铜导体的电缆，但不适用于特定用途的导体，如光缆或空心导体（波导管）。 本标准适用于： ——专用的机车车辆，如铺轨机、道碴清筛机和职工运输车； ——用于采矿的机车车辆； ——有轨电车； ——缆车。 由于机车车辆的布线也涉及到电缆的制造标准，所以应参考TB/T 1484、GB 12528.11、EN 50264、EN 50306与EN 50355等标准。 本标准应结合相关的产品与安装标准使用。也可以规定比本标准更严格的要求。 城轨车辆、地铁车辆可参照本标准。

Railway application Rolling stock Rules for installation of cabling

NF F07-405:2007 轨道交通.集流系统.碳滑板牵引试验方法

Railway applications - Current collection systems - Pantographs, testing methods for carbon contact strips.

DIN EN 61377-1:2006 轨道交通.机车车辆.逆向供电交流电动机及其控制的联合检验

Railway applications - Rolling stock - Part 1: Combined testing of inverter-fed alternating current motors and their control system (IEC 61377-1:2006); German version EN 61377-1:2006

IEC 60571:2006 用于有轨机动车上的电子设备

This International Standard applies to all electronic equipment for control, regulation, protection, supply, etc. installed on rail vehicles and associated with – either the accumulator battery of the vehicle; – or a low-voltage power supply source with or without a direct connection to the contact system (transformer, potentiometer device, auxiliary supply) with the exception of electronic power circuits, which conform to IEC 61287-1. This standard covers the conditions of operation, design, construction, and testing of electronic equipment, as well as basic hardware and software requirements considered necessary for competent, reliable equipment. Additional requirements in other standards or individual specifications may complement this standard, if they are justified. Specific requirements related to practices necessary to assure defined levels of functional safety are to be determined in accordance with 4.6.3.1 and 4.6.3.2 of IEC 62278 and its informative Annex A. Software safety integrity level of 1 or higher shall only be considered when it is shown that a residual safety risk remains and that it has to be carried by the software driven programmable electronic system. In such a case (i.e. software safety integrity level 1 or higher), IEC 62279 is applicable. For the purposes of this standard, electronic equipment is defined as equipment mainly composed of semiconductor devices and recognized associated components. These components will mainly be mounted on printed boards. NOTE Sensors (current, voltage, speed, etc.) and firing unit printed board assemblies for power electronic devices are covered by this standard. Complete firing units are covered by IEC 61287-1.

Electronic equipment used on rail vehicles

BS EN 50405:2006 轨道交通.集流系统.碳滑板用导电弓架试验方法

This European Standard gives rules for testing methods for carbon contact strips. The purpose of this standard is to demonstrate that the carbon strip construction is fit for purpose. Not all tests may be relevant to some designs.

Railway applications - Current collection systems - Pantographs, testing methods for carbon contact strips

TB/T 3141-2006 机车空调电源

本标准规定了电力机车和内燃机车用空调电源的技术要求、试验方法及验收规则等。 本标准适用于电力机车和内燃机车上的机车空调电源。

Air-conditioning power supply of locomotive

TB/T 3077.1-2006 电力机车车顶绝缘子 第1部分:瓷绝缘子

本部分规定了单相工频（50Hz）交流标称电压25kV电力机车或电动车组车顶受电弓和母线（导电杆）支持用支柱瓷绝缘子（以下简称绝缘子）的使用范围、分类与标记、技术要求、抽样、试验、验收和包装等。 本部分适用于电力机车和电动车组车顶受电弓和母线（导电杆）支持用绝缘子。 其他形式的车顶瓷绝缘子可参照本部分使用。

Post insulators on the roof of electric locomotives. Part 1: Ceramic insulators

TB/T 1680-2006 轨道交通.机车车辆牵引变压器和电抗器

本标准适用于机车车辆上安装的牵引变压器，也适用于电传动机车车辆上主电路和辅助电路中接入的各种类型的电抗器。 经过用户和制造商协商，本标准也适用于电动车组的三相交流网侧牵引变压器和机车车辆的单相与多相辅助电路中接入的变压器，但仪用互感器和额定输出功率单相小于1kV·A和多相小于5kV·A的变压器除外。 本标准不适用于安装在变压器或电抗器上的附属设备，如分接开关、电阻器、散热器、风机等，它们应分别依照相关标准进行试验。 当分接开关为完整变压器的一部分时，变压器试验时不能将其分开。 使用条件见TB/T 1333.1-2002第7章。

Railway application-Traction transformer and inductors on board rolling stock

TB/T 3077.2-2006 电力机车车顶绝缘子 第2部分:复合绝缘子

本部分规定了单相工频（50Hz）交流标称电压25kV电力机车或电动车组车顶受电弓和母线（导电杆）支持用硅橡胶复合支柱绝缘子（以下简称绝缘子）的使用范围、分类与标记、技术要求、抽样、试验、验收和包装等。 本部分适用于电力机车和电动车组车顶受电弓和母线（导电杆）支持用绝缘子。 其他形式的车顶复合绝缘子可参照本部分使用。

Post insulators on the roof of electric locomotives. Part 2: Composite insulators

TB/T 2436-2006 电力牵引 铁路机车车辆和公路车辆用除电子变流器供电的交流电动机之外的旋转电机

1.1 本标准规定了电力传动的铁路机车车辆和公路车辆（以下简称机车车辆）上，除电子变流器供电的交流电动机之外的旋转电机。这些机车车辆可从外部电源或内部电源获得动力。 本标准的目的是通过试验确认电机的性能，并为评定电机对某一规定负载的适应性以及与其他电机进行比较提供依据。 本标准也适用安装在由电力传动机车车辆牵引的拖车上的电机。 本标准的基本要求可以用于特殊用途的机车车辆（如矿山机车）上的旋转电机，但不包括防爆或可能要求的其他特殊性能。 本标准不适用于小型路面车辆（如蓄电池供电的搬运车、工厂运货车等）上的电机，也不适用于微型电机，如在各种机车车辆上所用的前窗刮雨器电动机等。 符合GB 755-2000的工业型电机可用于某些辅助用途。

Electric traction. Rotating electrical machines for rail and road vehicles. Part 1: Machines other than electronic convertor-fed Alternating current motors