Y30 造纸综合 标准查询与下载

ISO 287:2017 纸和纸板.成批纸和纸板中水分含量的方法.烘干法

This document specifies an oven-drying method for the determination of the moisture content of a lot of paper and board. The procedure in Clause 8, describing how the test pieces are drawn from the lot, is performed at the time of sampling. This document is applicable to every type of lot of paper and board, including corrugated board and solid board, provided that the paper or board does not contain any substances, other than water, that are volatile at the temperature specified in this document. NOTE For determination of the dry matter content of a sample of paper or board, e.g. for calculation of the dry mass of the sample, ISO 638[1] can be used.

Paper and board - Determination of moisture content of a lot - Oven-drying method

BS ISO 8791-3:2017 纸和纸板.粗糙度/平滑度的测定(漏气法).谢菲尔德方法

Paper and board. Determination of roughness/smoothness (air leak methods). Sheffield method

DIN 6730:2017 纸、纸板和纸浆.词汇

This standard defines terms that are closely related to the materials of paper, board and pulp. It applies to the entire work area "paper, board and pulp" and promotes the uniform use of terminology in business and trade.

Paper, board and pulps - Vocabulary

DB44/T 2040-2017 纸和纸板 乙二醛含量的测定 高效液相色谱法

本标准规定了采用高效液相色谱测定纸和纸板中乙二醛含量的方法。 本标准适用于纸和纸板中乙二醛的测定，乙二醛的检出限为1.0 mg/kg。

Determination of glyoxal content in paper and paperboard by high performance liquid chromatography

BS ISO 11480:2017 纸浆、纸和纸板.全氯和有机氯的测定

Pulp, paper and board. Determination of total chlorine and organically bound chlorine

BS ISO 9416:2017 纸.光散射和吸收系数的测定(运用库贝尔卡-蒙克(Kubelka-Munk)理论)

Paper. Determination of light scattering and absorption coefficients (using Kubelka-Munk theory)

BS ISO 11093-8:2017 纸和纸板.芯层试验.通过试验模型分析法对自然频率和弯曲模量的测定

Paper and board. Testing of cores. Determination of natural frequency and flexural modulus by experimental modal analysis

BS ISO 11475:2017 纸和纸板 CIE 白度测定 D65/10$0D（室外日光）

Paper and board. Determination of CIE whiteness, D65/10$0D (outdoor daylight)

ISO 11093-8:2017 纸和纸板.纸芯的检测.第8部分:试验模型分析法测定自然频率和弯曲模量

This document specifies a method for the determination of the flexural modulus by using experimentally measured natural frequencies in the free-free mode of transverse vibration of cylindrical paper and board cores, which meet the following criteria: —   internal diameter: 50 mm to 350 mm; —   minimum length of core: 8 × internal diameter. —   minimum wall thickness: NOTE 0,02 × internal diameter or not less than 2,0 mm; For the determination of the flexural modulus by the three-point method, see ISO 11093-7.

Paper and board - Testing of cores - Part 8: Determination of natural frequency and flexural modulus by experimental modal analysis

ISO 9416:2017 纸.光散射和吸光系数的测定(使用库贝尔卡-蒙克理论)

This document specifies a method for the calculation of light-scattering and light-absorption coefficients based upon diffuse reflectance measurements made under the conditions specified in ISO 2469 using the colour matching function ȳ(λ) and CIE illuminant C. It is emphasized that the strict evaluation of the light-scattering and light-absorption coefficients requires conditions which cannot be achieved with the instrumentation specified here. The values obtained by application of this document are dependent on the application of the Kubelka-Munk equations, not to full reflectance data but to reflectance factor data obtained using the specified d/0° geometry and a gloss trap. The use of the method is restricted to white and near-white uncoated papers with an opacity less than about 95 %. Paper that has been treated with a fluorescent dyestuff or that exhibits significant fluorescence can only be dealt with if a filter with a cut-off wavelength of 420 nm is used to eliminate all the fluorescence effect in the UVex(420) mode. NOTE 1 The residual UV-level in the instrument may depend on whether the instrument is adjusted to UV(C) or UV(D65) conditions prior to switching to the UVex(420) mode, but it is considered that this uncertainty in the residual level can be ignored in the application of this document. NOTE 2 Although this method is restricted to paper, it can be applied to pulp sheets, although this is not in accordance with this document. In general, when pulps are tested, the light-absorption coefficient at 457 nm corresponding to the ISO brightness value or the spectral absorption coefficients are of greater interest than the weighted value standardized in this document.

Paper - Determination of light scattering and absorption coefficients (using Kubelka-Munk theory)

DIN ISO 11093-4:2017 纸和纸板..卷轴芯的试验.第4部分:尺寸测量(ISO 11093-4-2016)

Paper and board - Testing of cores - Part 4: Measurement of dimensions (ISO 11093-4:2016)

ISO 11475:2017 纸和纸板.D65/10° CIE白度测定(室外日光)

This document specifies the procedure to be used for determining the whiteness of papers and boards. The values obtained correspond to the visual appearance of white papers and boards with or without fluorescent whitening agents when they are viewed under the CIE D65 daylight standard illuminant. It is based on reflectance data obtained over the full visible spectral range (VIS) in contrast to the measurement of ISO brightness which is limited to the blue region of VIS. In addition, it specifies a method for adjustment of the UV content to correspond to the CIE D65 daylight illuminant[10][11], insofar as results obtained when fluorescent whitening agents are present are dependent upon the UV content of the radiation falling upon the sample. It is specific for white fluorescent paper samples where the emission due to the fluorescent whitening agent (FWA) occurs in the blue region of the visible spectrum. This method is not applicable to coloured papers containing fluorescent dyes. This document should be read in conjunction with ISO 2469. NOTE 1 This document is based on the CIE whiteness formula, published in CIE 15.3-2004[9]. NOTE 2 A related International Standard, ISO 11476, specifying the procedure for obtaining values corresponding to the appearance of these products under indoor illumination, has also been published.

Paper and board - Determination of CIE whiteness, D65/10 degrees (outdoor daylight)

ISO 11480:2017 纸浆、纸和纸板.总氯和有机氯的测定

This document specifies two alternative procedures for the determination of total and organically bound chlorine in pulp, paper and board. It is applicable to all types of pulp, paper and board. The lower limit of the determination is about 20 mg/kg.

Pulp, paper and board - Determination of total chlorine and organically bound chlorine

DIN ISO 11093-5:2017 纸和纸板.卷轴芯试验.第5部分:同心旋转特性测定(ISO 11093-5-2016)

Paper and board - Testing of cores - Part 5: Determination of characteristics of concentric rotation (ISO 11093-5:2016)

QB/T 5044-2017 涂布美术印刷纸(铜版纸)单位产品能源消耗限额

本标准规定了涂布美术印刷纸(铜版纸)(以下简称铜版纸)主要生产系统单位产品能源消耗限额的技术要求、统计范围、计算方法和节能管理与措施。 本标准适用于铜版纸主要生产系统单位产品能源消耗的计算、考核，以及对新建及改扩建企业(装置)的能耗控制。

Norm of energy consumption per unit product of coated art paper

QB/T 5043-2017 新闻纸单位产品能源消耗限额

Newsprint energy consumption limit per unit product

JIS P 8125-2:2017 纸和纸板. 抗弯性的测定. 第2部分: 泰伯试验机

Paper and board -- Determination of bending resistance -- Part 2: Taber-type tester

JIS P 8125-1:2017 纸和纸板. 抗弯性的测定. 第1部分: 恒定弯曲率

Paper and board -- Determination of bending resistance -- Part 1: Constant rate of deflection

DIN ISO 5630-7:2017 纸和纸板.加速老化.第7部分:曝光(ISO 5630-7-2014)

Paper and board - Accelerated ageing - Part 7: Exposure to light (ISO 5630-7:2014)

DIN ISO 5630-6:2017 纸和纸板.加速老化.第6部分:暴露于空气污染的条件下(二氧化氮)(ISO 5630-6-2009)

Paper and board - Accelerated ageing - Part 6: Exposure to atmospheric pollution (nitrogen dioxide) (ISO 5630-6:2009)