Y43 牙膏、肥皂、洗涤剂 标准查询与下载

QB 2966-2008 功效型牙膏

本标准规定了功效型牙膏的分类、要求、试验方法、检验规则和标志。 本标准适用于在牙膏中通过添加功效成分，使牙膏具有辅助预防、防止和减轻口腔问题的功能或对牙齿状况具有一定的改善作用，并且宣传其功效的、在包装盒上标注其功效作用的牙膏产品。执行本标准的牙膏首先必须符合GB 8372的要求。

Functional toothpastes

QB/T 2953-2008 洗涤剂用荧光增白剂

本标准规定了洗涤剂用荧光增白剂的分类、技术要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于生产各种衣料用洗涤剂时所添加的荧光增白剂。

Fluorescent whitening agents for detergents

QB/T 2950-2008 醇（酚）醚羧酸（盐）

本标准规定了醇（酚）醚羧酸（盐）产品的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于由烷基醇醚、烷基酚醚经羧甲基化生产的醇（酚）醚羧酸（盐）的工业产品。

Alkylpolyethoxy carboxylate

QB/T 2387-2008 洗衣皂粉

本标准规定了洗衣皂粉的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于以天然油脂加工的活性物及其他表面活性剂和助剂、分散剂、酶制剂、添加剂等配制生产的洗衣皂粉。

Laundry soap powder

SANS 1923:2008 去毛剂

Specifies the requirements for three types of scouring compounds used for the removal of tenacious soil from hard surfaces

Scouring compounds

SANS 237:2008 盥洗皂

Specifies requirements for toilet soap for personal hygiene but not speciality soaps such as transparent soap, medicated soap and seawater soap.

Toilet soap

SANS 235:2008 普通纯皂

Specifies requirements for soap for general cleaning, for dish washing and laundry use, and for personal hygiene.

General purpose pure soap

QB/T 2945-2008 口腔清洁护理液

本标准规定了口腔清洁护理液的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于口腔内应用的漱口水及口腔喷雾剂等各类口腔清洁护理用液体产品。

Oral rinses

QB/T 2932-2008 牙粉

本标准规定了牙粉的要求、试验方法、检验规则和标志、包装、贮存、保质期。 本标准适用于口腔内应用的牙粉。

Dentifrice

SANS 490:2008 消毒用酒精洁手液

Covers requirements for two types of disinfectant alcohol-based handrub.

Disinfectant alcohol-based handrub

ASTM E2613-08 利用成人试验液体卫生洗手剂的去除病毒有效性的标准试验方法

This in vivo procedure is designed to test the ability of hygienic handwash or handrub agents to eliminate fungal contamination from experimentally-contaminated hands. Since the two thumbpads and all eight fingerpads can be used in any given test, it allows for the incorporation of an input control (two), control for viable cells of the test fungus remaining after the inoculum has been allowed to dry (two), fungal cells eliminated after treatment with a control or reference solution (two), and up to four replicates to assess the fungus-eliminating efficiency of the formulation under test. No more than 100 µL of the test fungal suspension is required to complete one test. Whereas this test method is designed to work with fungi, similar ASTM standards exist for testing against viruses (Test Method E 1838) and vegetative bacteria (Test Method E 2276). Infectious microorganisms left on hands after washing can be reduced further by drying the washed hands with paper, cloth, or warm air (5). A step for the drying of fingerpads after exposure to the control or test solution, therefore, has not been included to avoid fungal removal by the drying process itself. This test method is not meant for testing surgical hand scrubs or preoperative skin preps. The level of contamination with viable fungi on each fingerpad after the drying of the inoculum should be at least 104 CFU so that it would permit the detection of up to a 4-log10 reduction in the viability titer of the test organism by a test formulation under the conditions of this test. This in itself does not represent the product performance criterion, which may vary depending on the jurisdiction and the nature of the formulation being evaluated. 1.1 This test method is designed to assess the ability of hygienic handwash and handrub agents to reduce levels of fungal contamination on hands (3). This test method is not meant for use with surgical hand scrubs (Test Method E 1115) or preoperative skin preps (Test Method E 1173). 1.2 Performance of this procedure requires the knowledge of regulations pertaining to human experimentation. 1.3 The test method should be performed by persons with training in microbiology in facilities designed and equipped for work with infectious agents at biosafety level 2 (4). 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Determining Fungus-Eliminating Effectiveness of Hygienic Handwash and Handrub Agents Using Fingerpads of Adults

QB/T 2901-2007 牙膏用铝塑复合软管

本标准规定了铝塑复合软管的要求、试验方法、检验规则和标志、包装、运输、贮存。 本标准适用于牙膏包装用的铝塑复合软管。

Aluminium and plastic laminated tubing for toothpaste

QB/T 2900-2007 牙膏用十二烷基硫酸钠

本标准规定了十二烷基硫酸钠（简称K）的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于以天然油脂氢化制得的脂肪醇（主要成分为C醇）、用三氧化硫酸化、中和制得的十二烷基硫酸钠，包括粉状、针（粒）状和液体产品。

Sodium lauryl sulfate for toothpaste

QB/T 2477-2007 牙膏用二水磷酸氢钙

本标准规定了牙膏用二水磷酸氢钙的要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于中和法及复分解法生产的牙膏用二水磷酸氢钙。该产品用作牙膏摩擦剂。

Dicalcium phosphate dihydrate for toothpaste

QB/T 2346-2007 牙膏用二氧化硅

本标准规定了牙膏用二氧化硅的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于化学反应法制备的二氧化硅系列，主要用于牙膏。

Silicon dioxide for toothpaste

QB/T 2335-2007 牙膏用山梨糖醇液

本标准规定了牙膏用山梨糖醇液的分类、要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于以液体葡萄糖为原料，在催化剂的作用下，经加氢反应、精制而制得的山梨糖醇液，该产品在牙膏工业中用作保湿剂。山梨糖醇液又称山梨醇（下简称山梨醇），在牙膏工业中通常使用低结晶型和结晶型山梨醇二种规格，两者均可使用，其中低结晶型山梨醇含量较低，总糖较高，抗冻性相对较强；结晶型山梨醇含量较高，总糖较低，抗冻性相对较差。

Sorbitol solution for toothpaste

QB/T 2318-2007 牙膏用羧甲基纤维素钠

本标准规定了牙膏用羧甲基纤维素钠的要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于以纤维素、烧碱及氯乙酸或其钠盐制得的牙膏用羧甲基纤维素钠。该产品在牙膏中用做增稠剂。

Carboxymethycellulose sodium for toothpaste

QB/T 2317-2007 牙膏用天然碳酸钙

本标准规定了牙膏用天然碳酸钙的要求、试验方法、检验规则和标志、包装、运输、贮存、保质期。 本标准适用于以水洗、晾晒干经雷蒙磨机加工成的牙膏用天然碳酸钙。

Crude calcium carbonate for toothpaste

KS M 2708-2007 工业用丙三醇

KS M 2708:2007이 규격은 공업용 글리세린에 대하여 규정한다.

Glycerines for industrial use

KS M 2704-2007 洗衣粉

이 규격은 의류 등의 세탁에 사용하는 분말상 또는 입상 등의 가루 세탁비누에 대해서 규정한

Powdered laundry soaps