T91 无轨电车零部件 标准查询与下载

ISO 18300:2016 电动车辆. 组合铅酸电池或电容器的锂离子电池系统试验规范

Electrically propelled vehicles - Test specifications for lithium-ion battery systems combined with lead acid battery or capacitor

JIS D 62196-3:2014 插头, 插座, 车辆连接器和车辆插孔. 电动车辆的传导充电. 第3部分: 直流和交流/直流电销以及导电管车辆耦合器的尺寸兼容性与互换性要求

Plugs, socket-outlets, vehicle connectors and vehicle inlets -- Conductive charging of electric vehicles -- Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers

UL 2231-2 CRD-2014 电动汽车 (EV) 电源电路用个人保护系统的UL安全标准: 充电系统中使用的保护设备的特殊要求. 节/段落参考: 第14节, 第17节, 第18A节, 和附件A主题: 可编程元件 (第二版: 2012年9月7日)

UL Standard for Safety Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: Particular Requirements for Protection Devices for Use in Charging Systems - Section / Paragraph Reference: Sections 14, 17, 18A, and Annex A Subject: Programma

UL 2251-2013 电动车的插头、插孔和电缆联接器标准

Standard for Plugs, Receptacles, and Couplers for Electric Vehicles

NF C58-982*NF EN 61982:2013 电动道路车辆驱动用蓄电池(锂电池除外). 性能和耐久试验

Secondary batteries (except lithium) for the propulsion of electric road vehicles - Performance and endurance tests

BS EN 61982:2012 电动道路车辆驱动用蓄电池(锂电池除外). 性能和耐久试验

Secondary batteries (except lithium) for the propulsion of electric road vehicles. Performance and endurance tests

UL 2231-2-2012 电动车辆(EV)供电线路的人员保护系统.充电系统用保护装置的详细要求

Personnel protection systems for electric vehicle (EV) supply circuits - Particular requirements for protection devices for use in charging systems

NF C58-985-2:2012 电动道路车辆驱动用锂离子蓄电池. 第2部分: 可靠性和滥用试验.

Secondary lithium-ion cells for the propulsion of electric road vehicles - Part 2 : reliability and abuse testing.

UL 2231-2-2002 电动车辆供电线路的人员保护系统.充电系统用保护装置的特殊要求

This standard is intended to be read together with the Standard for Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: General Requirements, UL 2231-1. The requirements of UL 2231-1 apply unless modified by this standard.

UL Standard for Safety Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: Particular Requirements for Protective Devices for Use in Charging Systems

UL 2231-1-2002 电动车辆供电线路的人员保护系统.一般要求

1.1 These requirements cover devices and systems intended for use in accordance with the National Electrical Code (NEC), ANSI/NFPA 70, Article 625, to reduce the risk of electric shock to the user from accessible parts, in grounded or isolated circuits for charging electric vehicles. These circuits are external to or on-board the vehicle. 1.2 The devices and systems covered by these requirements must be compatible with the designs of charging systems and vehicles where use is intended and shall be rated accordingly. To assure compatibility, the features contained in 1.3 - 1.5 are required of the charging system, the vehicle, or both. 1.3 The type of vehicle covered by these requirements, including all accessible conductive parts on the vehicle, have one or more of the following: a)Provision for the connection of an equipment grounding conductor during battery charging, unless the vehicle has a system of reinforced or double insulation or all of the circuitry on the vehicle is electrically isolated from the supply circuit; b) Provision for the connection of ground-monitoring conductors, where required; c)Reinforced insulation or be double-insulated from the supply circuit; ord)No direct connection between current carrying conductors and the vehicle chassis.1.4 These requirements cover devices and systems where the grounding path impedance of the charging system to the vehicle is less than or equal to the impedance of the ungrounded conductor or conductors. 1.5 These requirements cover devices and systems where a continuous current less than 70 mA RMS is available from any accessible part of the charging system. 1.6 Devices covered by these requirements are intended to interrupt the electric circuit to the load when: a) A fault current to ground exceeds some predetermined value that is less than that required to operate the overcurrent protective device of the supply circuit,b) The grounding path becomes open-circuited or becomes an excessively high impedance, orc) A path to ground is detected on an isolated (ungrounded) system.1.7 These devices and systems are intended to be applied on electrical systems or include derived systems that are:a) Either end-grounded or centrally grounded when the operating voltage is 150 Vrms or less,b) Centrally grounded when the operating voltage is greater than 150 Vrms, orc) Isolated (ungrounded).1.8 Charging circuit interrupting devices covered by these requirements are investigated for their ability to provide protection based on:a) The type of current (60 Hz AC, DC, a combination of AC and DC, or AC at frequencies greater than 60 Hz) present in the circuit to be protected, andb) Voltage.1.9 These requirements do not cover ground-fault circuit-interrupters (GFCIs) intended for use as personnel protection in accordance with the National Electrical Code on grounded 120 Vrms to ground, 60 Hz circuits. Such devices are covered under the Standard for Ground-Fault Circuit-Interrupters, UL 943. 1.10 This standard includes the Scope, Glossary, and Description of Requirements, including the required features of protection systems. The Standard for Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: Particular Requirements for Protection Devices for Use in Charging Systems, UL 2231-2, contains the Performance and Construction requirements for protective devices that would become a part of a charging system.

UL Standard for Safety Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: General Requirements First Edition

DIN EN 1987-3:2000 电动道路车辆.安全性特殊要求.第3部分:乘客电危害防护

The following items are covered: Definitions, voltage classes, protection against contact, thermal protection, and water protection.

Electrically propelled road vehicles - Specific requirements for safety - Part 3: Protection of users against electrical hazards; German version EN 1987-3:1998

DIN EN 1987-1:1998 电动道路车辆.安全性特殊要求.第1部分:车载蓄能器

Electrically propelled road vehicles - Specific requirements for safety - Part 1: On board energy storage; German version EN 1987-1:1997

NF U14-505:1997 农用拖拉机和机具.四点刚性悬挂联接装置.规范

Agricultural tractors and implements. Four-point rigid hitch. Specifications.

NBN-EN 25667-2-1993 水质．取样．部分2：取样技术的总指导（ISO 5667：2：1991）

Water quality. Sampling. Part 2: Guidance on sampling techniques (ISO 5667-2:1991)

NBN-EN 26777-1993 水质．亚硝酸盐的定量．分子吸收的光谱测定方法（ISO 6777：1984）

Water quality. Determination of nitrite. Molecular absorption spectrometric method (ISO 6777:1984)