共找到 599 条与 夹具 相关的标准,共 40 页
MS27424, dated 6 December 1965, is hereby reinstated as inactive for new design and may be used for acquisition.
CLIP ASSEMBLY, COCKPIT UTILITY LIGHT
A-A-51140B, dated 25 September 2000, has been reviewed and determined to be valid for use in acquisition.
CHUCKS, DRILL, KEY TYPE, THREE-JAW, GEARED
A-A-52529, dated 13 October 1995, has been reviewed and determined to be valid for use in acquisition
HANGER, EXHAUST, MUFFLER AND TAILPIPE (METRIC)
A-A-52528, dated 13 October 1995, has been reviewed and determined to be valid for use in acquisition
BRACKET, EXHAUST, MUFFLER AND TAILPIPE (METRIC)
MS39046A remains inactive for new design, however, the document is valid for use
CLAMP, ELECTRICAL, LASHING (POLE LINE)
A-A-52127, dated 15 June 1993, has been reviewed and determined to be valid for use in acquistion.
PIN, NET, LAUNDRY, (5-INCH)
This commercial item description (CID) establishes the government acquisition requirements for geared three-jaw drill chucks capable of being adjusted to hold any size straight shank tool within the capacity of the chuck. The jaws of the chuck shall be opened and closed by means of a pinion- type key.
CHUCKS, DRILL, KEY TYPE, THREE-JAW, GEARED
This "Aerospace Series'' Prestandard has been drawn up under the responsibility of AECMA (The European Association of Aerospace industries). It is published on green paper for the needs of AECMA-Members. It has been technically approved by the experts of the concerned Technical Committee following comment by the Member countries.
Aerospace Series P, Q and Saddle Clamps with Rubber Cushion Technical Specification Edition P 1
This notice should be filed in front of MS27405A dated 23 DECEMBER 1971.
CLAMP - TUBE
MIL-C-496D is inactive for new design and is no longer used except for replacement purposes.
CLIPS, END, STRAP
The General Services Administration has authorized the use of this commercial item description as a replacement for Military Specifications MIL-V-16720E and MIL-V-16721D which are cancelled.
CLAMPS, LOOP TYPE, AND STRAPS, SUPPORT
Machine tool fixture parts and components with axial fastening screw rack type positioner
Machine Tool Fixture Parts and Components Lathe Faceplate Safety Device Hexagon Screws
Machine tool fixture parts and components with axial fastening screw rack type locator positioning pin
Machine tool fixture parts and components with axial fastening screw rack type locator tooth sleeve
Machine Tool Fixture Parts and Components Type V Locator Type I Locator
Machine tool fixture parts and components with axial fastening screw rack type positioner bushing
This commercial item description covers a rod and clamp assembly used in supporting insect bars over certain types of military beds and cots.
ROD AND CLAMP, INSECT BAR
Machine tool fixture parts and components sliding flat head platen flat head platen
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号