W60 针织综合 标准查询与下载

GB/T 4856-1993 针棉织品包装

本标准规定了针棉织品包装用纸箱箱型、规格、包装含量、技术要求、装箱要求、包装标志、运输和储存要求、试验方法、检验规则。 本标准适用于各种原料制成的针棉织品和有关纺织复制品的包装。

Package of cotton goods and knitwear

FZ/T 70015-2022 针织紧身服压力的检测方法及评价

Measuring method and evaluation of pressure in knitted tights

FZ/T 70016-2022 针织物接缝处氨纶滑脱的试验方法

Test method for spandex slippage at seams of knitted fabrics

FZ/T 70017-2022 针织服装印花质量通用技术要求

General technical requirements for printing quality of knitted garments

T/CKIA 1-2019 文胸术语

本标准规定了文胸成品，部位、部件，文胸裁剪制图，制作工艺，成品不良，专用工具等相关术语和定义。

bra term

KS K 0815-2015 针织品的试验方法

Test methods for knitted fabrics

KS K 0830-2015 塑料钮扣耐久性试验法:冲击力

Test method for durability of the plastic buttons to impact force

JIS L 1075:2013 机织物及针织物的绒毛保持性用测试方法

This Standard specifies the testing methods for pile retention of pile woven and pile knitted fabrics. Loop pile knitted fabrics and mats are excluded.

Testing methods for pile retention of woven and knitted fabrics

KS K 0046-2012 针织纱标准公差

이 표준은 면방적 방식 또는 소모방적 방식으로 방적한 카드사와 코머사의 품질 특성값 허용차

Standard tolerances for yarns spun on the cotton or worsted systems

ASTM D3775-12 机织物经纱(端部)和纬纱数(挑选)的标准试验方法

1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias. 5.1.2 This test method is suitable for use with narrow fabrics when the count across the total width is measured in the narrow direction and extrapolated to the number of yarns per centimetre or inch. 1.1 This test method covers the measurement of warp end count and filling pick count and is applicable to all types of woven fabrics. Note 1???Historically, the term fabric count has been used to describe the end and pick count of woven fabrics. The terms warp (end) and filling (pick) count are replacing the term fabric count, to provide clarity. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics

ASTM D4769-12 纺织品和较舒适经纱针织品标准规格

Upon mutual agreement between the purchaser and seller, fabrics intended for this end use should meet all the requirements listed in Table 1 of this specification. It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable fabrics that do not conform to all of the requirements in Table 1. Therefore, one or more of the requirements listed in Table 1 may be modified by mutual agreement between the purchaser and seller. If any of the requirements in Table 1 are modified by mutual agreement between purchaser and seller, any reference to the specification shall state that: “This fabric meets ASTM Specification D4769, except for the following characteristic(s).” Where no prepurchase agreement has been reached between the purchaser and seller, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As stated in 5.2, ultimate consumer demands dictate varying performance parameters for any particular style of fabric. The significance and use of particular properties and test methods are discussed in the appropriate sections of the specified test methods.1.1 This specification covers woven and warp knitted comforter fabrics, composed of any textile fiber, or mixture of fibers. 1.2 These requirements apply to the length and width directions for those properties where fabric direction is pertinent. 1.3 The following safety hazards caveat pertains only to the test methods described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Woven and Warp Knitted Comforter Fabrics

KS K 0811-2011 针织品覆盖因子测定法

이 표준은 편성물의 밀도가 많고 적은지를 상대적으로 나타내는 커버 팩터 시험방법에 대하여

Test method for determination of the cover factor of knitted fabric

KS K 0818-2011 地毯试验方法

이 표준은 카펫의 시험방법에 대하여 규정한다.

Test method for carpet

KS K 0821-2011 易熔衬里试验法

이 표준은 접착 심지(이하 심지라 한다.)의 시험방법에 대하여 규정한다.

Test method for fusible interlining fabrics

KS K 0825-2011 布料的羽毛透过性试验方法:摩擦法

이 표준은 마찰 장치를 사용하여 깃솜털 충전재가 들어 있는 시험편을 통하여 깃솜털이 새어

Feather and down-Methods of testing the down proof properties of fabrics-Rubbing test

KS K 0816-2011 地毯的防燃烧性试验方法

이 표준은 완성된 모든 카펫의 방염성 측정 방법에 대하여 규정한다.이 표준은 규정된

Test method for flammability of carpet

KS K 0802-2011 短袜尺寸变化的测定

이 표준은 성인용 양말의 세탁 치수 변화 시험방법에 대하여 규정한다.

Test method for dimensional change in laundering of socks

KS K 0801-2011 短袜断裂伸长率的测定

이 표준은 성인용 짧은 양말의 신장 측정 방법에 대하여 규정한다.

Measuring method for stretching ability of socks

KS K 0814-2011 毛毯试验方法

이 표준은 모포 시험방법에 대하여 규정한다. 다만, 가장자리 천 등의 부자재 및 그 봉제

Test method for blankets

KS K 0823-2011 地毯抗菌性能试验法

이 표준은 새로운 카펫의 항균성 시험방법에 대하여 규정한다.

Test method for antimicrobial activity assessment of carpets