共找到 9 条与 相关的标准,共 1 页
Fire hazard testing -- Part 11-5: Test flames -- Needle-flame test method -- Apparatus, confirmatory test arrangement and guidance
Fire hazard testing -- Part 11-20: Test flames -- 500 W flame test method
Fire hazard testing -- Part 11-10: Test flames -- 50 W horizontal and vertical flame test methods
この規格は。火災危険をシミュレーション技術によって評価する手段として,故障状態によって生じる小さな炎の影響をシミュレートするためのニードルフレーム(注射針バーナ)試験について規定する。
Fire hazard testing -- Part 11-5: Test flames -- Needle-flame test method -- Apparatus, confirmatory test arrangement and guidance
この規格は,プラスチック及びその他の非金属材料の試験片を水平又は垂直に保持した状態で,公称54Wの炎にさらし,相対的な燃焼挙動を比較するための.試験室における小規模な燃焼試験方法について規定する。
Fire hazard testing -- Part 11-10: Test flames -- 50 W horizontal and vertical flame test methods
この規格は,プラスチック及びその他の非金属材料の試験片を公称500Wの炎にさらして。貫通孔及び相対的な燃焼挙動を比較するための,試験室での小規模な燃焼試験方法について規定する。
Fire hazard testing -- Part 11-20: Test flames -- 500 W flame test methods
Fire hazard testing - Part 9-1: Surface spread of flame - General guidance (IEC 60695-9-1:2005); German version EN 60695-9-1:2005
This part of IEC 60695 gives guidance on: a) optical measurement of smoke obscuration; b) general aspects of optical smoke test methods; c) consideration of test methods; d) expression of smoke test data; e) relevance of optical smoke data to hazard assessment. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.
Fire hazard testing - Part 6-1: Smoke obscuration - General guidance
This part of IEC 60695 specifies the mould stress relief distortion test as a test method for use by product committees. It is applicable to electrotechnical equipment including parts made from polymeric materials. This test is intended to simulate the effects caused by the relieving of moulding stresses by conditioning the product or part at a temperature higher than the maximum normal operating temperature and observing the nature of the resulting changes. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.
Fire hazard testing - Part 10-3: Abnormal heat; Mould stress relief distortion test
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号