共找到 15 条与 相关的标准,共 1 页
La présente Norme internationale spécifie les prescriptions de sécurité relatives aux rideaux, lanières et écrans transparents utilisés pour la protection des lieux de travail situés à proximité de zones où sont appliqués des procédés de soudage à l'arc. Ils sont conçus contre le danger des rayonnements émis par l'arc et des projections pour protéger les personnes qui ne sont pas impliquées dans le processus de soudage.
Health and safety in welding and allied processes - Transparent welding curtains, strips and screens for arc welding processes
Determination of fume emission rate during arc welding and collection of fume for analysis
Fume data sheets (Amendment 1)
Health and safety in welding and allied processes - Laboratory method for sampling fume and gases - Part 6: Procedure for quantitative determination of fume and gases from resistance spot welding (ISO/TS 15011-6:2012 + Cor. 1:2012); German version CEN ISO
Health and safety in welding and allied processes — Laboratory method for sampling fume and gases — Part 6: Procedure for quantitative determination of fume and gases from resistance spot welding — Technical Corrigendum 1
This part of ISO 15011 provides guidance on determination of emission rates of fume and gases generated byspot welding of uncoated and coated steel sheets, expressed as the quantity of pollutants per spot weld. Itdescribes the test principle and considers methods for sampling and analysis.
Health and safety in welding and allied processes - Laboratory method for sampling fume and gases - Part 6: Procedure for quantitative determination of fume and gases from resistance spot welding (ISO/TS 15011-6:2012)
Health and safety in welding and allied processes - Laboratory method for sampling fume and gases - Part 6: Procedure for quantitative determination of fume and gases from resistance spot welding
Health and safety in welding and allied processes - Laboratory method for sampling fume and gases - Part 4 : fume data sheets.
이 규격은 용접 및 관련공정에서의 안전과 보건에 적용된다. 이 규격은 퓸 데이터 시트를 작
Health and safety in welding and allied processes-Laboratory method for sampling fume and gases-Part 4:Fume data sheets
This part of ISO 15011 covers health and safety in welding and allied processes. It specifies requirements fordetermination of the emission rate and chemical composition of welding fume in order to prepare fume datasheets.
Health and safety in welding and allied processes - Laboratory method for sampling fume and gases - Part 4: Fume data sheets (ISO 15011-4:2006)
Establishes the general principles for the protection of persons from injury and illness, and for the protection of property and equipment from damage that can arise from welding and thermal cutting processes. Specific provisions are included for oxyfuel
Welding and thermal cutting processes - Health and safety
Настоящий стандарт распространяется на процессы плазменной обработки металлов и устанавливает требования безопасности при плазменной р
Occupational safety standards system. Plasma treatment of metals. Safety requirements
Настоящий стандарт распространяется на газопламенную обработку металлов во всех отраслях народного хозяйства и устанавливает общие тре
Occupational safety standards system. Flame machining of metals. Safety requirements
Specifies requirements for the selection of safe oxy-fuel gas hand-held or portable equipment used in welding, cutting, heating and allied processes. This Standard also details the safe operation and maintenance of this type of equipment. It applies to p
The safe use of portable and mobile oxy-fuel gas systems for welding, cutting, heating and allied processes
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号