71.040.40;71.040.50 标准查询与下载
共找到 13 条与 相关的标准，共 1 页
本标准规定了使用高效液相色谱法进行的定性定量分析和提纯精制的通用规则。 本标准适用于使用高效液相色谱法对无机、有机化合物的定性定量分析及提纯精制，以及对高分子化合物的分子量的测定的一般要求。
General rules for high performance liquid chromatography
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 2008-06-18
- 实施
- 2009-02-01
本标准规定了用原子吸收光谱仪进行定量分析的通用规则。 本标准适用于利用原子吸收光谱仪对从常量到痕量化学元素的定量分析。
General rules for atomic absorption spectrometric analysis
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 2008-06-04
- 实施
- 2008-12-01
This International Standard specifies a secondary-ion mass spectrometric method for the determination of boron atomic concentration in single-crystalline silicon using uniformly doped materials calibrated by a certified reference material implanted with boron. This method is applicable to uniformly doped boron in the concentration range from 1 × 1016 atoms/cm3 to 1 × 1020 atoms/cm3.
Surface chemical analysis - Secondary-ion mass spectrometry - Determination of boron atomic concentration in silicon using uniformly doped materials
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 2010-07
- 实施
5.1 The amount of volatile components reflects the impurity level in the product, and as a consequence, its behavior in a rubber mixture. 1.1 This test method covers the characterization of silanes of the type bis-(triethoxysilylpropyl)sulfanes by gas chromatography. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Silanes Used in Rubber Formulations
- ICS
- 71.040.40;71.040.50
- CCS
- 发布
- 2010
- 实施
This Technical Specification gives guidelines for the operation of glow discharge mass spectrometry (GD-MS) instruments and recommendations for the use of GD-MS. It is intended to be read in conjunction with the instrument manufacturers’ manuals and recommendations.
Surface chemical analysis - Glow discharge mass spectrometry (GD-MS) - Introduction to use
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 2009-04
- 实施
This International Standard describes three methods for measuring the lateral resolution achievable in Auger electron spectrometers and X-ray photoelectron spectrometers under defined settings. The straight-edge method is suitable for instruments where the lateral resolution is expected to be larger than 1 µm. The grid method is suitable if the lateral resolution is expected to be less than 1 µm but more than 20 nm. The goldisland method is suitable for instruments where the lateral resolution is expected to be smaller than 50 nm. Annexes A, B and C provide illustrative examples of the measurement of lateral resolution.
Surface chemical analysis - Auger electron spectroscopy and X-ray photoelectron spectroscopy - Determination of lateral resolution
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 2006-11
- 实施
この規格は，電位差滴定方法，電流滴定方法，電量滴定方法及びカールフィッシャー滴定方法を用いる場合の通則について規定する。 なお，滴定操作手順などは，個別規格で規定し，この規格では規定しない。
General rules for methods of potentiometric, amperometric, coulometric, and Karl Fischer titrations
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 2005-10-20
- 实施
General rules for methods of potentiometric, amperometric, coulometric, and Karl-Fischer titrations
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 1997-09-20
- 实施
Настоящий стандарт распространяется на вспомогательные электроды общепромышленного применения Государственной системы промышленных п
Potentiometric transducers SSI. Industrial auxiliary electrodes. Specifications
- ICS
- 71.040.40;71.040.50
- CCS
- 发布
- 1984
- 实施
- 1986-01-01
この規格は，作用電極の電位を制御し，その電極に流れる電流を測定するボーラログラフを用いて，無機物・有機物の定性及び定量分析を行う場合の通則について規定する。
General rules for polarographic analysis
- ICS
- 71.040.40;71.040.50
- CCS
- A43
- 发布
- 1983-12-01
- 实施
General rules for mass spectrometric analysis
- ICS
- 71.040.40;71.040.50
- CCS
- G04
- 发布
- 1979-03-01
- 实施
Настоящий стандарт распространяется на стеклянные электроды общепромышленного применения Государственной системы промышленных прибор
Glass industrial electrodes for determination hydrogan ion activition SSI. Specifications
- ICS
- 71.040.40;71.040.50
- CCS
- 发布
- 1977
- 实施
- 1978-07-01
Adopts ISO 19319:2003 to provide information for measuring lateral analysis, the analysis area and the sample area viewed by the analyser in Auger electron spectroscopy and X-ray photoelectron spectroscopy.
Surface chemical analysis - Augur electron spectroscopy and X-ray photoelectron spectroscopy - Determination of lateral resolution, analysis area and sample area viewed by the analyser
- ICS
- 71.040.40;71.040.50
- CCS
- 发布
- 实施
