ANSI/ASTM E1125-1999
利用平行光谱校准初级非浓缩地面光伏比对电池的试验方法

Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovolatic Reference Cells Using a Tabular Spectrum


 

 

非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 ANSI/ASTM E1125-1999 前三页,或者稍后再访问。

如果您需要购买此标准的全文,请联系:

点击下载后,生成下载文件时间比较长,请耐心等待......

 

标准号
ANSI/ASTM E1125-1999
发布日期
1999年
实施日期
1999年12月07日
废止日期
中国标准分类号
F12
国际标准分类号
27.160
发布单位
US-ANSI
适用范围
This test method is intended to be used for calibration and characterization of primary terrestrial photovoltaic reference cells to a desired reference spectral irradiance distribution, such as Tables G 173. The recommended physical requirements for these reference cells are described in Specification E 1040. Reference cells are principally used in the determination of the electrical performance of photovoltaic devices. Primary photovoltaic reference cells are calibrated in natural sunlight using the relative spectral response of the cell, the relative spectral distribution of the sunlight, and a tabulated reference spectral irradiance distribution. This test method requires the use of a pyranometer that is calibrated according to Test Method E 816, which requires the use of a pyrheliometer that is traceable to the World Radiometric Reference (WRR). Therefore, reference cells calibrated according to this test method are traceable to the WRR. This test method is a technique that may be used instead of the procedures found in Test Method E 1362. This test method offers convenience in its ability to characterize a reference cell under any spectrum for which tabulated data are available. The selection of the specific reference spectrum is left to the user. This test method applies only to the calibration of a photovoltaic cell that shows a linear dependence of its short-circuit current on irradiance over its intended range of use, as defined in Test Method E 1143. This test method applies only to the calibration of a reference cell fabricated with a single photovoltaic junction. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ANSI/ASTM E1125-1999 中可能用到的仪器设备





Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号