ASTM D2896-2015

Standard Test Method for Base Number of Petroleum Products by Potentiometric Perchloric Acid Titration



非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 ASTM D2896-2015 前三页,或者稍后再访问。




ASTM D2896-2015

5.1x00a0;New and used petroleum products can contain basic constituents that are present as additives. The relative amounts of these materials can be determined by titration with acids. The base number is a measure of the amount of basic substance in the oil, always under the conditions of the test. It is sometimes used as a measure of lubricant degradation in service; however, any condemning limits must be empirically established.

1.1x00a0;This test method covers the determination of basic constituents in petroleum products by titration with perchloric acid in glacial acetic acid.

1.2x00a0;Procedures A and B use different titration solvent volumes and sample weights.

Note 1:x00a0;A round robin on a series of new and used oils and additive concentrates has shown that the two procedures give statistically equivalent results.

1.3x00a0;Appendix X2 provides the use of an alternative solvent system which eliminates the use of chlorobenzene in this test method. The use of the alternative solvent gives statistically equivalent results; however, the precision is worse. Paragraph X2.5.5 provides guidance when comparing results using the two different solvents.

1.4x00a0;The constituents that may be considered to have basic characteristics include organic and inorganic bases, amino compounds, salts of weak acids (soaps), basic salts of polyacidic bases, and salts of heavy metals.

Note 2:x00a0;This test method is applicable to both fresh oils and used oils as described in Sections 16, 17, and 19 and Appendix X1.

1.5x00a0;This test method can be used to determine base number >3008201;mg KOH/g. However, the precision statement in Section 19 has been obtained only on base number x2264;3008201;mg KOH/g.

1.6x00a0;The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.7x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7, Section 10, and X2.2.

谁引用了ASTM D2896-2015 更多引用

高氯酸 测试方法


GB/T 1509-2016 锰矿石 硅含量的测定 高氯酸脱水重量法 GB/T 1509-1979 锰矿石中二氧化硅量的测定(高氯酸脱水重量法) GB/T 1509-2006 锰矿石 硅含量的测定 高氯酸脱水重量法 GB/T 1509-2016 锰矿石 硅含量的测定 高氯酸脱水重量法 GB/T 3286.2-2012 石灰石及白云石化学分析方法.第2部分:二氧化硅含量的测定.硅钼蓝分光光度法和高氯酸脱水重量法 GB/T 23835.13-2009 无水高氯酸锂.第13部分:澄清度的测定 GB/T 23835.11-2009 无水高氯酸锂.第11部分:铅含量的测定 GB/T 23835.12-2009 无水高氯酸锂.第12部分:总氮含量测定 GB/T 23835.2-2009 无水高氯酸锂.第2部分:高氯酸锂含量的测定 GB/T 23835.3-2009 无水高氯酸锂.第3部分:水分的测定 GB/T 23835.4-2009 无水高氯酸锂.第4部分:水不溶物含量的测定 GB/T 23835.5-2009 无水高氯酸锂.第5部分:氯化物含量的测定 GB/T 23835.6-2009 无水高氯酸锂.第6部分:氯酸盐含量的测定 GB/T 23835.7-2009 无水高氯酸锂.第7部分:硫酸盐含量的测定 GB/T 23835.8-2009 无水高氯酸锂.第8部分:钾和钠含量的测定 GB/T 23835.9-2009 无水高氯酸锂.第9部分:钙含量的测定 GB/T 23835.10-2009 无水高氯酸锂.第10部分:铁含量的测定 GB/T 33317-2016 塑料 酚醛树脂 六次甲基四胺含量的测定 凯氏定氮法、高氯酸法和盐酸法 GB/T 20614-2006 烟花爆竹 烟火药中高氯酸盐含量的测定 GB/T 22786-2008 烟花爆竹用高氯酸钾关键指标的测定 GB/T 4333.1-1984 硅铁化学分析方法 高氯酸脱水重量法测定硅量 GB/T 4702.2-1984 金属铬化学分析方法 高氯酸脱水重量法测定硅量 GB/T 8654.4-1988 金属锰化学分析方法 高氯酸脱水重量法测定硅量 GB/T 3653.3-1988 硼铁化学分析方法 高氯酸脱水重量法测定硅量 GB/T 223.60-1997 钢铁及合金化学分析方法 高氯酸脱水重量法测定硅含量 GB/T 7730.2-2002 锰铁及高炉锰铁 硅含量的测定 高氯酸脱水重量法 GB/T 5687.2-2007 铬铁 硅铬合金和氮化铬铁 硅含量的测定 高氯酸脱水重量法 GB/T 5686.1-2008 锰铁、锰硅合金、氮化锰铁和金属锰.锰含量的测定.电位滴定法、硝酸铵氧化滴定法及高氯酸氧化滴定法 GB/T 5686.2-2008 锰铁、锰硅合金、氮化锰铁和金属锰.硅含量的测定.钼蓝光度法、氟硅酸钾滴定法和高氯酸重量法 GB/T 4702.2-2008 金属铬.硅含量的测定.高氯酸重量法 GB/T 8638.3-1988 镍基合金粉化学分析方法高氯酸脱水重量法测定硅量 GB/T 4700.1-1984 硅钙合金化学分析方法 高氯酸脱水重量法测定硅量


Copyright ©2007-2016 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号