13.040.50 移动源排放限值 标准查询与下载

BS EN 50545-1:2011+A1:2016 停车场和隧道中有毒和可燃气体检测和测量用电气设备一氧化碳和氮氧化物检测和测量的一般性能要求和试验方法

What is BS EN 50545-1 - Electrical apparatus about?    BS EN 50545-1 is the first part of an international standard used for Electrical apparatus for the detection and measurement of toxic and combustible gases in car parks and tunnels.   BS EN 50545-1 specifies the test method that helps in constructing and manufacturing good quality electrical apparatus which helps in keeping the environment clean and healthy.    BS EN 50545-1 specifies general requirements for construction and testing and describes the test methods that apply to fixed apparatus for the detection and/or the measurement of the concentration of the target gases in car parks and tunnels.    BS EN 50545-1

Electrical apparatus for the detection and measurement of toxic and combustible gases in car parks and tunnels - General performance requirements and test methods for the detection and measurement of carbon monoxide and nitrogen oxides

DB22/T 1537-2011 在用柴油车加载减速法排气烟度排放限值及测量方法

Limit value and measurement method of exhaust smoke emission by loading deceleration method for diesel vehicles in use

DB22/T 1536-2011 在用轻型汽油车稳态工况法排气污染物排放限值及测量方法

Exhaust pollutant emission limits and measurement methods for light-duty gasoline vehicles under steady-state conditions

TIS 2555-2011 燃用天然气或液化石油气的装有强制点火发动机轻型机动车.安全要求.发动机排放.1级

Light motor vehicle equipped with positive ignition engines fuelled with natural gas or liquefied petroleum gas: safety requirements; emission from engine, level 1

TIS 2560-2011 机动车尾气排放：试验方法

Exhaust emissions from motor vehicles:test method

DB21/T 1970-2012 移动实验室有害废弃物管理规范

Mobile Laboratory Hazardous Waste Management Specifications

LST EN 50545-1-2012 停车场和隧道中有毒和可燃气体检测和测量用电气设备 第1部分：检测和测量一氧化碳和氮氧化物的通用性能要求和试验方法

Electrical apparatus for the detection and measurement of toxic and combustible gases in car parks and tunnels -- Part 1: General performance requirements and test methods for the detection and measurement of carbon monoxide and nitrogen oxides

DS/EN 50545-1:2011 检测和测量停车场和隧道中有毒和可燃气体的电气设备 第1部分：检测和测量一氧化碳和氮氧化物的一般性能要求和试验方法

This European Standard applies to apparatus for the detection and/or the measurement of carbon monoxide (CO), nitrogen monoxide (NO) and nitrogen dioxide (NO2) intended to control a ventilation system and/or to give an indication, alarm or any other signal to warn of a toxic hazard. These three gases are generically called “target gases” for the purpose of this European Standard.National and local regulations might not require detection of NO or NO2 and might require detection of other gases or vapours. This European Standard includes requirements for remote gas sensors (RGS) to be used in car parks and tunnels and requirements for the control unit (CU) to

Electrical apparatus for the detection and measurement of toxic and combustible gases in car parks and tunnels - Part 1: General performance requirements and test methods for the detection and measurement of carbon monoxide and nitrogen oxides

SAE J2914-2011 废气再循环(EGR)冷却器命名和应用

This document provides an overview on how and why EGR coolers are utilized, defines commonly used nomenclature, discusses design issues and trade-offs, and identifies common failure modes. The reintroduction of exhaust gas into the combustion chamber is just one component of the emission control strategy for internal combustion (IC) engines, both diesel and gasoline, and is useful in reducing exhaust port emission of Nitrogen Oxides (NOx). Other means of reducing NOx exhaust port emissions are briefly mentioned, but beyond the scope of this document.

Exhaust Gas Recirculation (EGR) Cooler Nomenclature and Application

SAE J1151-2011 用气相色谱法进行甲烷测量

This SAE Recommended Practice describes instrumentation for determining the amount of methane in air and exhaust gas. This document provides a means for a batch measurement of the methane concentration in light-duty vehicle exhaust samples. Nonmethane hydrocarbon concentration can be obtained by subtracting the methane concentration from the total hydrocarbon concentration obtained by a separate measurement made in accordance with accepted practices such as SAE J1094, J254, or a current federal Test Procedure.

Methane Measurement Using Gas Chromatography

DB36/ 617-2011 在用点燃式发动机轻型汽车简易瞬态工况法排气污染物排放限值

Limits of Exhaust Pollutant Emissions for Light Vehicles with Ignition Engines in Simple Transient Conditions

DB36/ 618-2011 在用压燃式发动机汽车加载减速法排气烟度排放限值

Limit value of exhaust smoke emission by loading deceleration method for compression ignition engine vehicles

ISO 15031-1:2010 道路车辆.排放相关的诊断用车辆和外部设备之间的通信.第1部分:一般信息与使用实例定义

This part of ISO 15031 gives an overview of the structure and the partitioning of ISO 15031, and shows the relation between the different parts. It also defines the corresponding SAE recommended practices and reference to the SAE Digital Annexes. The terminology defined in this part of ISO 15031 is common for all parts of ISO 15031. This part of ISO 15031 also describes the use cases applicable to the communication between vehicle and external test equipment for emissions-related diagnostics.

Road vehicles - Communication between vehicle and external equipment for emissions-related diagnostics - Part 1: General information and use case definition

GSO ECE 40:2010 摩托车排放的气态环境污染物

This Regulation applies to the emission of gaseous pollutants from positive-ignition engines of two-wheeled or three-wheeled motor cycles with an unladen weight of less than 400 kg having a maximum design speed exceeding 50 km/h and/or cylinder capacity exceeding 50 ccm.

Emission of gaseous pollutants of motor cycles

GSO ECE 103:2010 机动车催化转化器更换审批统一要求

This Regulation applies to the type-approval, as separate technical units, of catalytic converters to be fitted in one or more types of motor vehicles of categories M1 and N1 as replacement parts."

Uniform provisions concerning the approval of replacement catalytic converters for power-driven vehicles

DB11/ 206-2010 储油库油气排放控制和限值

本标准规定了储油库在储存、收发汽油过程中汽油油气排放的控制要求、限值和检测方法。本标准适用于存储汽油的储油库新建、改建、扩建和现有油库油气回收改造项目的设计、验收、环境影响评价和建成后的油气排放管理。本标准对汽油发油平台的要求也适用于柴油发油平台。

Oil and gas emission control and limit value of oil depot

DB11/ 207-2010 油罐车油气排放控制和限值

本标准规定了油罐汽车（以下简称“油罐车”）在燃油运输过程中油气泄漏排放的控制要求、排放限值和检测方法。本标准适用于油罐车（包括制造厂新生产的油罐车）油气排放控制的管理。

Oil and gas emission control and limit value of oil tanker

DB11/ 208-2010 加油站油气排放控制和限值

{[4]}本标准规定了加油站汽油油气排放控制的技术要求、排放限值和检测方法。本标准适用于加油站新建、改建和扩建项目和现有加油站油气回收改造项目的设计、安装、验收、环境影响评价和建成后的汽油油气排放管理。

Oil and gas emission control and limit value of gas station

DB11/ 183-2010 在用三轮汽车和低速货车加载减速烟度排放限值及测量方法

本标准规定了在用三轮汽车和低速货车加载减速烟度排放的检测方法和检查项目、限值及结果判定、测量结果与数据记录要求。本标准适用于装用压燃式发动机、最大设计总质量不大于4500kg、最大设计速度不大于70km/h的在用三轮汽车和低速货车。

Smoke emission limits and measurement methods during deceleration of three-wheeled vehicles and low-speed trucks

DB11/ 121-2010 在用柴油车加载减速烟度排放限值及测量方法

本标准规定了在用柴油车加载减速烟度排放的检测方法和检查项目、限值及结果判定、测量结果与数据记录要求。本标准适用于装用柴油机、最大总质量大于400kg、最大设计速度大于或等于50km/h的在用汽车。

Limit value and measurement method of smoke emission during deceleration of diesel vehicles in use