13.060.45 水检验综合 标准查询与下载



共找到 326 条与 水检验综合 相关的标准,共 22

This International Standard gives guidance on the selection, and requirements for the application, of ready-to-use methods in water analysis. The so-called "ready-to-use methods" are of increasing interest because, compared to standard methods, they allow fast and often inexpensive results for analytical problems. Under certain conditions these methods can be applied in routine control of water quality, provided they give reliable results. This International Standard deals with practical aspects concerning quantitative ready-to-use methods. Statistical evaluations for establishing the equivalence of ready-to-use methods and standard methods are only mentioned briefly. As the available ready-to-use methods are based on different analytical principles and also show different degrees of accuracy, they are classified into several groups. The aim of this International Standard is to set up criteria as to when the different kinds of ready-to-use methods may be applied for the analysis of distinct parameters in water samples (e.g. potable water, river water, process water, waste water) and which steps are necessary to prove their suitability for a certain application. Ready-to-use methods have to meet special requirements because they are often used by non-chemists. This International Standard lists requirements for the producers of these tests, concerning safety and environmental aspects as well as handling and a description of the procedure. There are also several requirements concerning the training and supervision of the users of ready-to-use methods.

Water quality - Selection and application of ready-to-use test kit methods in water analysis

ICS
13.060.45
CCS
Z16
发布
2003-12
实施

This International Standard describes the performance testing of on-line sensors/analysing equipment for water. The standard is applicable to most sensors/analysing equipment, but it is recognized that, for some sensors/analysing equipment, certain performance tests cannot be carried out. This International Standard — defines an on-line sensor/analysing equipment for water quality measurements; — defines terminology describing the performance characteristics of on-line sensors/analysing equipment; — specifies the test procedures (for laboratory and field) to be used to evaluate the performance characteristics of on-line sensors/analysing equipment.

Water quality - On-line sensors/analysing equipment for water - Specifications and performance tests

ICS
13.060.45
CCS
Z16
发布
2003-10
实施

This standard specifies requirements on carrying out interlaboratory trials for external quality control of laboratories. With respect to the purpose the standard differs from DIN 38402-41 and DIN 38402-42, which are used for quantitative statements about reliability of analytical methods. In this standard requirements are specified for the organizer of interlaboratory trials as well as on planning, carrying out and evaluation of interlaboratory trials for external quality control of laboratories.

German standard methods for the examination of water, waste water and sludge - General information (group A) - Part 45: Interlaboratory comparisons for proficiency testing of laboratories (A 45)

ICS
13.060.45
CCS
Z16;Z23
发布
2003-09
实施

This standard provides sampling procedures with electricity procedures to be used by trained persons in evaluating fish communities in streams, rivers and littoral areas for the purpose of classification of ecological status. These procedures allow standardisation of sampling methods for descriptions of fish communities. The use of standardised methods is a critical requirement for the comparability of results.

Water quality - Sampling of fish with electricity

ICS
13.060.45
CCS
发布
2003-08-11
实施
2003-06-27

Water Quality - Sampling - Part 3: Guidance on the Preservation and Handling of Samples ISO 5667-3:2003

ICS
13.060.45
CCS
发布
2003
实施

Water quality - Determination of radionuclides - General data

ICS
13.060.45
CCS
发布
2003
实施

The standard specifies a method to test the equivalence of the results obtained by two different analytical methods for the analysis of water samles. The test of equivalence is applied for the comparison of a reference method and an alternative method and a reference method and a modified reference method. It can be used for the direct comparison of two alternative methods or two modified reference methods. When two alternative methodes are compared the introduced method takes the place of the reference method.

German standard methods for the examination of water, waste water and sludge - General information (group A) - Part 71: Equivalance of two analytical methods based on the comparison of results and their statistical evaluation, Procedure for quantitative c

ICS
13.060.45
CCS
Z23;Z16
发布
2002-11
实施

This part of ISO 5667 provides guidance on the sampling of groundwater at potentially contaminated sites. It is applicable to situations where contamination of the subsurface could exist as a result of downward migration of pollutants whose source is at the surface or just below it, and when the guidance provided in ISO 5667-11 is inappropriate.

Water quality - Sampling - Part 18: Guidance on sampling of groundwater at contaminated sites

ICS
13.060.45
CCS
Z16
发布
2001-04
实施

The proper use of analytical data requires adequate documentation of all inputs, that is, the source and history of the sample, laboratory performing the analysis, method of analysis, date of analysis, precision and bias of the measurements, and related quality assurance information. In order to have defensible data, the report must be complete and accurate, providing adequate information to evaluate the quality of the data and contain supporting information that documents sampling and analysis procedures. This guide contains some of the common data qualifiers or “flags” commonly used by laboratories following the Good Laboratory Practices, the Government Contract program, or found in the commercial laboratories. Examples of these qualifiers are the use of (E) for estimated value, (U) for analyzed for but not detected, and (B) for analyte was found in the blank (see 8.11). The qualifiers included in this guide should help the laboratory and its customers to better understand each other by using standardized qualifiers. Practice D933 is a comprehensive practice for reporting water-formed constituents such as metal oxides, acid anhydrides, and others.1.1 This guide provides guidelines for reporting inorganic and organic results of analyses of drinking water, waste water, process water, ground water, and surface water, and so forth, to laboratory clients in a complete and systematic fashion. 1.2 The reporting of bacterial and radiological data are not addressed in this guide. 1.3 The commonly used data qualifiers for reviewing and reporting information are listed and defined. Client and laboratory specific requirements may make use of other qualifiers. This guide does not preclude the use of other data qualifiers. 1.4 This guide discusses procedures for and specific problems in the reporting of low level data, potential errors (Type I and Type II), and reporting data that are below the calculated method detection limit and above the analyte. 1.4.1 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Standard Guide for Reporting Results of Analysis of Water

ICS
13.060.45
CCS
Z16
发布
2001
实施

This part of ISO 5667 is applicable to the sampling of suspended solids for the purpose of monitoring and investigat-ing freshwater quality, and more particularly to flowing freshwater systems such as rivers and streams. Certain ele-ments of this part of ISO 5667 may be applied to freshwater lakes, reservoirs and impoundments, however field sampling programmes may differ and are not necessarily covered here.

Water quality - Sampling - Part 17: Guidance on sampling of suspended sediments

ICS
13.060.45
CCS
Z16
发布
2000-07
实施

1.1 This guide covers the selection and use of automatic wastewater samplers including procedure for their use in obtaining representative samples. Automatic wastewater samplers are intended for the unattended collection of samples that are representative of the parameters of interest in the wastewateer body. While this guide primarily addresses the sampling of wastewater, the same automatic samplers may be used to sample process streams and natural water bodies. 1.2 The guide does not address general guidelines for planning waste sampling activities (see Guide D4687), development of data quality objectives (see Practice D5792), the design of monitoring systemsand determination of the number of samples to collect (see Practice D6311), operational details of any specific type of sampler, in-situ measurement of parameters of interest, data assessment and statistical interpretation of resultant data (see Guide D6233), or sampling and field quality assurance (see GuideD5612). It also does not address sampling groundwater. 1.3 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Guide for Sampling Wastewater With Automatic Samplers

ICS
13.060.45
CCS
发布
2000-05-10
实施

This International Standard specifies a procedure which can be used to determine the genotoxicity of water and waste water using the umu-test. This assay is based on the detection of genotoxicity of a test sample which increases the expression of the SOS-repair system associated with the umuC-gene. note: 1) Toxicity which specifically affects the genome (genetic material). 2) SOS repair occurs when cells are overwhelmed by genotoxins allowing the cell to survive at the cost of mutagenesis. 3) umuC-gene is the acronym for UV mutagenesis gene C. The induction of the umuC-gene is part of the specific response of the bacterial cell to DNA-damage.

Water quality - Determination of the genotoxicity of water and waste water using the umu-test

ICS
13.060.45
CCS
Z16
发布
2000-03
实施

This part of ISO 5667 provides guidance on the procedures for preservation and handling of sewage and waterworks sludges, suspended matter, and saltwater and freshwater sediments for subsequent analysis.

Water quality - Sampling - Guidance on preservation and handling of sludge and sediment samples

ICS
13.060.45
CCS
Z16
发布
1999-10-15
实施
1999-10-15

This part of ISO 5667 provides guidance on the procedures for preservation and handling of sewage and waterworks sludges, suspended matter, and saltwater and freshwater sediments for subsequent analysis.

Water quality - Sampling - Part 15: Guidance on preservation and handling of sludge and sediment samples

ICS
13.060.45
CCS
Z16
发布
1999-08
实施

This international standard gives practical guidance on sampling, pretreatment, performance and evaluation of waters in the context of biotesting. Information is given on how to cope with the problems for biotesting arising from the nature of the sample and the suitability of the test design.

Water quality - Sampling - Part 16: Guidance on biotesting of samples

ICS
13.060.45
CCS
发布
1999-06-07
实施
1999-03-31

Water quality. Guide to analytical quality control for water analysis

ICS
13.060.45
CCS
Z16
发布
1999-02-15
实施
1999-02-15

Provides guidance on the design of sampling programmes, sampling techniques and the handling of water samples taken from groundwater for physical, chemical and microbiological assessment.

Water quality - Sampling Part 11: Guidance on sampling of groundwaters

ICS
13.060.45
CCS
Z12
发布
1999-01-15
实施

Provides guidance on sampling techniques used to obtain the data necessary to make analyses for the purposes of quality control, quality characterization and identification of sources of pollution of waters.

Water quality - Sampling Part 2: Guidance on sampling techniques

ICS
13.060.45
CCS
Z12
发布
1999-01-15
实施
1999-01-15

Presents detailed principles to be applied to the design of sampling programmes, to sampling techniques and the handling and preservation of samples of water from natural and man-made lakes.

Water quality - Sampling Part 4: Guidance on sampling from lakes, natural and man-made

ICS
13.060.45
CCS
Z12
发布
1999-01-15
实施

This part of ISO 5667 provides guidance on the selection and use of various quality assurance techniques relating to the manual sampling of surface, potable, waste, marine and ground waters; NOTE The general principles outlined in this part of ISO 5667 in some circumstances may be applicable to sludge and sediment sampling.

Water quality - Sampling - Guidance on quality assurance of environmental water sampling and handling

ICS
13.060.45
CCS
Z16
发布
1998-11-15
实施
1998-11-15



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号