13.220.10 灭火 标准查询与下载

DB5113/T 27-2022 大型商业综合体建筑灭火救援预案编制指南

Guidelines for the preparation of fire fighting and rescue plans for large commercial complex buildings

DB5113/T 29-2022 大型商业综合体建筑火灾排烟行动指南

Action guidelines for fire and smoke exhaust in large commercial complex buildings

T/ZZB 2812-2022 简易式水基型灭火器

本文件规定了简易式水基型灭火器的分类与型号、 基本要求、技术要求、试验方法、检验规则、标志、包装、运输、贮存和质量承诺。 本文件适用于在60 ℃时最大工作压力不超过1.2 MPa的简易式水基型灭火器（以下简称灭火器） 。

Simple water-based fire extinguishers

T/QDAS 101-2022 消防排烟灭火机器人

本文件规定了消防排烟灭火机器人（以下 简称“消防机器人”）的术语和定义、功能、技术要求、试验方法、标志、包装、运输及贮存等方面的内容。   本文件适用于在地面行走的一种人工遥控的以排烟、灭火为主的消防机器人。

Fire smoke exhaust fire extinguishing robot

T/CSEE 0322-2022 移动式细水雾涡扇炮灭火系统及部件通用技术条件

本文件规定了移动式细水雾涡扇炮灭火系统及部件的性能要求、试验方法、标志、包装、运输和贮存。 本文件适用于移动式细水雾涡扇炮灭火系统。

General technical conditions for mobile water mist turbofan cannon fire extinguishing systems and components

DB37/T 4562-2022 森林航空消防直升机吊桶灭火操作规程

Forest Aviation Fire Helicopter Bucket Fire Extinguishing Operation Rules

CAN/ULC 522:2022 灭火器和增压软管标准

Scope 1.1 These requirements cover hose in nominal internal diameter sizes of 8 mm up to and including 32 mm for use on portable and wheeled fire extinguishers, hand hose line fixed extinguishing systems, and also as booster hose on fire apparatus. 1.2 Fire extinguisher, hand hose line system and booster hose covered by these requirements is intended for use at a maximum working pressure of 1400, 2800, 4200, 5600, 7000, or 8750 kPa (gauge) at a minimum temperature of –40 °C. 1.3 These requirements also cover hose for use at –54 °C. 1.4 These requirements also cover hose designated as oil resistant. 1.5 These requirements do not cover couplings nor their method of attachment. NOTE: Reference to each applicable Test Method for a requirement is indicated by the letters TM and the appropriate clause number in parenthesis in the right hand margin.

STANDARD FOR FIRE EXTINGUISHER AND BOOSTER HOSE

22/30396867 DC BS 750 地下消防栓 表面盒框架和盖子 规格

BS 750. Underground fire hydrants. Surface box frames and covers. Specification

DB12/T 1171-2022 轨道交通车辆高压细水雾灭火装置设置与安装技术规范

Technical specifications for setting and installation of high-pressure water mist fire extinguishing devices for rail transit vehicles

22/30465306 DC BS 5306-8 场所内的灭火装置和设备 便携式灭火器的选择和放置 实践守则

BS 5306-8. Fire extinguishing installations and equipment on premises - Selection and positioning of portable fire extinguishers. Code of practice

ASTM D6064-11(2022) HFC-227ea 1,1,1,2,3,3,3-七氟丙烷（CF3CHFCF3）的标准规范

1.1 This specification covers requirements for HFC-227ea as a fire-fighting medium. 1.2 This specification does not address the fire-fighting equipment or hardware that employs HFC-227ea or the conditions of employing such equipment (for example, handhelds, fixed installations, etc.). 1.3 This specification does not address the storage or transportation of HFC-227ea. Storage, handling, and transportation issues may be addressed in future ASTM specifications. 1.4 The values stated in both inch-pound and SI units are to be regarded separately as the standard. The values given in parentheses are for information only. 1.5 The following safety hazards caveat pertains only to the test methods portion, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Note 1. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for HFC-227ea, 1,1,1,2,3,3,3-Heptafluoropropane (CF3CHFCF3)

T/NJFPA A004-2022 高硅氧灭火毯

1  范围 2  规范性引用文件 3  术语和定义 4  型号、规格 5  要求 6  试验方法 7  检验规则 8  标志、包装、运输与贮存 附录A 高硅氧玻璃纤维机织物高温强力的测定  附录B 高硅氧玻璃纤维机织物热收缩率的测定 附录C 高硅氧玻璃纤维机织物热失量的测定

High Silica Fire Blanket

ASTM D5632/D5632M-17(2022) 溴三氟甲烷（CF3Br）哈龙1301标准规范

1.1 This specification covers the requirements for Halon 1301 as a fire-fighting medium. 1.2 This specification does not address the fire-fighting equipment or hardware that employs Halon 1301 or the conditions of employing such equipment (for example, handhelds, fixed installations, etc.). 1.3 This specification does not address the storage or transportation of Halon 1301. Storage, handling, and transportation issues are addressed in Practice D5631. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.5 The following safety hazards caveat pertains only to the test methods portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in 4.5. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Halon 1301, Bromotrifluoromethane (CF3Br)

BS ISO 6183:2022 消防设备 室内使用的二氧化碳灭火系统 设计与安装

1   Scope This document specifies requirements and gives recommendations for the design, installation, testing, maintenance and safety of fixed carbon dioxide firefighting systems in buildings, plants or other structures. It is not applicable to extinguishing systems on ships, in aircraft, on vehicles or on mobile fire appliances, or to below‑ground systems in the mining industry; nor does it apply to carbon dioxide pre-inerting systems. Design of systems where unclosable opening(s) exceed a specified area and where the opening(s) can be subject to the effect of wind is not specified, although general guidance on the procedure to be followed in such cases is given (see 7.4.3.2).

Fire protection equipment. Carbon dioxide extinguishing systems for use on premises. Design and installation

T/CASMES 140-2022 智能室外消火栓

本文件规定了智能室外消火栓的术语和定义、智能终端要求、管理软件要求、安全要求、维护要求。 本文件适用于消防给水管道中智能室外消火栓产品的设计、生产、检验和维护。

Intelligent outdoor fire hydrant

BS 6165:2019+A1:2022 小型一次性灭火器 规格

1   Scope This British Standard specifies performance requirements for, and the maximum capacity of, small single use fire extinguishers of the aerosol type with metal bodies . This British Standard covers single use fire extinguishers for various applications, including but not limited to, usage in cars, motor homes, etc. This British Standard is applicable to extinguishers containing powder or water-based media which allow use for single fire class applications. Clean agents are excluded from the Scope of this British Standard. Requirements are specified for minimum performance in extinguishing test fires of Class A, B and F, as defined in BS EN 2. NOTE Annex A gives the conditioning treatment to be applied to extinguishers prior to testing, as described in Annex B to Annex I. Annex J gives the use code symbols to be used.

Small, single-use, fire extinguishers. Specification

T/JFPA 0011-2022 双浮力消防水带

本标准规定了双浮力消防水带在符合GB 6246-2011的技术要求和试验方法的基础上，还应满足的技术要求与试验方法。 本标准适用于以聚乙烯纤维丝（或优于聚乙烯纤维丝的材料）作为消防水带编织层材料，通过水带编织层与内衬的粘合工艺，使得经过创新升级后消防水带质量更轻，水面浮力更大承压能力更强的双浮力消防水带。

Double buoyancy fire hose

T/JFPA 0010-2022 旋转式快速接口

依靠特殊轴承和滑块的配合，在水压状态下能使扭曲水带迅速自由旋转打开通水的快速接口。

Rotary quick interface

T/CSPIA 009-2022 城市轨道交通车辆细水雾灭火系统技术规程

近年来，随着轨道交通建设的不断发展，我国轨道交通车辆火灾险情时有发生。采用传统被动式的手持灭火器，如在车辆狭窄空间使用对人体会产生二次伤害。本标准从一般要求、系统组成、火灾自动报警系统、细水雾灭火系统、电控柜灭火装置、验收和运行维护要求等方面，对城市轨道交通车辆细水雾灭火系统进行了阐述，进一步明确系统应用于轨道交通车辆的技术要求，指导车辆制造厂和供应商进一步明确验收和运行维护的相关指标，对系统的实际应用，具有一定的参考和指导作用。

Technical code of practice for water mist fire extinguishing system of urban rail transit vehicles

DB5119/T 24-2022 公路隧道火灾扑救行动指南

本文件适用于公路隧道火灾扑救行动的辅助决策和参考依据

Guidelines for Fire Fighting in Highway Tunnels