共找到 38 条与 相关的标准,共 3 页
Degrees of protection provided by enclosures (IP code)
Stationary lead-acid batteries. General requirements and methods of test. Part 1: Vented types
Connectors for optical fibres and cables. Part 9: Sectional Specification. Fibre optic connector type OF-2
The section of IEC 839-5 specifies the general requirements for equipment used in alarm systems. It does not specify the equipment used to display the information at the alarm receiving centre or installation of the equipment. Additional requirements for specific types of alarm transmission systems are given in separate sections as part of IEC 839-5. This does not preclude the use of any alarm transmission system not covered by any one of these specific sections, provided...
Alarm systems. Part 5: Requirements for alarm transmission systems. Section 2: General requirements for equipment
The section of IEC 839-5 specifies the general requirements for the performance, reliability and security characteristics of alarm transmission systems. It covers the general requirements for connectors providing signaling between an alarm system and an alarm receiving centre. Additional requirements for specific alarm transmission systems are given in separate sections as parts of IEC 839-5. This does not preclude the use of any transmission system not covered by one of...
Alarm systems. Part 5: Requirements for alarm transmission systems. Section 1: General requirements for systems
Guidance is included in each of the methods referred to in this standard but it is specific to the test method. The guidance in this standard is directed towards choosing the appropriate test method and applying it to seismic testing.
Environmental testing. Part 3:Guidance. Seismic test methods for equipments
Environmental testing. Part 2: Test methods. Test Ef: Impact,pendulum hammer
Environmental testing. Part 2: Test methods. Test Z/ABDM: Climatic sequence
Environmental testing. Part 2: Tests. Test Ed: Free fall
Basic environmental testing procedures. Part 2: Test. Test U: Robustness of terminations and integral mounting devices
Protection of structures against lighting. Part 1: General principles
Short-circuit calculation in three-phase a.c. systems
Identification of insulated and bare conductors by colours
Classification of environmental conditions. Part 2: Environmental conditions appearing in nature. Temperature and humidity.
The standard presents fundamental properties, quantities for characterization and a classification of environmental conditions dependent on precipitation and wind, relevant for electrotechnical products. Defines the characteristics of precipitation and wind as background for the severities to which products are liable to be exposed during transportation, storage and use.
Classification of environmental conditions. Part 2: Environmental conditions appearing in nature. Precipitation and wind
The standard indicates values of air pressure to which produ cts are liable to be exposed during transportation, storage and use
Classification of environmental conditions. Part 2: Environmental conditions appearing in nature. Air pressure
Classification of environmental conditions. Part 2: Environmental conditions appearing in nature. Solar radiation and temperature
The standard describes influences from fauna and flora to which products are liable to be exposed during storage, transportation and use.
Classification of environmental conditions. Part 2: Environmental conditions appearing in nature. Fauna and flora
Classification of environmental conditions. Part 3: Classification of groups of environmental parameters and their severities. Introduction
Classification of environmental conditions. Part 3: Classification of groups of environmental parameters and their severities. Storage
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号