共找到 214 条与 键和键槽、花键 相关的标准,共 15 页
この規格は,一般の機械に用いる鋼製の平行キー,こう配キー及び半月キー(以下,これらを総称してキーという。),並びにこれらに対応するキー溝について規定する。
Keys and their corresponding keyways
この規格は,小径による中心合わせを行う,円筒軸に用いる軽荷重用及ぴ中荷重用の角形スプラインの寸法について規定する。また。管理方法及ぴ対応するゲージについても規定する。
Straight-sided splines for cylindrical shafts with internal centering -- Dimensions, tolerances and verification
Covers requirements for square and rectangular parallel keeys and keyways intended for both alginment of shafts and hubs, and transmitting torque between the shafts and hubs.
Woodruff Keys & Keyways
This Standard covers requirements for square and rectangular parallel keys and keyways intended for both alignment of shafts and hubs, and transmitting torque between the shafts and hubs.
Square and Rectangular Keys and Keyways
Стандарт применяют для цилиндрических концов валов, для специальных случаев как, например, установка их в тонкостенных деталях. Стандарт
Basic requirements for interchangeability. Thin taper keys with and without gib head and their corresponding keyways. Dimensions and tolerances
Mechanical transmissions. Woodruff keys. Dimensions and tolerances.
Mechanical transmissions. Tangential keys and keyways. Dimensions and tolerances.
Thin parallel keys and their corresponding keyways. Dimensions and tolerances
Keying. Forced assembly by means of taper keys. Dimensions.
Keying. Assembly by means of parrallel keys. Dimensions.
Taper keys forced assembly. Dimensions.
本标准适用于斜面键及平键之键槽公差。
Tolerance of Key Slot for Taper and Flat Key
本标准适用于滑键螺钉及孔。
Screw and Hole for Sliding Key
本标准适用于冷拉之键子钢剖面及偏差。
Key Section and Tolerance (Cold Drawing)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号