23.100.99 其他流体动力系统部件 标准查询与下载

GOST 19751-1984 与金属平面垫连接阀的凹部.结构及尺寸

Flat metal gasket joint gate seats. Design and dimensions

CNS 8197-1982 液压用电磁线圈总成检验法（干式）

本标准规定 CNS 8196 液压用电磁线圈总成之检验法。

Method of Test for Solenoid Assembly (Oil - Hydraulic Use - Dry Type)

GOST 25144-1982 气压传动.气动消音器.一般技术要求及试验方法

Air silensers. Specifications

ISO 4400:1980 流体动力系统和部件.三针电气插头连接器.特性和要求

Fluid power systems and components — Three-pin electrical plug connector — Characteristics and requirements

ISO 3722:1976 液压传动 油液取样容器 净化方法的鉴定和控制

Specifies a method, and establishes a means for ensuring that the accuracy of particulate contamination analyses in hydraulic systems is not degraded by a lack of sample container cleanliness. Gives definitions and tabulates the inspection ratios together with the AQQL values of concern.

Hydraulic fluid power; Fluid sample containers; Qualifying and controlling cleaning methods

ISO 3724:1976 液压传动 滤芯 流动疲劳特性的验证

Specifies a method for determining the characteristics of a filter element and establishes a uniform method for verifying the ability of an element to withstand the flexing caused by cyclic differential pressures without altering its collapse/burst rating. Gives definitions, test procedures, and criteria for acceptance. A figure shows the typical test stand.

Hydraulic fluid power; Filter elements; Verification of flow fatigue characteristics

AS 2842:1986 液压能力．O型环和外壳．英制，公制转换

Specifies the dimensions of elastomeric O-rings used for sealing components against the ingress of contaminants and the egress of fluids under dynamic and static conditions, and the dimensions of O-ring housings with and without anti-extrusion back-up washers. It is based on the former AS B320 and has been extended to include the range of O-rings specified in SAE Aerospace Standard AS 568A. Groove dimensions for static and dynamic applications for both internal and external pressures are specified, and information on parallel tube fitting boss gaskets is included.

Fluid power - O-rings and housings - Inch series, metric conversion

AS 2974:1987 液压能力系统与元件

Specifies requirements including dimensions for metric parallel-threaded ports for pressures up to 40 000 kPa.

Fluid power systems and components - Metric ports - Dimensions and design

MT/T 94-1996 液压支架立柱、千斤顶内径及活塞杆外径系列

本标准规定了液压支架立柱、干斤顶内径及活塞杆外径系列。 本标准适用于液压支架用立柱、千斤顶。

Inner diameter of upright post of hydraulic support and lifting jack and outer diameter of piston rod