气动工具标准-分析测试百科网

This document specifies a laboratory performance test method for power assembly tools (referred throughout the document as “tool”) for installing threaded fasteners. It provides a method for the measurement of torque repeatability (scatter) — over a range of torque rates as specified in this document, — over a range of torque adjustment as defined by the manufacturer, and — over a number of operating cycles as defined by the manufacturer. It provides a method for the measurement of the precision of the built-in torque measurement system for tools incorporating such a feature. See Annex E. It gives instructions on equipment parameters, what to test for and how to evaluate and present the test data. It is applicable to tools — of any power source, e.g. pneumatic, hydraulic, and electric, including battery-powered, — which apply torque in a generally continuous manner, and — within the torque range 0,5 Nm to 2000 Nm. Outside this range, it is acceptable to modify the test method providing that the modification is documented in the test report. It is not applicable to — impact or impulse wrenches, — ratchet wrenches or wrenches with ratcheting clutches, and — other tools which advance fasteners in discontinuous increments, overcoming static friction at each increment. It allows a test to be performed at any test torque level; however, in order to minimize the number of test joints necessary for a wide range of test torque levels, a list of preferred test torque levels is provided in Annex A.

Rotary tools for threaded fasteners - Performance test method

ICS: 25.140.10
CCS: J48
发布: 2017-11-01
实施

ISO 11148-13:2017 手持非电动工具.安全性要求.第13部分:紧固件驱动工具

This document specifies safety requirements for hand-held non-electric power tools (hereinafter referred to as “fastener driving tools”) intended for installation of a fastener (see Annex B), forming a mechanical connection or attachment with the workpiece which are for example wood and woodbased materials, plastic materials, fibre materials (loose or compacted), cementitious materials, metals and combinations of these materials. The fastener driving tools for fasteners can be powered by compressed air or combustible gases (which may be ignited by a battery or accumulator) and the energy is transmitted to an impacted element by an intermediary component that does not leave the device. These tools are intended to be used by one operator and supported by the operator's hand or hands, with or without a suspension, e.g. a balancer. This document is applicable to fastener driving tools in which energy is applied to a loaded fastener for the purpose of driving this into a workpiece. This document is not applicable to fastener driving tools in which the energy for driving fasteners is drawn from powder-actuated cartridges, hydraulics or from any type of electrical supply. This document does not deal with special requirements and modifications of hand-held power tools for the purpose of mounting them in a fixture. This document deals with all significant hazards, hazardous situations or hazardous events relevant to fastener driving tools for fasteners when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer, with the exception of the use of power tools in potentially explosive atmospheres. NOTE

Hand-held non-electric power tools - Safety requirements - Part 13: Fastener driving tools

ICS: 25.140.10
CCS: J48
发布: 2017-11-01
实施

JB/T 7172-2016 直柄式气动砂轮机

Straight handle pneumatic grinder

ICS: 25.140.10
CCS: J48
发布: 2016-04-05
实施: 2016-09-01

JB/T 8411-2016 冲击式气扳机

Impact gas trigger

ICS: 25.140.10
CCS: J48
发布: 2016-04-05
实施: 2016-09-01