25.220.01 标准查询与下载

JB/T 10580-2006 热喷涂涂层命名方法

Designation of thermal spraying coatings

GOST R 9.518-2006 腐蚀和老化联合防护系统.安装操作中的暂时性防腐蚀.一般要求

Unified system of corrosion and ageing protection. Temporary corrosion protection during assembling operations. General requirements

GOST R 9.804-2006 腐蚀和老化联合防护系统.产品和材料.啮齿动物造成的稳定性退化的实验室测试方法

Unified system of corrosion and ageing protection. Products and materials. Methods of laboratory testing for the stability in regards to the deterioration by rodents

ASTM B374-06(2011) 电镀的相关标准术语

These definitions correspond to interpretations as applied to electroplating and do not necessarily correspond to the definitions used in other fields.

Standard Terminology Relating to Electroplating

SANS 10322:2005 建筑铝的表面精加工

Gives the selection and maintenance of surface finishes on exterior architectural aluminium. Is intended as a guide for specifiers, designers, installers, building owners and maintenance staff. Covers four types of surface finish, i.e. mill finishes, ano

Surface finishing of architectural aluminium

ANSI C18.1M Part 1-2005 干电池和电池组.规范

Applies to portable primary cells and batteries with aqueous electrolyte and a zinc anode (non-lithium). This edition includes the following electrochemical systems: a) Carbon zinc (LeClanche and zinc chloride types); b) Alkaline manganese dioxide; c) Si

Dry Cells and Batteries - Specifications

DVS 2302-2003 通过热喷涂涂层保护钢和铸铁材料的腐蚀

Protection against corrosion of steel and cast iron materials by thermal spray coatings

AS 3894.9:2003 防护涂层的现场试验．粘附力测定

Site testing of protective coatings - Determination of adhesion

KS W 2025-2003(2008) 定义和飞机不同的金属处理

DEFINITIONS AND OPERATIONS OF DISSIMILAR METALS IN AIRCRAFT

WJ 2607-2003 兵器产品表面化学处理与电化学氧化处理膜层通用规范

本规范规定了兵器产品表面化学处理与电化学氧化处理膜层的要求、质量保证规定等内容。 本规范适用于兵器行业车辆、火炮、枪械、光电仪器、弹箭、引信、火工品等金属产品零、部 (组) 件表面化学处理与电化学氧化处理膜层的制造与验收。

General specifications for surface chemical treatment and electrochemical oxidation films of ordination products

AS 2483:2003 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Specifies sampling plans and procedures for inspection by attributes of electrodeposited metallic coatings. This Standard is an adoption with national modifications and is reproduced from ISO 4519:1980.

Metal finishing - Recommended sampling plans for the inspection and testing of coatings (ISO 4519:1980, MOD)

AS 3894.14:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Inspection report - Daily painting

AS 3894.7:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Determination of surface temperature

AS 3894.8:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Visual determination of gloss

AS 3894.10:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Inspection report - Daily surface and ambient conditions

AS 3894.11:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Equipment report

AS 3894.12:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Inspection report - Coating

AS 3894.13:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Inspection report - Daily

AS 3894.0:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Introduction and list of test methods

AS 3894.1:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Non-conductive coatings - Continuity testing - High voltage ('brush') method