27.190 标准查询与下载

ARP 062-2-2005 农村电气化用小型可再生能源和混合系统的建议．第2部分：从电气化系统的要求到范围

Provides guidance on socio-economic studies to determine the needs for rural electrification systems and provides some structures as technical solutions to such needs. Proposes a range of renewable energy systems.

Recommendations for small renewable energy and hybrid systems for rural electrification Part 2: From requirements to a range of electrification systems

IEC TS 62257-5:2005 农村电气化用小型可再生能源和混合系统的建议.第5部分:电气事故的防护

Specifies the general requirements for the protection of persons and equipment against electrical hazards to be applied in decentralised rural electrification systems. Requirements dealing with protection against electric shock are based on the rules tak

Recommendations for small renewable energy and hybrid systems for rural electrification - Part 5: Protection against electrical hazards

IEC TS 62257-6:2005 农村电气化用小型可再生能源和混合系统的建议.第6部分:验收、操作、维修和替换

Describes the various rules to be applied for acceptance, operation, maintenance and replacement of decentralized rural electrification systems which are designed to supply electric power for sites which are not connected to a large interconnected system

Recommendations for small renewable energy and hybrid systems for rural electrification - Part 6: Acceptance, operation, maintenance and replacement

BS DD IEC/TS 62257-3:2005 农村电气化用小型可再生能源和混合系统的推荐.项目开发和管理

Recommendations for small renewable energy and hybrid systems for rural electrification - Project development and management

IEC TS 62257-3:2004 农村电气化用小型可再生能源和混合系统的建议.第3部分:项目开发和管理

Proposes a framework for project development and management and includes recommended information that should be taken into consideration during all the steps of the electrification project. Also provides information on the responsibilities involved in th

Recommendations for small renewable energy and hybrid systems for rural electrification - Part 3: Project development and management

IEC TS 62257-2:2004 农村电气化用小型可再生能源和混合系统的建议.第2部分:从电气化系统的要求到范围

Proposes a methodological approach for the setting up and carrying out of socio-economic studies as part of the framework of decentralized rural electrification projects. Also provides some structures as technical solutions that could be recommended, dep

Recommendations for small renewable energy and hybrid systems for rural electrification - Part 2: From requirements to a range of electrification systems

SNI 13-6983-2004 执行和报告程序的持续和初步调查

Implementing and reporting procedures of geothermal preliminary and continuation preliminary investigations

SNI 13-6987-2004 地热井流体. 流量测试程序

Geothermal well fluid - Flow test procedures

SNI 13-6677-2002 地热井流体流动测试报告

Reporting of geothermal wells fluid flow test

SNI 13-6605-2001 地热井流体流动的测试方法

Test methods for fluid flow geothermal wells

FprEN ISO 17827-1 固体生物燃料 未压缩燃料颗粒尺寸分布的测定 第1部分：使用孔径为 3.15 毫米及以上的筛子的振荡筛法 (ISO/FDIS 17827-1:2024)

ISO 17827-1:2016 specifies a method for the determination of the size distribution of particulate biofuels by the horizontally oscillating screen method. It applies to particulate uncompressed fuels with a nominal top size of 3,15 mm and above, e.g. wood chips, hog fuel, olive stones, etc. The method is intended to characterize material up to a particle size class of P63. For larger P-classes, the characterization is mainly done by hand sorting.

Solid biofuels - Determination of particle size distribution for uncompressed fuels - Part 1: Oscillating screen method using sieves with apertures of 3,15 mm and above (ISO/FDIS 17827-1:2024)

FprEN ISO 18134-2 固体生物燃料 水分含量的测定 第2部分：简化方法 (ISO/FDIS 18134-2:2023)

ISO 18134-2:2017 describes the method of determining the total moisture content of a test sample of solid biofuels by drying in an oven and is used when the highest precision is not needed, e.g. for routine production control on site. The method described in ISO 18134 (all parts) is applicable to all solid biofuels. The moisture content of solid biofuels (as received) is always reported based on the total mass of the test sample (wet basis).

Solid biofuels - Determination of moisture content - Part 2: Simplified method (ISO/FDIS 18134‑2:2023)

FprEN ISO 17827-2 固体生物燃料 未压缩燃料颗粒尺寸分布的测定 第2部分：使用孔径为 3.15 mm 及以下筛子的振动筛法 (ISO/FDIS 17827-2:2024)

ISO 17827-2:2016 specifies a method for the determination of the size distribution of particulate biofuels by the vibrating screen method. The method described is meant for particulate biofuels only, namely, materials that either have been reduced in size, such as most wood fuels, or are physically in a particulate form. This part of ISO 17827 applies to particulate uncompressed fuels with a nominal top size of 3,15 mm and below (e.g. sawdust).

Solid biofuels - Determination of particle size distribution for uncompressed fuels - Part 2: Vibrating screen method using sieves with aperture of 3,15 mm and below (ISO/FDIS 17827-2:2024)

FprEN ISO 17830 固体生物燃料 粉碎颗粒的粒度分布 (ISO/FDIS 17830:2024)

ISO 17830:2016 aims to define the requirements and method used to determine particle size distribution of disintegrated pellets. It is applicable for pellets that fully disintegrate in hot water.

Solid biofuels - Particle size distribution of disintegrated pellets (ISO/FDIS 17830:2024)

prEN ISO 17830 固体生物燃料 分解颗粒的粒度分布（ISO/DIS 17830:2023）

ISO 17830:2016 aims to define the requirements and method used to determine particle size distribution of disintegrated pellets. It is applicable for pellets that fully disintegrate in hot water.

Solid biofuels - Particle size distribution of disintegrated pellets (ISO/DIS 17830:2023)

prEN ISO 17827-1 固体生物燃料 未压缩燃料粒度分布的测定 第1部分：使用孔径为 3.15 毫米及以上的筛子的振动筛法（ISO/DIS 17827-1:2022）

ISO 17827-1:2016 specifies a method for the determination of the size distribution of particulate biofuels by the horizontally oscillating screen method. It applies to particulate uncompressed fuels with a nominal top size of 3,15 mm and above, e.g. wood chips, hog fuel, olive stones, etc. The method is intended to characterize material up to a particle size class of P63. For larger P-classes, the characterization is mainly done by hand sorting.

Solid biofuels - Determination of particle size distribution for uncompressed fuels - Part 1: Oscillating screen method using sieves with apertures of 3,15 mm and above (ISO/DIS 17827-1:2022)

FprEN 16214-3 能源应用生物质的可持续性和温室气体减排标准 原则、标准、指标和验证器 第3部分：与环境方面相关的可持续性标准

This document specifies procedures, criteria and indicators meeting the sustainability criteria of European Commission Directive 2018/EU/2001 (RED II), the recast of the Renewable Energy Directive, for agricultural biomass and forest biomass for energy applications, i.e. biofuels, bioliquids and biomass fuels. This document is applicable to production, cultivation and harvesting of biomass from agricultural land and forest land for biofuels, bioliquids and biomass fuel production.

Sustainability and greenhouse gas emission saving criteria for biomass for energy applications - Principles, criteria, indicators and verifiers - Part 3: Sustainability criteria related to environmental aspects

prEN ISO 17827-2 固体生物燃料 未压缩燃料粒度分布的测定 第2部分：使用孔径为 3.15 毫米及以下的筛子的振动筛法（ISO/DIS 17827-2:2022）

ISO 17827-2:2016 specifies a method for the determination of the size distribution of particulate biofuels by the vibrating screen method. The method described is meant for particulate biofuels only, namely, materials that either have been reduced in size, such as most wood fuels, or are physically in a particulate form. This part of ISO 17827 applies to particulate uncompressed fuels with a nominal top size of 3,15 mm and below (e.g. sawdust).

Solid biofuels - Determination of particle size distribution for uncompressed fuels - Part 2: Vibrating screen method using sieves with aperture of 3,15 mm and below (ISO/DIS 17827-2:2022)

prEN ISO 18134-2 固体生物燃料 水分含量的测定 第2部分：总水分 简化方法（ISO/DIS 18134 :2023）

ISO 18134-2:2017 describes the method of determining the total moisture content of a test sample of solid biofuels by drying in an oven and is used when the highest precision is not needed, e.g. for routine production control on site. The method described in ISO 18134 (all parts) is applicable to all solid biofuels. The moisture content of solid biofuels (as received) is always reported based on the total mass of the test sample (wet basis).

Solid biofuels - Determination of moisture content - Part 2: Total moisture - Simplified method (ISO/DIS 18134‑2:2023)

FprEN ISO 18134-3 固体生物燃料 水分含量的测定 第3部分：一般分析样品中的水分（ISO/FDIS 18134-3:2023）

ISO 18134-3:2015 describes the method of determining the moisture in the analysis test sample by drying in an oven. It is intended to be used for general analysis samples in accordance with EN 14780. The method described in this part of ISO 18134-3:2015 is applicable to all solid biofuels. The moisture content of solid biofuels (as received) is always reported based on the total mass of the test sample (wet basis). Since biofuels in small particle size are very hygroscopic, their moisture content will change with humidity in the atmosphere and therefore, the moisture of the test portion is determined simultaneously with determination of for example calorific value, carbon content, and nitrogen content. NOTE The term moisture content when used with biomass materials can be misleading since untreated biomass frequently contains varying amounts of volatile compounds (extractives) which can evaporate when determining the moisture content by oven drying (see References [1] and [2]).

Solid biofuels - Determination of moisture content - Part 3: Moisture in general analysis sample (ISO/FDIS 18134-3:2023)