29.035.50 云母基材料 标准查询与下载

GB/T 5019.13-2023 以云母为基的绝缘材料 第13部分：高导热性玻璃布补强少胶云母带

Mica-based insulation materials Part 13: High thermal conductivity glass cloth reinforced low-adhesive mica tape

GB/T 5019.5-2023 以云母为基的绝缘材料 第5部分：电热设备用硬质云母板

Mica-based insulating materials Part 5: Rigid mica sheets for electric heating equipment

GB/T 5019.10-2022 以云母为基的绝缘材料 第10部分：耐火安全电缆用云母带

本文件规定了由无碱玻璃纤维布/塑料薄膜补强和云母纸经合适树脂粘合而成的耐火安全电缆用云母带(以下简称“耐火云母带”)的型号、要求、试验方法、检验规则、标志、包装、运输及贮存。 本文件适用于着火后仍能继续运行的电缆用耐火云母带,其标称厚度从0.10 mm 至0.20 mm,以

Specification for insulating materials based on mica—Part 10：Mica paper tapes for flame-resistant security cables

GB/T 5019.12-2017 以云母为基的绝缘材料 第12部分：高透气性玻璃布补强环氧少胶云母带

Specification for insulating materials based on mica— Part 12：Glass fabric backup epoxy dry mica tape with high porosity

GB/T 5019.5-2014 以云母为基的绝缘材料 第5部分:电热设备用云母板

GB/T 5019的本部分规定了以剥片云母或云母纸为基的电热设备用云母板的分类、要求、供货形式和标志。本部分适用于用剥片云母或云母纸以合适的胶粘剂粘合而成的云母板。

Insulating materials based on mica.Part 5:Rigid mica materials for heating equipment

GB/T 5019.4-2009 以云母为基的绝缘材料.第4部分:云母纸

GB/T 5019的本部分规定了云母纸的分类、要求、供货及标志、试验方法。 本部分适用于电气绝缘用云母纸。

Specification for insulating materials based on mica.Part 4:Mica paper

GB/T 5019.3-2009 以云母为基的绝缘材料.第3部分:换向器隔板和材料

GB/T 5019的本部分适用于换向器隔板用的以剥片云母或云母纸为基材的硬质材料。 这些产品由白云母片或金云母片或云母纸用合适的粘合剂的粘结而成。其供货形式如下： －以压制而成或经切边后的尺寸供应的片材； －由片材切成的条； －符合用户订货条件中的形状和尺寸的换向器隔板。 产品的标称厚度为0.3mm～2.0mm。

Specification for insulating materials based on mica.Part 3:Commutator separators and materials

GB/T 5019.1-2009 以云母为基的绝缘材料.第1部分:定义和一般要求

GB/T 5019的本部分给出了粘合云母材料、以粘合云母材料为基的产品和云母纸等的定义、一般要求和供货条件。 本部分适用于以云母为基的绝缘材料。

Specification for insulating materials based on mica.Part 1:Definitions and general requirements

GB/T 5019.2-2009 以云母为基的绝缘材料.第2部分:试验方法

GB/T 5019的本部分规定了粘合云母材料、以粘合云母材料为基的产品和云母纸的试验方法。 本部分适用于有关电气设备用、由粘合云母或云母纸、带或不带补强材料粘合而成的绝缘材料，并适用于云母纸。

Specification for insulating materials based on mica.Part 2:Methods of test

GB/T 5019-2002 以云母为基的绝缘材料 试验方法

本标准规定了粘合云母材料、以粘合云母材料为基的产品及云母纸的试验方法。 本标准适用于有关电气设备用、由剥片云母或云母纸、带或不带补强材料粘合而成的绝缘材料，并适用于云母纸。

Insulating materials based on mica Methods of test

GB/T 5020-2002 以云母为基的绝缘材料 定义和一般要求

本标准给出了粘合云母材料、以粘合云母材料为基的产品和云母纸等术语的定义、一般要求和供货条件。

Insulating materials based on mica Definitions and general requirements

GB/T 5021-2002 换向器隔板和材料

本标准适用于换向器隔板用的以剥片云母或云母纸为基材的硬质材料。这些产品由白云母或金云母片或云母纸用合适的粘合剂粘结而成。其供货形式如下：——以压制或经切边后的尺寸供应的片材。——由片材切成的条状供货。——符合使用者订货条件中的形状和尺寸的换向器隔板。产品的标称厚度为(0．3～2)mm。

Commutator separators and materials

ASTM D1677-17(2024) 电绝缘用未经处理的云母纸取样和试验的标准试验方法

Standard Test Methods for Sampling and Testing Untreated Mica Paper Used for Electrical Insulation

KS C IEC 60371-3-4-2024 云母基绝缘材料规范第3部分:单项材料规范活页4:带B级环氧树脂粘合剂的聚酯薄膜背衬云母纸

Specification for insulating materials based on mica — Part 3: Specifications for individual materials — Sheet 4: Polyester film-backed mica paper with a B-stage epoxy resin binder

ASTM D352-23 电绝缘用糊状云母的标准试验方法

1.1  These test methods cover the testing of bonded mica splittings and bonded mica paper to be used for commutator insulation, hot molding, heater plates, and other similar insulating purposes. 1.2  These test methods appear in the following sections: Test Sections Compressive Creep 4 – 10 Dielectric Strength 38 – 41 Mica or Binder Content 19 Molding Test 31 – 36 Organic Binder 20 – 24 Resistivity 42 – 46 Silicone Binder 25 – 30 Stability Under Heat and Pressure 11 – 18 1.3  The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 40.1 and 45.1 for specific hazard statements. 1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Methods for Pasted Mica Used in Electrical Insulation

ASTM D1039-16(2022) 电绝缘用玻璃粘结云母的标准试验方法

1.1 These test methods cover the evaluation of the characteristics of glass-bonded, natural, or synthetic mica materials intended for use as electrical insulation. 1.2 Glass bonded mica materials are commercially available in both injection molded and compression molded types. These test methods are applicable to both types except for tensile strength methods. (See Section 41.) 1.3 The test methods appear in the following sections: Test Method Section ASTM Test Method Arc Resistance 57 – 59 D495 Compressive Strength 33 – 35 D695 Conditioning 5 D618 Dielectric Strength 48 – 51 D149 Dissipation Factor 43 – 47 D150 and D2149 Heat Distortion Temperature 24 – 29 D648 Impact Resistance 36 – 39 D256 Modulus of Rupture 30 – 32 D790 and C674 Permittivity 43 – 47 D150 and D2149 Porosity 13 – 16 D116 Resistivity, Volume and Surface 52 – 56 D257 Rockwell Hardness 10 – 12 D785 Specific Gravity 6 – 9 D792 Specimens 4 Tensile Strength 40 – 42 D638 and D651 Terminology 3 D1711 Thermal Conductivity 17 – 19 C177 and E1225 Thermal Expansion 20 – 23 E228 and E289 Thickness 49 and 54 D374 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See also Sections 45, 49, 54, and 58. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Methods for Glass-Bonded Mica Used as Electrical Insulation

KS C IEC 60371-3-9-2019 云母绝缘材料 第3部分：单个材料的规范 表 9：模压云母石

Insulating materials based on mica — Part 3: Specifications for individual materials — Sheet 9: Moulding micanite

KS C IEC 60371-3-1-2019 云母绝缘材料规范 第3部分：单个材料的规范 表 1：换向器隔板和材料

Specification for insulating materials based on mica — Part 3: Specifications for individual materials — Sheet 1: Commutator separators and materials

T/CBMF 69*T/CNMMIA 02-2019 合成云母粉

本标准规定了合成云母粉的术语和定义、分类和标记、要求、试验方法、检验规则以及标志、包装、运输和贮存。 本标准适用于以合成云母为原料加工而成的云母粉。

Synthetic mica powder

T/CBMF 68*T/CNMMI A01-2019 合成云母

本标准规定了合成云母的规格和标记、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于以天然矿产原料和部分化工原料经高温熔融、冷却析晶而制得的合成云母。

Synthetic mica