共找到 68 条与 绝缘流体综合 相关的标准,共 5 页
本标准规定了测定绝缘液体氧指数的试验方法。本方法通常被认为是评述产品燃烧特性的方法之一。 本标准适用于温度在(40±2)℃时粘度不大于50m㎡/s的各种液体。 注:必要时,应对测定粘度的试验方法作出说明。
Test method for the determination of oxygen index of insulation liquids
This International Standard describes a method for the simultaneous measurement of conductance (G) and capacitance (C) enabling the calculation of the dielectric dissipation factor (tan delta) of insulating liquids. The proposed method applies both to unused insulating liquids and insulating liquids in service in transformers and in other electrical equipment. The standard is no substitute for IEC 60247; rather it complements it insofar as it is particularly suited to highly insulating liquids and it recommends a method of measurement for these liquids. This method allows values of the dielectric dissipation faxtor as low as 0,0000001(10-6) at power frequen
Insulating liquids - Determination of the dielectric dissipation factor by measurement of the conductance and capacitance - Test method
Insulating liquids. Determination of the dielectric dissipation factor by measurement of the conductance and capacitance. Test method.
This International Standard describes a method for the simultaneous measurement of conductance G and capacitance C enabling the calculation of the dielectric dissipation factor tan δ of insulating liquids. The proposed method applies both to unused insulating liquids and insulating liquids in service in transformers and in other electrical equipment. The standard is no substitute for IEC 60247; rather it complements it insofar as it is particularly suited to highly insulating liquids and it recommends a method of measurement for these liquids. This method allows values of the dielectric dissipation factor as low as 10 at power frequency to be determined with certainty. Moreover, the range of measurements of tan δ lies between 10 and 1 and can be extended up to 200 in particular conditions.
Insulating liquids. Determination of the dielectric dissipation factor by measurement of the conductance and capacitance. Test method
This standard describes two procedures each using different apparatus to measure the tendency of insulating liquids to evolve or absorb gas when subjected, in cells having specific geometries, to electrical stress of sufficient intensity to cause an electric discharge through a gas phase in which a gas-oil interface is located.
Gassing of insulating liquids under electrical stress and ionization
本标准介绍了一种测量绝缘液体的介质损耗因数tanδ的方法,该方法通过同步测量电导G和电容 C后经换算得到tanδ,本标准适用于未使用过的绝缘液体和运行中的变压器或其他电力设备中使用的 绝缘液体。 尽管本标准适用于GB/T 5654—2007中提到的所有液体,甚至是高绝缘性能液体,但该标准并不 能替代GB/T 5654—2007。本方法可以在工频下准确的测量小到10的介质损耗因数,其测量范围为 10到l之间,特殊条件下可以达到200。
Insulating liquids - Determination of dielectric dissipation factor by measurement of the conductance and capacitance - Test method
This International Standard specifies a method for the determination of polychlorinated biphenyl (PCB) concentration in non-halogenated insulating liquids by high-resolution capillary column gas chromatography using an electron capture detector (ECD).
Insulating liquids - Contamination by polychlorinated biphenyls (PCBs) - Methods of determination by capillary column gas chromatography
This International Standard specifies the method for determining the dielectric breakdown voltage of insulating liquids at power frequency. The test portion, contained in a specified apparatus, is subjected to an increasing a.c. electrical field by means of a constant rate of voltage rise until breakdown occurs. The method applies to all types of insulating liquids of nominal viscosity up to 350 mm2s-1 at 40 °C.
Insulating liquids - Determination of the breakdown voltage at power frequency - Test method
Applies to all insulating liquids, used and unused, the kinematic viscosity of which is lower than or equal to 300 mm2/s at 40° C.
Insulating liquids - Linear flame propagation - Test method using a glass-fibre tape
Recommends standard tests and evaluation procedures for silicone transformer fluid
Guide for Acceptance of Silicone Insulating Fluid and Its Maintenance in Transformers
This standard describes a method for measuring the oxygen index of insulating liquids. This test method is applicable to all liquids, the viscosity of which is lower than or equal to 50 mm2/S at 40 C +/- 1 C.
Test method for determination of oxygen index of insulating liquids
The standard defines a system for classifying insulating liquids according to firepoint and net calorific value. The characteristics on which the system is based are given together with limiting values.
Classification of insulating liquids according to fire point and net calorific value
Guide for the sampling of gases and of oil from oil-filled electrical equipment and for the analysis of free and dissolved gases
Methods of measurement for the refractive index and specific dispersion of electrical insulating fluid
Method for determining volume resistivity of insulating oil
Method of test for refractive index and specific dispersion of electrically insulating liquid
Настоящий стандарт устанавливает методы отбора проб жидких диэлектриков из нефтяного или растительного сырья, а также синтетических, име
Liqyid dielectrics. Sampling
Conductivity of electrical copper material
Conductivity of electrical copper material
Measurement of relative permittivity dielectric dissipation factor and D.C. Resistivity of insulating liquids.
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号