共找到 176 条与 电工器件 相关的标准,共 12 页
Note: In order to maintain a consistent relationship between Clause numbers and subject matter throughout this Standard, some numbers may have been omitted. 1. Scope 1.1 This Standard applies to panelboards and enclosed panelboards, rated 600 V and less, for use in nonhazardous locations in accordance with the Rules of the Canadian Electrical Code, Part I, to provide overcurrent protection for a number of circuits. 1.2 Clauses 1 to 6 apply to panelboards and enclosed panelboards of other than the service entrance type and apply, unless otherwise noted, to the panelboards covered by Clauses 7 and 8 as follows: (a) Clause 7 - Panelboards for service entrance use; and (b) Clause 8 - Custom-built panelboard assemblies. 1.3 This Standard covers the construction of the synthetic fuses to be used in the simulated load cycle test on fusible panelboar ds (see Clause 9).
Panelboards and Enclosed Panelboards
1. Scope This Standard applies to (a) electrode receptacles and fittings for mounting gas tubes intended for indoor and outdoor applications operating at voltages of 15 000 V and less but not exceeding 7 500 V to ground for use in accordance with the rules of the Canadian Electrical Code, Part I; (b) connectors that are intended to enclose the ends of gas tube electrodes and to provide a connection to the secondary voltage supply.
Electrode Receptacles, Fittings, and Connectors for Gas Tubes
Cable connector and cable welding
AN-1 and AN-2 button type protecting device
AN-3 button type protecting device
Large connector for cut edge of electrical wire
Panelboards and Enclosed Panelboards
Thin slice for electric fuse clamp
Thin slice for electric fuse protecting device
Electrode Receptacles for Luminous Tube-Signs
Liner disc connector of wave-proof sleeve for conductor
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号