29.120.20 连接装置 标准查询与下载
共找到 913 条与 连接装置 相关的标准，共 61 页
Replacement: This International Standard applies to twist-on connecting devices for connecting two or more unprepared rigid and/or flexible copper conductors having a cross-sectional area of 0,5 mm2 up to and including 16 mm2 and complying with IEC 60228, the total cross-sectional area of the connected conductors not exceeding 35 mm2. It covers low voltage circuits up to 1 000 V a.c. and 1 500 V d.c. where electrical energy is utilized for household and similar purposes. This standard covers TOCDs primarily designed for application by hand. However, certain TOCDs, for example for large cross-sections, may require the use of a tool designed for that particular TOCD. NOTE In the UK, TOCDs must also be suitable for connecting 2 or more unprepared flexible cables, including a flexible cable having a cross sectional area of 1,25 mm2 complying with BS 6500. Wires and cables in the USA do not presently comply to IEC 60228.
Connecting devices for low-voltage circuits for household and similar purposes - Part 2-4: Particular requirements for twist-on connecting devices
- ICS
- 29.120.20
- CCS
- 发布
- 2014-12-25
- 实施
General rules for fittings of metal conduits and underfloor ducts
- ICS
- 29.120.20
- CCS
- 发布
- 2014-10-27
- 实施
이 표준은 KS C 8401, KS C 8422 및 KS C 8425에 사용되는 금속제 전선관류의 부속품(이하 부속품이라 한다.)의 일반사항에 대하여 규정한다.
General rules for fittings of metal conduits and underfloor ducts
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-10-27
- 实施
- 2014/10/27
Connecting devices — Flat quick-connect terminations for electrical copper conductors — Safety requirements
- ICS
- 29.120.20
- CCS
- 发布
- 2014-10-27
- 实施
- 2014/10/27
Appliance couplers for household and similar general purposes — Part 2-4: Couplers dependent on appliance weight for engagement
- ICS
- 29.120.20
- CCS
- Y60
- 发布
- 2014-10-27
- 实施
- 2014/10/27
Connecting devices — Flat quick-connect terminations for electrical copper conductors — Safety requirements
- ICS
- 29.120.20
- CCS
- 发布
- 2014-10-27
- 实施
Appliance couplers for household and similar general purposes — Part 2-4: Couplers dependent on appliance weight for engagement
- ICS
- 29.120.20
- CCS
- 发布
- 2014-10-27
- 实施
이 표준은 KS C IEC 60228에 적합한 경질(단선 또는 연선) 또는 유연성 전선 연결 장치용 나사형 및 꽂음형 전선 커넥터에 적용한다. 전선의 공칭 단면적은 0.2 mm2 이상 35 mm2 이하이며, 이에 상응하는 AWG 크기로 한다. 1 000 Hz 이하의 주파수에서는 정격 전압이 교류 1 000 V 이하, 직류 1 500 V 이하이다.이 표준은 미처리 도체를 연결하는 데 적합한 전선 커넥터에 적용한다.이 표준은 아래와 같은 전선 커넥터에는 적용하지 않는다.a) 주름관 또는 납땜 연결용 전선 커넥터b) 데이터 및 신호 회로용c) IEC 61210[3]1), KS C IEC 60998-2-3[1] 및 KS C IEC 60998-2-4[2]에 각각 적용되는 평형 급속-접속 종단, 절연 관통형 전선 커넥터 및 트위스트형 전선 커넥터?
Connecting devices — Electrical copper conductors — Safety requirements for screw-type and screwless-type clamping units — Part 1: General requirements and particular requirements for clamping units for conductors from 0.2 mm2 up to 35 mm2(included)
- ICS
- 29.120.20
- CCS
- 发布
- 2014-09-26
- 实施
- 2014/9/26
Connecting devices — Electrical copper conductors — Safety requirements for screw-type and screwless-type clamping units — Part 1: General requirements and particular requirements for clamping units f
- ICS
- 29.120.20
- CCS
- 发布
- 2014-09-26
- 实施
JB/T 8443的本部分规定了铜铬触头材料中铬含量的测定方法。本部分适用于铜铬触头材料中铬含量的测定。测定质量分数范围:20.00%~55.00%。
Test methods for chemical analysis of copper-chromium electric contact material.Part 1: Determination of chromium content
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 4107本部分规定了采用重铬酸钾法测定银铁电触头材料中铁含量的方法。本部分适用于银铁电触头材料中铁含量的测定。测定质量分数范围:5.00%~10.00%。
Chemical analyse method for electrical contact materials.Part 6: Determine iron content in the silver-iron
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 8443的本标准规定了铜铬触头材料中铜含量的测定方法。本标准适用于铜铬触头材料中铜含量的测定。测定质量分数范围:45.00%~80.00%。
Test methods for chemical analysis of copper-chromium electric contact material.Part 2: Determination of chromium content
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 4107的本部分规定了电触头材料化学分析方法的总则及一般规定。本部分适用于电触头材料化学分析方法,在制(修)订电触头材料化学分析方法标准时也应遵守本部分。
Chemical analyse method for electrical contact materials.Part 1: General and ordinary specification
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 4107的本部分规定了采用碘量法测定铜钨电触头材料中铜含量的方法。本部分适用于铜钨电触头材料中铜含量的测定。测定质量分数范围:15.00%~45.00%。
Chemical analyse method for electrical contact materials.Part 2: Determination of copper content in the copper tungsten
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 4107的本部分规定了采用气体容量法测定银石墨电触头材料中碳含量的方法。本部分适用于银石墨电触头材料中碳含量的测定。测定质量分数范围:3.00%~6.00%。
Chemical analyse method for electrical contact materials.Part 3: Determination of carbon content in the silver-graphite
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 4107的本部分规定了采用碘量法测定银钨电触头材料中银含量的方法。本部分适用于银钨电触材料中银含量的测定。测定质量分数范围:25.00%~75.00%。
Chemical analyse method for electrical contact materials.Part 4: Determination of silver content in the silver-tungsten
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
本标准规定了复合双金属材料和复合电触头材料成分的半定量和定性测定方法。本标准适用于复合双金属材料中除C、O等轻元素外的各元素(质量分数>0.1%)成分测定。本标准适用于复合电触头材料的定性测定以及主元素的半定量分析。本标准适用于以X射线波长分光谱仪进行的定量分析,其主要内容和基本原则也适用于与扫描电镜联用的X射线能谱仪。
Quantitative analysis of composition metal.Electron probe microanalysis
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
JB/T 4107的本部分规定了采用EDTA容量法测定银镍电触头材料中镍含量的方法。本部分适用于银镍电触头材料中镍含量的测定。测定质量分数范围:8.00%~35.00%。
Chemical analyse method for electrical contact materials.Part 5: Determination ofnickel content in the silver-nickel
- ICS
- 29.120.20
- CCS
- K14
- 发布
- 2014-07-09
- 实施
- 2014-11-01
Full-tension sleeve for aluminium conductor
- ICS
- 29.120.20
- CCS
- 发布
- 20140615
- 实施
- 20140615
이 표준은 가공 Al 배전선의 내장, 인류개소에서 사용하는 볼트 조임형 인장 클램프(이하 클램프라 한다.) 및 가공 알루미늄선에 장력이 걸리지 않는 장소에서 알루미늄선 상호 간 또는 알루미늄선과 동선을 볼트로 접속하는 부착형 커넥터(이하 커넥터라 한다.)에 대하여 규정한다.?
Deadend clamp and bolt type connector for aluminum
- ICS
- 29.120.20
- CCS
- K43
- 发布
- 2014-06-15
- 实施
- 2014-06-15
