共找到 349 条与 输电网和配电网 相关的标准,共 24 页
Energy and data interfaces of users connected to the smart grid with other smart grid stakeholders - Standardization landscape
Energy and data interfaces of users connected to the smart grid with other smart grid stakeholders - Standardization landscape
Top priority standards development status in the domain of smart energy
Technical specification for anti-galling of overhead transmission lines
Application Principles for Environmental Noise Implementation Standards at Substation Boundary
Technical requirements for low-voltage grid-connected interface devices for distributed photovoltaic power generation
Technical Specifications for Relay Protection Configuration and Setting of High Voltage Reactive Power Compensation Device
Calculation Method for Radio Interference of High Voltage Overhead Transmission Lines
General specification for fiber channel transmission protection information
Calculation method for audible noise of high-voltage AC overhead transmission lines
Measurement method of DC magnetic field in HVDC transmission project
Specifications for traveling wave fault location devices for transmission lines
General technical specifications for power system over-frequency cutting machine and over-frequency de-loading device
Overhead Transmission Line Operation Regulations
Specifications for single-phase grounding capacitance current inspection of mine high-voltage power grids
220kV Substation Load Transfer Equipment Technical Specifications
Technical specifications for relay protection configuration and setting of ultra-high voltage controllable shunt reactor
Generic smart grid requirements - Part 1: Specific application of the Use Case methodology for defining generic smart grid requirements according to the IEC systems approach
IEC 61643-31:2018 is applicable to Surge Protective Devices (SPDs), intended for surge protection against indirect and direct effects of lightning or other transient overvoltages. These devices are designed to be connected to the DC side of photovoltaic installations rated up to 1 500 V DC. These devices contain at least one non-linear component and are intended to limit surge voltages and divert surge currents. Performance characteristics, safety requirements, standard methods for testing and ratings are established. SPDs complying with this standard are exclusively dedicated to be installed on the DC side of photovoltaic generators and the DC side of inverters. SPDs for PV systems with energy storage (e.g. batteries, capacitor banks) are not covered. SPDs with separate input and output terminals that contain specific series impedance between these terminal(s) (so called two-port SPDs according to IEC 61643-11:2011) are not covered. SPDs compliant with this standard are designed to be permanently connected where connection and disconnection of fixed SPDs can only be done using a tool. This standard does not apply to portable SPDs Keywords: photovoltaic installations, lightning or other transient overvoltages
Low-voltage surge protective devices - Part 31: Requirements and test methods for SPDs for photovoltaic installations
Technical conditions of sulfur hexafluoride detector - decomposition product detector
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号