29.240.10 标准查询与下载

DS/EN 60099-4/A1:2007 电涌放电器 第4部分：用于交流系统的无间隙金属氧化物电涌放电器

Applies to non-linear metal-oxide resistor type surge arresters without spark gaps designed to limit voltage surges on a.c. power circuits.

Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems

JB/T 10695-2007 低压无功功率动态补偿装置

本标准规定了低压无功功率动态补偿装置的术语和定义、分类与基本参数、正常使用条件、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于额定电压交流不超过1000V，频率不超过1000Hz，投切时间不大于２s的低压无功功率动态补偿装置（以下简称装置）。

Low-voltage reactive power dynamic compensation equipments

JB/T 8754-2007 高压开关设备和控制设备型号编制办法

本标准规定了高压开关设备和控制设备及其成套装置、熔断器、封闭母线及其配套设备的型号命名原则、组成及编制方法。 本标准适用于额定电压3.6kV及以上的高压开关设备和控制设备及其配套设备，亦适用于高压/低压预装式变电站等隶属于高压开关行业统一管理的设备。 包括： ——高压交流断路器（简称断路器）； ——高压交流隔离开关（简称隔离开关）； ——高压交流负荷开关（简称负荷开关）； ——高压交流接地开关（简称接地开关）； ——高压交流接触器（简称接触器）； ——高压交流自动重合器（简称重合器）； ——高压交流自动分段器（简称分段器）； ——高压交流熔断器（简称熔断器）； ——高压交流负荷开关—熔断器组合电器（简称负荷开关—熔断器组合）； ——高压交流接触器—熔断器组合电器（简称接触器—熔断器组合）； ——交流金属封闭开关设备和控制设备； ——高压/低压预装式变电站（简称预装式变电站）； ——气体绝缘金属封闭开关设备（封闭式组合电器）（GIS）； ——复合式组合电器（H-GIS）； ——敞开式组合电器（C-AIS）； ——气体绝缘金属封闭刚性输电线路（GIL）； ——金属封闭母线； ——电缆分接箱等； ——操动机构； ——真空灭弧室； ——配套设备。

Organization of the types of high-voltage switchgear and controlgear

IEEE Std C57.12.36-2007 液浸式配电变压器要求

This standard covers certain electrical, dimensional, and mechanical characteristics of 50 Hz and 60 Hz, two winding, liquid-immersed distribution substation transformers. Such transformers may be remotely or integrally associated with either primary and secondary switchgear or substations, or both, for step-down or step-up purposes rated as follows: a) 112.5 kVA through 10 000 kVA three-phase b) 250 kVA through 6667 kVA single-phase c) High voltage 69 000 V and below and low voltage 34 500 V and below It is not intended that this standard shall apply to dry-type, regulating, pad-mounted, secondary-network, furnace, rectifier, mobile, railway, or mine transformers.

Requirements for liquid-immersed distribution substation transformers

DL/T 1036-2006 变电设备巡检系统

本标准规定了变电设备巡检系统的建设原则、架构、使用流程、功能和巡检终端设备配置要求。 本标准适用于变电设备巡检系统的设计、建设、验收和应用。

Patrol system for power transformation facilities

NF C65-101/A1:2006 电涌放电器.第4部分:交流电系统用无火花隙的金属氧化物电涌放电器

Surge arresters - Part 4 : metal-oxide surge arresters without gaps for a.c. systems.

BS DD CLC/TS 61643-12:2006 低压电涌保护装置.连接到低压配电系统的电涌保护装置.选择和应用原则

This part of IEC 61643 describes the principles for selection, operation, location and co-ordination of SPDs to be connected to 50 Hz to 60 Hz a.c. power circuits and equipment rated up to 1 000 V r.m.s.. NOTE 1 This technical specification deals only with SPDs and not with SPDs components integrated inside equipment.

Low-voltage surge protective devices - Surge protective devices connected to low-voltage power systems - Selection and application principles

DS/CLC/TS 61643-22:2006 低压电涌保护器《第22部分：连接到电信和信号网络的电涌保护器》选用和应用原则

This TS 61643-22 describes the principles for the selection, operation, location and coordination of SPDs connected to telecommunication and signalling networks with nominal system voltages up to 1 000 V r.m.s. a.c. and 1 500 V d.c. This TS also addresses SPDs that incorporate protection for signalling lines and power lines in the same enclosure.

Low-voltage surge protective devices – Part 22: Surge protective devices connected to telecommunications and signalling networks – Selection and application principles

SANS 61643-1:2006 低压电涌保护设备.第1部分:连接到低压配电系统上的电涌保护装置.要求及测试

Applies to devices for surge protection against indirect and direct effects of lightning or other transient overvoltages. These devices are packaged to be connected to 50/60 Hz a.c. and d.c. power circuits, and equipment rated up to 1 000 V r.m.s. or 1 500 V d.c.

Low-voltage surge protective devices Part 1: Surge protective devices connected to low-voltage power distribution systems - Requirements and tests

IEC 60099-4:2004+AMD1:2006 CSV 电涌放电器第4部分:交流系统用无间隙金属氧化物电涌放电器

Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems

ANSI/IEEE 1267:2005 指定承包变电站项目规范的指南

The technical requirements to engineer, design, specify, fabricate, manufacture, furnish, install, test, commission, and provide as-built documents for air-insulated substations are covered.

Guide for Development of Specification for Turnkey Substation Projects

IEEE 1427-2006 空气绝缘电力变电站推荐电间隙和绝缘水平用指南

Covering three-phase ac systems from 1kV to 800 kV, provides recommended electrical operating and safety clearances and insulation levels in air-insulated electric supply substation; addresses insulation coordination procedures; provides design procedures for the selection and coordination of the insulation levels within the station as they relate to substation clearances; and addresses how reduced clearances in high-voltage ac substations will allow for compact bus arrangements and substation voltage uprating applications

Guide for Recommended Electrical Clearances and Insulation Levels in Air-Insulated Electrical Power Substations

DL/T 969-2005 变电站运行导则

本导则规定了变电运行值班人员及相关专业人员进行设备运行、操作、异常及故障处理的行业准则。 本导则适用于交流35kV及以上电压等级的变电站（含发电厂升压站）及监控中心。

Guideline of Substtion Operation

ANSI/IEEE 1268:2005 变电所移动设备的安全安装指南

Establishes general transport, set-up, and installation guidelines for the safe use of mobile substation equipment. Identifies specific areas of concern and offers design assistance in those areas.

Guide for the Safe Installation of Mobile Substation Equipment

DS/EN 60099-4:2005 电涌放电器 第4部分：用于交流系统的无间隙金属氧化物电涌放电器

This International Standard applies to non-linear metal-oxide resistor type surge arresters without spark gaps designed to limit voltage surges on a.c. power circuits.

Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems

SANS 60099-6:2005 电涌放电器．第6部分：额定电压为52 kV或更低的包括串联和并联间隙结构的电涌放电器

Specifies requirements and tests for metal-oxide surge arresters with internal series gaps, with rated voltages 52kV and below. Applies to non-linear metal-oxide resistor type surge arresters with spark gaps designed to limit voltage surges on a.c. power

Surge arresters Part 6: Surge arresters containing both series and parallel gapped structures - Rated 52 kV and less

NF C65-101:2005 避雷器.第4部分:交流电系统用无间隙金属氧化物避雷器

Surge arresters - Part 4 : metal-oxide surge arresters without gaps for a.c. systems.

BS EN 60099-4:2004 避雷器.交流电系统用无间隙金属氧化物避雷器

This part of IEC 60099 applies to non-linear metal-oxide resistor type surge arresters without spark gaps designed to limit voltage surges on a.c. power circuits.

Surge arresters - Metal-oxide surge arresters without gaps for a.c. systems

IEEE 1646-2004 变电站自动化用通信传送时间性能要求

Defines communication delivery times of information to be exchanged within and external to substation integrated protection, control, and data acquisition systems

Standard Communication Delivery Time Performance Requirements for Electric Power Substation Automation

JIS C 4620:2004 组合式高压电力接收装置

この規格は，需要家が電気事業者から受電するために用いるキュービクル式高圧受電設備(以下,キュービクルという。)で，公称電圧6.6kV，周彼数50Hz又は60 Hzで系統短絡電流12.5 kA以下の回路に用いる受電設備容量4000kVA以下のキュービクルについて規定する。

Cubicle type high voltage power receiving units