29.240.10 标准查询与下载

NF C65-101:1993 电涌放电器.第4部分:交流电系统用无火花隙氧化金属电涌放电器

Surge arresters. Part 4 : metal-oxyde surge arresters without gaps for A.C. systems.

IEEE Std C62.11-1993 交流电源电路金属氧化物电涌放电器

Metal-oxide surge arresters for alternating current power circuits

JIS C 4620:1992 组合式高压配电设备

Cubicle type high voltage power receiving units

IEEE Std C62.22-1991 交流系统中金属氧化物电涌放电器应用指南

Guide for the application of metal-oxide surge arresters for alternating-current systems

BS 7354:1990 高压敞开式接线站设计实用规程

1 General This British Standard gives recommendations for the design of high-voltage open-terminal stations. This standard does not cover equipment included in installations for which separate standards exist. Such equipment should comply with the relevant separate standards. Some relevant British Standards are listed in table 1. 2 International practice Both UK and international practice concerning clearances are included in section 5. International practice is included to allow this standard to be applied to installations designed in the UK for construction overseas. See also note 1 to 1.3. NOTE. The titles of the publications referred to in this standard are listed on the inside back cover. (See also table 1.)

Code of practice for design of high-voltage open-terminal stations

CAN/CSA-C233.1-1987(C2004) 用于交流网络的金属氧化物可变电阻避雷器 无火花隙

1. Domaine d'application 1.1 Cette norme ne s'applique qu'aux parafoudres à résistance variable en oxyde métallique montés séparément et à ceux qui sont intégrés à un appareil quelconque. Ces dispositifs sont destinés à limiter les pointes de tension dans les circuits à 50 ou 60 Hz en laissant passer le courant de décharge sans couper l'alimentation. 1.2 Les valeurs données en unités SI (métriques) sont la norme. Les valeurs entre parenthèses ne sont données qu'à titre indicatif.

Variable resistance surge arresters in metal oxide, without spark gap, for alternating current networks

IEEE Std C62.2-1989 用于交流电系统的间隙碳化硅避雷器应用的 IEEE 指南

IEEE Guide for the Application of Gapped Silicon-Carbide Surge Arresters for Alternating Current Systems

IEEE Std C62.1-1989 交流电源电路气隙式碳化硅电涌放电器

Gapped silicon-carbide surge arresters for ac power circuits

CSN 33 3265-1988 控制室电量和电力分配的测量标准

Zpracovatel a oborové normaliza?ní st?edisko: Energoprojekt, p.i.o Praha — ing. Ivan Bene?, ing. Jaroslav Bárta Pracovník ú?adu pro normalizaci a mě?ení: — ing. Michal K?í?

Electric-engineering rules. Measurement of electrical quantities in control room and electric distribution networks

CAN/CSA-C233.1-1987(R2004) 用于交流系统的无间隙金属氧化物避雷器

1. Scope 1.1 This Standard applies only to gapless metal oxide surge arresters of separate mounting or those supplied integrally with other equipment. The surge arresters are designed to limit voltage surges in 50 or 60 Hz alternating current power circuits by passing surge discharge current without causing power interruption. 1.2 The values given in SI (metric) units are the standard. The values given in parentheses are for information only.

Gapless Metal Oxide Surge Arresters for Alternating Current Systems

CSN 33 3240-1987 电工学规则．户内及户外变压器的安装

Zpracovatel: Energoprojekt p.i.o — Ing. Ka?párek — Ing. Ho?ovsk? Oborové normaliza?ní st?edisko: Energoprojekt — Ji?í Beránek Pracovník ??adu pro normalizaci a mě?ení: Ing. M. K?í?

Electric-engineering rules. Installation of indoor and outdoor power transformers

ANSI C92.2-1987 标称工作电压大于230kV的交流电气系统和设备用电力系统.首选电压额定值

This standard provides preferred voltage ratingsabove 230 kV nominal for alternating-currentsystems and equipment.

Power systems; alternating-current electrical systems and equipment operating at voltages above 230 kV nominal; preferred voltage ratings

IEEE Std C62.2-1987 交流系统气隙式碳化硅电涌放电器应用指南

This standard covers the application of gapped silicon-carbide surge arresters (see ANSI/IEEE Std C62.1-1984 [1]) 1 to safeguard electric power equipment against the hazards of abnormally high voltage surges of various origins. Such overvoltages may cause ?ash-overs and serious damage to equipment, thereby jeopardizing the supply of power to users. It is essential to prevent this by the proper coordination of surge protective devices with the insulation strength of the protected equipment. The subject is a broad one with many rami?cations, and it would require a volume of considerable bulk to explain all possible cases in detail. Section 3 of this standard covers the basic cases for stations used to supply and switch electric power transmission, subtransmission, or distribution feeders. Information is included in Section 4 on application of arresters for protection of overhead distribution systems, both open-wire and spacer cable; underground system cables; all distribution transformers; and other electric distribution equipment. Step-by-step directions toward proper solutions for various applications are provided. For many cases the prescribed steps are adequate. Complex situations or special situations requiring study by experienced engineers are described, but speci?c solutions may not be given. These procedures are based on theoretical studies, test results, and experience.

Guide for the Application of Gapped Silicon-Carbide Surge Arresters for Alternating Current Systems

CSN 38 0810-1986 电气设备过压保护

Zpracovatel: V?zkumn? ústav energetick?, pobo?ka Brno — Ing. Jaroslav Jirk?, ?Sc. Oborové normaliza?ní st?edisko: Energoprojekt, p.i.o. — Ing. Bárta Pracovník ??adu pro normalizaci a mě?ení: Ing. Michal K?í?

Overvoltage protection of electric equipment

CSN 33 3220-1986 电工学规则．变电站的一般工作指导

Zpracovatel: Energoprojekt Praha, p.i.o. Ing. Vladimír Vachek, Oborové normaliza?ní st?edisko odvětví energetiky, Ji?í Beránek Pracovník ?NM: Ing. Michal K?í?

Electric-engineering rules. Common directions for electric substations

CSN 33 3231-1983 电工学规则．处理最高值为52kV电压的三相开关站

Zpracovatel a oborové normaliza?ní st?edisko: ENERGOPRO-JEKT - Ing. Miroslav ? p e 11 í k Pracovník ??adu pro normalizaci a mě?ení - Ing. Michal K?í?

Electric-engineering rules. Three-phase switchyards for voltage to 52 kV

CNS 9090-1982 柜式高压受电设备

本标准适用于标称电压 6.6 kv 受电容量 500 Kva 以下，系统知路容量 150MVA 以下柜式高压受电设备（以下简称受电设备）。

Cubicle Type High Voltage Power Receiving Unit

CSN 33 3230-1982 52 kV以上电压三相开关场设计的电工学规则

Zpracovatel a oborové normaliza?ní st?edisko: ENERGOPROJEKT Praha: Ing. Vladimír Yachek Pracovník ??adu pro normalizaci a mě?ení: Ing. Michal K?í?

Electric-engineering rules. Three-phase switchyards for voltage above 52 kV

GOST 20248-1982 电压在10kV以内功率（25～2500）kVA的成套变电站.试验方法

Unit transformer substations from 25 to 2500 kV·A for voltage to 10 kV. Test methods

GOST 14695-1980 电压10 kV及以下,输出功率25-2500 kV·A的封闭式变电站.通用规范

Настоящий стандарт распространяется на комплектные трансформаторные подстанции (КТП) трехфазного переменного тока частоты 50 и 60 Гц на на

Enclosed transformer substations of output from 25 to 2500 kV·A, for voltages up to 10 kV inclusive. General specifications