33.040.30 交换和信令系统 标准查询与下载

ITU-T Q SUPP 45-2003 技术报告 TRQ.2815：BICC/ISUP 网络与基于会话发起协议和会话描述协议的始发/目的地网络互通的要求

This Supplement to ITU-T Q-Series Recommendations is a technical report on the procedures, information flows and information elements needed to interwork Bearer Independent Call Control (BICC) peer-to-peer protocol (i.e., ITU-T Rec. Q.1902) and ISDN User Part (ISUP) protocol (i.e., ITU-T Recs Q.761-Q.764, Q.73y.x, Q.765.x, Q.769.x), with Session Initiation Protocol (SIP) and Session Description Protocol (SDP) at the BICC Interface Serving Node (ISN). The SIP/SDP is assumed on a Network-to-Network Interface (NNI) between the BICC/ISUP network and a SIP network, which is an originating or terminating/destination network.

Technical Report TRQ.2815: Requirements for interworking BICC/ISUP network with originating/destination networks based on Session Initiation Protocol and Session Description Protocol

ITU-T Q SUPP 46-2003 技术报告 TRQ.2830：ATM-MPLS 网络互通信令要求

This Supplement provides the signalling requirements to enable ATM services to be provided over an MPLS network in a network interworking environment.

Technical Report TRQ.2830: ATM-MPLS network interworking signalling requirements

ITU-T Q SUPP 42-2003 技术报告 TRQ.2402：传输控制信令要求 AAL 类型 2 链路控制能力集 3 的信令要求

Technical Report TRQ.2402: Transport control signalling requirements - Signalling requirements for AAL type 2 link control Capability Set 3

ITU-T Q SUPP 44-2003 技术报告 TRQ.2800：传输控制信令要求 AAL 类型 2 到 IP 互通能力集 1 的信令要求

This Supplement to the Q-series Recommendations contains a Technical Report that specifies the general aspects of AAL type 2 to IP interworking signalling requirements for the development of AAL type 2 to IP signalling interworking Capability Set 1 (CS-1). This Supplement identifies what can be viewed as the capabilities for AAL type 2 to IP signalling interworking.

Technical Report TRQ.2800: Transport control signalling requirements - Signalling requirements for AAL type 2 to IP interworking Capability Set 1

ITU-T Q.115.0 ERRATUM 1-2003 控制信号处理网络元素和功能的协议；勘误表 1

Protocols for the control of signal processing network elements and functions; Erratum 1

ITU-T Q SUPP 43-2003 技术报告 TRQ.2415：传输控制信令要求 无线电接入网络能力集 1 中 IP 连接控制的信令要求

This Supplement to the Q-series of ITU-T Recommendations contains a Technical Report that specifies the general aspects of IP signalling requirements for the development of IP connection control Capability Set 1 (CS-1) in radio access networks. This Technical Report identifies what can be viewed as the capabilities for IP signalling. In addition, it describes the essential features and models useful for the development of functional entity actions in support of IP signalling.

Technical Report TRQ.2415: Transport control signalling requirements - Signalling requirements for IP connection control in radio access networks Capability Set 1

DS/EN 50065-4-2/A1:2003 kHz 至 148.5 kHz 频率范围内低压电气装置的信号传输 第 4-2 部分：低压去耦滤波器 安全要求

This product safety standard applies to electrical equipment, such as decoupling filters and phase couplers in a mains communication system for a phase to neutral voltage not exceeding AC 250 V and a nominal current not exceeding 125 A, intended for household and similar fixed-electrical installations including residential, commercial and light industrial buildings.

Signalling on low voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 4-2: Low voltage decoupling filters - Safety requirements

DS/EN 50065-4-3:2003 kHz 至 148.5 kHz 频率范围内低压电气装置的信号传输 第 4-3 部分：低压去耦滤波器 输入滤波器

This standard applies to incoming filters used to control the coupling of signals between the utility area and the consumer area (see Figure 1). The standard defines: - the minimum impedance in the relevant frequency band(s) at both Utility port and Consumer port, - the minimum attenuatiuon of unwanted signals transmitted from the utility side to the consumer side and vice versa, - the transmission characteristics: operating frequency domain for both utility side and consumer side, attenuation between the utility side and consumer side. This standard applies to incoming filters designed for and used in single or multiphase installations.

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 4-3: Low voltage decoupling filter - Incoming filter

DS/EN 301160 V1.2.1:2003 将呼叫路由至欧洲电话号码空间（ETNS）服务

The present document specifies the routeing methods that shall be used for implementation of the European Telephony Numbering Space (ETNS), the alternative structures of the routeing numbers and the addressing between networks.

Routeing of calls to European Telephony Numbering Space (ETNS) services

DS/EN 301161 V1.2.1:2003 欧洲电话号码空间（ETNS）的管理

The present document specifies the management of ETNS, including the number structure, the allocation of codes to the service described, number length and evolution from National numbers to pan-European to global numbers. It also describes the reference model for the ETNS and specifies the methods for routeing a call from the calling party to the called party and the management methods to be used for controlling such procedures.

Management of the European Telephony Numbering Space (ETNS)

YD/T 1278-2003 在用局用交换设备计费技术性能检测技术规范—固定电话网部分

本标准适用于固定电话网上在用长途局和本地端局的计费性能检测 ，测试对象包括交换机计费系统 和相关计费处理系统 (前置采集机、计费中心、账务中心等) 。 本标准规定了交换机计费系统和相关计费处理系统的技术指标和测试方法。接人公用电信网专网设 備的計費性能檢測可參照本标准執行。 本标准不涉及网间计费和人网检测。

The technical specification for testing the charging performance of SPC-telephone network part

DS/EN 50065-2-1:2003 kHz 至 148.5 kHz 频率范围内的低压电气装置信号 第 2-1 部分：在 95 kHz 至 148.5 kHz 频率范围内运行并打算用于以下用途的电源通信设备和系统的抗扰度要求

This standard applies to electrical equipment using signals in the frequency range 95 kHz to 148,5 kHz to transmit or receive information on low voltage electrical systems, residential, commercial and light industrial environments. In the case of equipment which includes functions other than the transmission or reception of information on low voltage electrical supplies, this standard applies only to that part of the equipment intended for such transmission or reception of information. Other parts of the equipment shall comply with the immunity standard or standards relevant to the functions of those other parts. In the event of tests being specified in tho

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-1: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 95 kHz to 148,5 kHz and intended for use in

DS/EN 50065-2-3:2003 kHz 至 148.5 kHz 频率范围内低压电气装置的信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供 ele 使用的电源通信设备和系统的抗扰度要求

This standard applies to electrical equipment using signals in the frequency range 3 kHz to 95 kHz to transmit or receive information on low voltage electrical systems, for electricity suppliers and distributors. In the case of equipment which includes functions other than the transmission or reception of information on low voltage electrical supplies, this standard applies only to that part of the equipment intended for such transmission or reception of information. Other parts of the equipment shall comply with the immunity standard or standards relevant to the functions of those other parts. In the event of tests being specified in those other standards

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by ele

DS/EN 50065-2-2:2003 3 kHz 至 148.5 kHz 频率范围内低压电气装置的信号 第 2-2 部分：在 95 kHz 至 148.5 kHz 频率范围内运行并用于以下用途的电源通信设备和系统的抗扰度要求

This standard applies to electrical equipment using signals in the frequency range 95 kHz to 148,5 kHz to transmit or receive information on low voltage electrical systems, in industrial environments. In the case of equipment which includes functions other than the transmission or reception of information on low voltage electrical supplies, this standard applies only to that part of the equipment intended for such transmission or reception of information. Other parts of the equipment shall comply with the immunity standard or standards relevant to the functions of those other parts. In the event of tests being specified in those other standards of a differe

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-2: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 95 kHz to 148,5 kHz and intended for use in

YD/T 1255-2003 具有路由功能的以太网交换机技术要求

Technical Specification for Ethernet Switch with Routing Capability

LST EN 50065-7-2003 3 kHz 至 148.5 kHz 频率范围内低压电气装置的信号第7部分：设备阻抗

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz Part 7: Equipment impedance

ITU-T G.7713.3/Y.1704.3-2003 分布式呼叫和连接管理：使用 GMPLS CR-LDP 的信令机制

Distributed Call and Connection Management: Signalling mechanism using GMPLS CR-LDP

ANSI/TIA-689-A-2003 电信.增强的9-1-1呼叫服务的多线终端系统PBX KTS支持

Contains technical requirements associated with PBX and Key Telephone System support of Enhanced 9-1-1 Emergency Calling Service.

Telecommunications-Multi Terminal Systems PBX KTS support of Enhanced 9-1-1 Calling Services

ITU-T Q SUPP 40-2002 技术报告：网络控制与应用层API/对象接口参考文档

Technical Report: Reference document on API/object interface between network control and application layer

ITU-T Q SUPP 32-2002 技术报告 TRQ.2141.1：通过宽带传输技术支持窄带服务的信令要求 CS-2 信令流程

This Supplement to ITU-T Q-series Recommendations is a technical report on the procedures, information flows and information elements needed for supporting CS-2 signalling requirement flows for the support of narrowband services via broadband transport technologies. Its scope is limited to functionality of the Serving Node and Call Mediation Node, and the associated protocols at the call control, bearer control, and call-bearer control levels needed for Capability Set 2.

Technical Report TRQ.2141.1: Signalling requirements for the support of narrowband services via broadband transport technologies - CS-2 signalling flows