59.060.01 纺织纤维综合 标准查询与下载
共找到 864 条与 纺织纤维综合 相关的标准，共 58 页
This document specifies a method for determining the amount of certain benzotriazole compounds (UV- 320, UV-327, UV-328, UV-350) in textiles by using liquid chromatography-tandem mass spectrometry (LC-MS/MS) or liquid chromatography-diode array detector (LC-DAD) or gas chromatography with mass spectrometry (GC-MS). The method is applicable to all kinds of textile materials (fibres and fabrics).
Textiles — Determination of certain benzotriazole compounds
- ICS
- 59.060.01
- CCS
- 发布
- 2022-04-01
- 实施
Methods for identification of imported solid waste Textile raw materials and products Part 5: Fibers
- ICS
- 59.060.01
- CCS
- W04
- 发布
- 2022-03-14
- 实施
- 2022-10-01
本标准规定了采用平行染色法测定包芯纱染色均匀度的原理、试剂和材料、装置、试验程序、注意事项和试验报告。针对包芯纱产品特点，主要分4类染料染色，和4种试剂的配比。 1. 取样和制样方法 取样制样 参照GB/T 6502 ，GB/T 6508 ，每段袜筒试样长度为10～30 cm。 2. 染料选择 2.1 采用活性染料染粘胶，要求对锦纶不沾色，本试验采用C.I.活性红195，在标准文本中，给出了C.I.活性红195。 2.2 采用酸性染料染锦纶，要求对粘胶不沾色，本试验采用C.I.酸性黑172，在标准文本中，给出了C.I.酸性蓝324。 2.3 采用X型阳离子染料染腈纶和常温阳离子改性涤纶，标准文本中给出了 C.I.碱性、C.I.碱性黄28。 2.4 采用分散染料染涤纶，本标准文本中给出了C.I.分散蓝56。 3. 染色工艺 3.1 袜带前处理采用中性皂片或皂粉，以适应多种纤维性质。 3.2 染色 3.2.1 染料溶解条件 1）活性染料溶解水温度低于50 ℃； 2）酸性染料溶解水温度90 ℃； 3）阳离子染料加入浓度为100 g/L与染料等量的冰醋酸溶解水温90 ℃； 4）分散染料溶解水温度低于40 ℃。 3.2.2 活性染料染色 按照60 ℃恒温染色工艺，染色深度1% o.w.f，染色30 min后，加纯碱固色45～60 min。 3.2.3 酸性染料、分散染料和阳离子染色工艺，染色深度0.5%o.w.f， 室温入染后按照1 ℃/min升温到98 ℃染色45～60 min。仪器评色 4. 仪器评色 将目测评定中的评定样作为仪器评定的试样，用测色仪测试，读取色差评级结果并记录。 5. 目测评色 试样袜带平整展开，缓缓平移，逐段观察袜带的深、浅、条、带、纹，选择袜带中的最深段和最浅段一段试样作为评定样，用GB/T 250 提供的框架压框压住，按灰色样卡目测评定试样的色差等级并做好记录。
Determination of dyeing uniformity of core-spun yarn Parallel dyeing
- ICS
- 59.060.01
- CCS
- C175
- 发布
- 2022-03-11
- 实施
- 2022-03-18
Construction principles of industrial hemp standard system
- ICS
- 59.060.01
- CCS
- B 00
- 发布
- 2022-03-03
- 实施
- 2022-04-02
Guidelines for Utilization of Hemp Fiber Processing Waste
- ICS
- 59.060.01
- CCS
- B 00
- 发布
- 2022-03-03
- 实施
- 2022-04-02
Method for measuring and grading the color of natural colored cotton
- ICS
- 59.060.01
- CCS
- W 10
- 发布
- 2022-03-01
- 实施
- 2022-03-01
本文件规定了植物染料染色棉及再生纤维素纤维的术语和定义、产品分类、标记、要求、试验方法、检验规则及标志、包装、运输、贮存。 植物染料染色棉及再生纤维素纤维技术要求包括理化性能、特性指标、断裂强度降低率、含杂率、实际回潮率最高限度、色牢度、外观质量和安全性能。
Vegetable dyed cotton and regenerated cellulose fiber
- ICS
- 59.060.01
- CCS
- C171
- 发布
- 2022-02-18
- 实施
- 2022-02-18
3 术语和定义 4 技术要求 4.1 外观形态 4.2 尺寸偏差 4.3 克重 4.4 性能要求 4.5 可迁移元素限量 5 试验方法 5.1 外观形态 5.2 尺寸偏差 5.3 克重 5.4 与水接触角 5.5 断裂强度和断裂伸长率 5.6 层间撕裂强度 5.7 降解率 5.8 耐紫外性能 5.9 比表面积 5.10 孔隙率 5.11 可迁移元素限量 6 检验规则 6.1 组批 6.2 取样 6.3 出厂检验 6.4 型式检验 6.5 判定 7 包装、标志、运输和贮存
Technical specification for ecological base material for water environment treatment
- ICS
- 59.060.01
- CCS
- N772
- 发布
- 2021-12-28
- 实施
- 2021-12-28
阳离子改性棉纤维技术要求包括物理性能、可染性、pH 值、异味、含杂率、回潮率。物理性能包含纤维主体长度、马克隆值、断裂比强度、长度整齐度指数四项。
Cationic Modified Cotton Fiber
- ICS
- 59.060.01
- CCS
- C171
- 发布
- 2021-12-25
- 实施
- 2021-12-30
This document specifies a gravimetric method and a vibroscope method for the determination of the linear density of textile fibres applicable respectively to: a) bundles of fibres; b) individual fibres. Useful data can be obtained on man-made fibres and, with less precision, on n
Textile fibres - Determination of linear density - Gravimetric method and vibroscope method (ISO 1973:2021); German version EN ISO 1973:2021
- ICS
- 59.060.01
- CCS
- 发布
- 2021-12-00
- 实施
Textile fibres. Determination of linear density. Gravimetric method and vibroscope method
- ICS
- 59.060.01
- CCS
- 发布
- 2021-11-01
- 实施
- 2021-11-01
Textiles - Quantitative chemical analysis - Part 22: Mixtures of viscose or certain types of cupro or modal or lyocell with flax fibres (method using formic acid and zinc chloride) (ISO 1833 22:2020)
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-15
- 实施
- 2021-10-15
Textile fibres – Determination of linear density – Gravimetric method and vibroscope method
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-13
- 实施
- 2021-10-13
Textile fibres – Determination of linear density – Gravimetric method and vibroscope method (ISO 1973:2021)
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-13
- 实施
- 2021-10-13
This document specifies a gravimetric method and a vibroscope method for the determination of the linear density of textile fibres applicable respectively to: a) bundles of fibres; b) individual fibres. Useful data can be obtained on man-made fibres and, with less precision, on natural fibres. This document only applies to fibres which can be kept straight and, in the case of bundles, parallel, during test preparation. It is properly applicable when the fibres are readily freed of crimp. The methods in this document are not applicable to tapered fibres. The vibroscope method is not always applicable to hollow and flat (ribbon-like) fibres.
Textile fibres - Determination of linear density - Gravimetric method and vibroscope method (ISO 1973:2021)
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-06
- 实施
- 2022-01-31
1.1 This guide lists fibers used to manufacture textile products. 1.2 Specific groups of fibers are identified using tables of standard classification. 1.2.1 Animal fibers are identified by commercial name, biological name, end use, and geographic source. 1.2.2 Vegetable fibers are identified by commercial name, botanical name, staple length or description, and geographic source. 1.2.3 Mineral fibers are identified by commercial name, mineralogical name, chemical description, and geographic source. 1.2.4 Manufactured fibers are identified by commercial name, generic name, and major component. 1.3 Major fiber types used for textile purposes are further classified. 1.3.1 Manufactured fibers are identified as having either an organic base or inorganic base. 1.3.2 Natural fibers are identified as having a cellulosic, protein, or mineral base. 1.4 A glossary of generic names and definitions for manufactured fibers is included as additional information. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Guide for Textile Fibers
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-01
- 实施
Textiles - Determination of the phthalate content - Tetrahydrofuran method (ISO/DIS 14389:2021)
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-00
- 实施
This document specifies a method, using formic acid and zinc chloride, to determine the mass percentage of viscose or certain types of cupro or modal or lyocell, after removal of non-fibrous matter, in textiles made of mixtures of viscose or certain types of the cupro or modal or
Textiles - Quantitative chemical analysis - Part 22: Mixtures of viscose or certain types of cupro or modal or lyocell with flax fibres (method using formic acid and zinc chloride) (ISO 1833-22:2020); German version EN ISO 1833-22:2021
- ICS
- 59.060.01
- CCS
- 发布
- 2021-10-00
- 实施
Textiles - Determination of short-chain chlorinated paraffins (SCCP) and middle-chain chlorinated paraffins (MCCP) in textile products out of different matrices by use of gas chromatography negative ion chemical ionization mass spectrometry (GC-NCI-MS) (I
- ICS
- 59.060.01
- CCS
- 发布
- 2021-08-25
- 实施
- 2021-08-25
植物多酚改性功能棉纤维技术要求包括物理性能、功能性要求、植物多酚含量、含杂率和回潮率。 物理性能包含纤维主体长度、马克隆值、断裂比强度、长度整齐度指数四项。功能性要求包含抗菌性、 消臭性、防螨性三项。
Plant polyphenol modified functional cotton fiber
- ICS
- 59.060.01
- CCS
- C171
- 发布
- 2021-08-23
- 实施
- 2021-08-24
