71.040.10 化学实验室、实验室设备 标准查询与下载

DIN EN 15154-2:2006 安全性应急冲洗器. 第2部分: 眼睛垂直冲洗器. 英文版本 DIN EN 15154-2: 2006-12

This document is a product specification, giving performance requirements for emergency safety eye wash units connected to the water supply. It is applicable to plumbed-in eye wash units only. Requirements are given in respect of the performance, installation, adjustment and marking of the eye wash units, as well as installation, operation and maintenance instructions to be given by the manufacturer. NOTE Attention is drawn to national regulations which may apply in respect of the installation and use of eye wash units.

Emergency safety showers - Part 2: Plumbed-in eye wash units; English version of DIN EN 15154-2:2006-12

DS/EN 14470-2:2006 消防安全储存柜 第2部分：加压气瓶安全柜

This standard is a product specification, giving performance requirements for fire safety cabinets used for storing pressurised gas cylinders. It is applicable to cabinets with a total internal volume suitable to store pressurised gas cylinders with a total volume not exceeding 220 l, including cylinders of purging gases.

Fire safety storage cabinets - Part 2: Safety cabinets for pressurised gas cylinders

DS/CEN/TS 14175-5:2006 通风柜 第5部分：安装和维护建议

This technical specification specifies a selection of recommendations for the installation and maintenance of fume cupboards in accordance with EN 14175-2 and EN 14175-6. The maintenance recommendations can be applicable to other fume cupboards as well.

Fume cupboards - Part 5: Recommendations for installation and maintenance

DS/EN 14175-6:2006 通风柜-第6部分：可变风量通风柜

This standard specifies requirements and type test methods for VAV systems. It also specifies additional requirements to those in EN 14175-2 and additional test methods to those in EN 14175-3 and EN 14175-4 for fume cupboards with VAV systems (VAV fume cupboards).For terms and definitions, EN 14175-1 applies. For safety and performance requirements of fume cupboards, EN 14175-2 applies. For type testing of fume cupboards with preset air volume flow, EN 14175-3 applies. For on-site test methods of fume cupboards already installed in a laboratory, EN 14175-4 applies.

Fume cupboards - Part 6: Variable air volume fume cupboards

NF X15-203-6*NF EN 14175-6:2006 实验室排风柜.第6部分:可改变空气体积的排风柜

Fume cupboards - Part 6 : variable air volume fume cupboards.

DIN EN 14175-6:2006-08 通风柜.第6部分:空气变量通风柜

Fume cupboards - Part 6: Variable air volume fume cupboards English version of DIN EN 14175-6:2006-08

LST EN 14175-6-2006 通风柜-第6部分：可变风量通风柜

Fume cupboards - Part 6: Variable air volume fume cupboards

LST EN 14727-2006 实验室家具 实验室存储单元 要求和测试方法

Laboratory furniture - Storage units for laboratories - Requirements and test methods

EN 14175-6:2006 通风柜.第6部分:空气变量通风柜

This document specifies requirements and type test methods for VAV systems. It also specifies additional requirements to those in EN 14175-2 and additional test methods to those in EN 14175-3 and EN 14175-4 for fume cupboards with VAV systems (VAV fume cupboards).For terms and definitions, EN 14175-1 applies. For safety and performance requirements of fume cupboards,EN 14175-2 applies. For type testing of fume cupboards with preset air volume flow, EN 14175-3 applies. For on-site test methods of fume cupboards already installed in a laboratory, EN 14175-4 applies.

Fume cupboards - Part 6: Variable air volume fume cupboards

DIN EN 14727:2006 实验室设备.实验室存储设备.要求和试验方法.德文版本 EN 14727-2005

This European Standard specifies requirements and test methods for storage units (see 3.1 used in laboratones. This European Standard specifies strength, durability and safety requirements to prevent serious injury through normal functional use, as well as misuse that might reasonably be expected to occur Safety, depending on the structure of the building, is not included e.g. the strength of wall hanging cabinets includes only the cabinet and its parts. The wall and the fixing in the wall are not included. It should be understood that the tests do not ensure that structural failure will not eventually occur as a result of habitual misuse or after an excessively long period of service. Assessment of ageing, degradation and the heating effect of appliances are not included nor are ergonomic aspects or resistance to fire.

Laboratory furniture - Storage units for laboratories - Requirements and test methods; English version of DIN EN 14727:2006-03

DS/EN 14727:2006 实验室家具 实验室存储单元 要求和测试方法

This European Standard specifies requirements and test methods for storage units (see 3.1) used in laboratories.This European Standard specifies strength, durability and safety requirements to prevent serious injury through normal functional use, as well as misuse that might reasonably be expected to occur. Safety, depending on the structure of the building, is not included e.g. the strength of wall hanging cabinets includes only the cabinet and its parts. The wall and the fixing in the wall are not included. It should be understood that the tests do not ensure that structural failure will not eventually occur as a result of habitual misuse or after an exce

Laboratory furniture - Storage units for laboratories - Requirements and test methods

DS/EN 61010-2-040:2006 测量、控制和实验室用电气设备的安全要求 第 2-040 部分：用于处理医疗材料的灭菌器和清洗消毒器的特殊要求

This International Standard specifies safety requirements for electrical equipment intended for sterilization, washing, and disinfection of medical materials in the medical, veterinary, pharmaceutical and laboratory fields, when used under the environmental conditions of 1.4. This document consolidates the requirements of four standards, EN 61010-2-041, EN 61010-2-042, EN 61010-2-043 and EN 61010-2-045, which are withdrawn, and aligns them with the second edition (2001) of EN 61010-1:Safety requ

Safety requirements for electrical equipment for measurement, control and laboratory use - Part 2-040: Particular requirements for sterilizers and washer-disinfectors used to treat medical materials

NF X15-202:2006 实验室设备.实验室存储装置.要求和试验方法

Laboratory furniture - Storage units for laboratories - Requirements and test methods.

BS EN 14727:2005 实验室设备.实验室用存储设备.要求和试验方法

This European Standard specifies requirements and test methods for storage units (see 3.1) used in laboratories. This European Standard specifies strength, durability and safety requirements to prevent serious injury through normal functional use, as well as misuse that might reasonably be expected to occur. Safety, depending on the structure of the building, is not included e.g. the strength of wall hanging cabinets includes only the cabinet and its parts. The wall and the fixing in the wall are not included. It should be understood that the tests do not ensure that structural failure will not eventually occur as a result of habitual misuse or after an excessively long period of service. Assessment of ageing, degradation and the heating effect of appliances are not included nor are ergonomic aspects or resistance to fire.

Laboratory furniture - Storage units for laboratories - Requirements and test methods

BS EN 14727:2006 实验室设备 实验室用存储设备 要求和试验方法

Laboratory furniture. Storage units for laboratories. Requirements and test methods

UL 1805 BULLETINS-2006 CSDS 02/10/2006 (2p)

1.1 These requirements apply to laboratory hoods and cabinets intended to provide an enclosed countertop work area with exhaust for containment and removal of vapors, mists, gases, and particulate matter from the work area. 1.2 These requirements do not cover ductless hoods (i.e., hoods that recirculate air back to room environment after filtering) or glove boxes. 1.3 These products are investigated for fire, electrical and mechanical risk of injuries only. A limited number of tests are conducted for minimal air flow capability. It remains for the user to determine that the hood performance, as confirmed by the requirements in this standard, meets the needs of the user. These needs depend on several factors, including installation with proper exhaust equipment, location within the room, the type of material being handled and the method in which the material is being handled. Also, suitability for use with perchloric acid or radiological materials is not investigated. 1.4 Requirements for the installation of laboratory hoods are included in the Standard for Fire Protection for Laboratories Using Chemicals, NFPA 45 and in the Method of Testing Performance of Laboratory Fume Hoods, ASHRAE 110. 1.5 Requirements for the installation of piped gas systems are contained in the following standards :a) National Fuel Gas Code, NFPA 54,b) Liquefied Petroleum Gas Code, NFPA 58,c) Gaseous Hydrogen Systems at Consumer Sites, NFPA 50A,d) Design and Installation of Oxygen-Fuel Gas Systems for Welding, Cutting, and Allied Processes, NFPA 51.

CSDS 02/10/2006 (2p)

BS EN 14175-6:2006(2014) 通风柜 变风量通风柜

Fume cupboards. Variable air volume fume cupboards

NF C42-720:2005 测量、控制和实验室用电气设备的安全要求.第2-010部分:材料加热用实验室设备的特殊要求

Safety requirements for electrical equipment for measurement, control and laboratory use - Part 2-010 : particular requirements for laboratory equipment for the heating of material.

EN 14727:2005 实验室设备.实验室存储设备.要求和试验方法

This European Standard specifies requirements and test methods for storage units (see 3.1) used inlaboratories.

Laboratory furniture - Storage units for laboratories - Requirements and test methods

DIN EN 14175-4:2004-12 通风柜.第4部分:现场试验方法

The standard specifies on-site test methods for the assessment of safety and performance of installed fume cupboards. Test methods are specified for commissioning testing and maintenance testing of type tested (according EN 14175-3) and non-type tested fume cupboards. In addition, a qualification test for non-type tested fume cupboards is specified.#,,#

Fume cupboards - Part 4: On-site test methods; German version EN 14175-4:2004