共找到 773 条与 其他化工产品 相关的标准,共 52 页
1 范围................................................................................. 1 2 规范性引用文件....................................................................... 1 3 术语和定义........................................................................... 1 4 技术要求............................................................................. 1 5 采样及试验方法....................................................................... 2 6 检验规则............................................................................. 3 7 标志、包装、运输、贮存和质量证明文件................................................. 4 8 安全................................................................................. 4
Indole
前言 I 1 范围 1 2 规范性引用文件 1 3 术语和定义 1 4 技术要求 1 5 采样及试验方法 2 6 检验规则 3 7 标志、包装、运输、贮存和质量证明文件 4 8 安全 4
Indene
1.1 This test method covers the determination of the stability of wax emulsion floor polishes when these are exposed to repeated cycles of freezing and thawing. Possible degradation of the emulsion is observed and possible reduction of initial gloss is measured. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Freeze/Thaw Resistance of Wax Emulsion Floor Polish
本文件规定了左旋肉碱富马酸盐的基本要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存、质量承诺要求。
L-Carnitine fumarate
本文件规定了乙酰左旋肉碱盐酸盐的基本要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存、质量承诺。
O-Acetyl-L-carnitine hydrochloride
1.1 This practice covers the definition of properties to test and the apparatus to use, in evaluating the performance of buffable shoe polishes. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Evaluation of Buffable Shoe Polish
本文件规定了汽车门板热烫印工艺的术语定义、技术要求、工艺流程、试验方法。 本文件适用于汽车门板热烫印工艺过程中的生产与检验。
Specifications for thermal stamping process of automobile door panels
4 原料要求 应以稀土湿法冶金产生的硫酸铵废水,然后以氯化钙处理生成的稀土石膏固废为原料,稀土石膏中稀土铈Ce元素含量水平应在0.025mg/L上下。 5 生产要求 5.1 生产场所 生产场所应设在稀土石膏固废堆积场附近。生产车间面积和物理空间应与生产能力相适应,便于设备安装、物料搬运及人员操作。 5.2 设施设备 5.2.1 湿法反应槽和沉淀池。 5.2.2 MCR-3型微波化学反应器。 5.2.3 101-1A型电热鼓风干燥箱。 5.2.4 DF-101S型集热式磁力搅拌器。 5.2.5 SHZ-D(Ⅲ)型循环水多用真空泵。 5.3 化学试剂 5.3.1 无机强酸溶液,可采用硫酸、硝酸、盐酸中的任一种。无机强酸溶液中氢离子的摩尔浓度应为2-8mol/L。 5.3.2 无水乙醇,应符合GB/T 678的要求。 6 生产工艺 步骤一:将稀土石膏在微波条件下溶解于无机强酸溶液中,配置成硫酸钙过饱和溶液,质量浓度应为50-120 g/L;微波加热温度应为40-90 ℃,加热时间应为5-60 min。 步骤二:用循环式真空泵对硫酸钙过饱和溶液进行真空抽滤,把固液分离后得到的滤液冷却至室温,陈化2-10 h。 步骤三:再次进行真空抽滤得到滤渣,滤渣用无水乙醇洗涤,在恒温干燥箱中干燥,干燥温度为60-90 ℃,干燥时间为12-36 h,干燥后得到二水硫酸钙晶须。
Rare earth calcium sulfate whisker
Standard Specification for Drycleaning-Grade Perchloroethylene
Water treatment agent aminotrimethylene phosphonic acid
Water treatment agent diethylenetriamine pentamethylenephosphonic acid
本文件规定了氨氧化节铂组合网的术语和定义、一般要求、技术要求、试验方法、检验规则、标志、包装、运输及贮存。 本文件适用于氨氧化节铂组合网的生产及检验。
Platinum ammonium oxide combined network
本文件规定了工业级甲基肼的术语和定义、要求、检验方法、检验规则以及标志、包装、运输和贮存。 本文件适用于由水合肼等生产的工业级甲基肼。 分子式: CH6N2 相对分子量:46.07 (按2009年国际原子量)
Industrial grade methyl hydrazine
Analytical method for chemical composition of platinum palladium series deoxidizer
Determination of Silica Crystal Phase Content in Hydrogenation Catalyst and Its Support X-ray Diffraction Method
Test method for sulfur capacity of zinc oxide desulfurizer at room temperature
1 范围 1 2 规范性引用文件 1 3 术语和定义 6 4 技术要求 6 5 采样及试验方法 7 6 检验规则 7 7 标志、包装、运输、贮存和质量证明文件 8 8 安全 8
Decahydronaphthalene
Analytical method for chemical composition of catalyst for dehydrogenation of methyl isobutyl methanol to methyl isobutyl ketone
Test method for activity of chromium-based ethylene polymerization catalysts
X-ray fluorescence spectrometry method for chemical composition analysis of lubricating oil hydroisomerization catalyst
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号