共找到 1884 条与 固体燃料 相关的标准,共 126 页
本标准适用于铸造焦、冶金焦等焦炭假相对密度及总气孔率的测定。
Coke--Determination of apparent relative density and total porosity
本标准适用于铸造焦、冶金焦等焦炭的显气孔率的测定。
Coke--Determination of show porosity
本标准适用于煤沥青经高温干馏所得沥青焦试样的采取和制备,供测定相应标准中技术条件规定的各项指标。
Sampling and preparation of samples of petroleum cokes
Solid recovered fuels. Determination of the recycling index for co-processing
Standard Test Method for Determination of Ash Content of Particulate Wood Fuels
Standard Test Method for Volatile Matter in the Analysis of Particulate Wood Fuels
1.1 This practice covers the term ultimate analysis as it is applied to the analysis of coal and coke. The information derived is intended for the general utilization by applicable industries, to provide the basis for evaluation, beneficiation, or for other purposes. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.2.1 All percentages are percent mass fractions. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Ultimate Analysis of Coal and Coke
Coke. Determination of moisture in the general analysis test sample
本文件规定了煤粉燃烧催化剂使用性能试验和评价方法针对煤粉燃烧炉窑添加催化剂燃烧的使用性能进行试验评价。
Performance test and evaluation method of pulverized coal combustion catalyst
Standard Guide for Harvesting Coal Combustion Products Stored in Active and Inactive Storage Areas for Beneficial Use
1.1 This test method covers determination of the pH of a water extract of activated carbon. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6 . 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for pH of Activated Carbon
Standard Test Method for Ignition Temperature of Granular Activated Carbon
Standard Practice for Ultimate Analysis of Coal and Coke
Standard Practice for Calculating Coal and Coke Analyses from As-Determined to Different Bases
规定了船舶供受燃油过程中船用燃油计量及取样操作的基本要求。包括基本要求、加油检验前的准备、加油数量检验、取样、记录和报告等内容。
Operation specification for bunkering survey
Standard Test Method for Real Density of Calcined Petroleum Coke by Xylene Displacement
Standard Test Method for Hardgrove Grindability Index (HGI) of Petroleum Coke
Standard Test Method for Determination of Bulk Density for Specific Size Fractions of Calcined Petroleum Coke Using a Transaxial Pressure Pycnometer
Standard Test Method for Fusibility of Refuse-Derived Fuel (RDF) Ash
Standard Test Method for Determination of Vibrated Bulk Density of Calcined Petroleum Coke
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号