75.160.10 固体燃料 标准查询与下载
共找到 1884 条与 固体燃料 相关的标准，共 126 页
1.1 This test method covers a relative measure of the plastic behavior of coal when heated under prescribed conditions. This test method may be used to obtain semiquantitative values of the plastic properties of coals and blends used in carbonization and in other situations where determination of plastic behavior of coals is of practical importance. 1.2 Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer
- ICS
- 75.160.10
- CCS
- 发布
- 2022-12-01
- 实施
本文件规定了公路隧道空气净化用煤质活性炭的技术要求、试验方法、检测规则及包装、运输、贮存等内容。 本文件适用于公路隧道空气中有毒有害组分处理用煤质活性炭。
Coal-based activated carbon for air purification in road tunnels
- ICS
- 75.160.10
- CCS
- C252
- 发布
- 2022-11-28
- 实施
- 2022-11-28
Coke — Determination of bulk density in a small container
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-25
- 实施
Solid mineral fuels — Coke — Determination of moisture in the general analysis test sample
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-25
- 实施
Coke — Determination of bulk density in a small container
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-25
- 实施
Solid mineral fuels — Coke — Determination of moisture in the general analysis test sample
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-25
- 实施
Coke — Determination of shatter indices
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-25
- 实施
Coke — Determination of shatter indices
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-25
- 实施
Solid mineral fuels — Determination of ash
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-18
- 实施
Solid mineral fuels — Determination of carbonate carbon content — Gravimetric method
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-18
- 实施
Solid mineral fuels — Determination of carbonate carbon content — Gravimetric method
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-18
- 实施
Solid mineral fuels — Determination of ash
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-18
- 实施
This document specifies an analytical method for quantification of the spontaneous heat generation from solid recovered fuels using isothermal calorimetry. This document gives guidance on the applicability and use of the specified analytical method. It further establishes procedures for sampling and sample handling of solid recovered fuels prior to the analysis of spontaneous heat generation. The test procedure given in this document quantifies the thermal power (heat flow) of the sample during the test. It does not identify the source of self-heating in the test portion analysed.
Solid recovered fuels — Determination of self-heating — Part 1: Isothermal calorimetry
- ICS
- 75.160.10
- CCS
- 发布
- 2022-11-15
- 实施
Coke — Determination of true relative density, apparent relative density and porosity
- ICS
- 75.160.10
- CCS
- 发布
- 2022-10-28
- 实施
Coke — Determination of true relative density, apparent relative density and porosity
- ICS
- 75.160.10
- CCS
- 发布
- 2022-10-28
- 实施
1.1 This test method covers the analysis for commonly determined trace metals in test specimens of raw and calcined petroleum coke by inductively coupled plasma atomic emission spectroscopy. 1.2 Elements for which this test method is applicable are listed in Table 1. Detection limits, sensitivity, and optimum ranges of the metals will vary with the matrices and model of spectrometer. 1.3 This test method is applicable only to samples containing less than one mass % ash. 1.4 Elements present at concentrations above the upper limit of the working ranges can be determined with additional, appropriate dilutions. 1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES)
- ICS
- 75.160.10
- CCS
- 发布
- 2022-10-01
- 实施
1.1 This test method covers the analysis for the commonly determined trace metals (aluminum, calcium, iron, nickel, silicon, sodium, and vanadium) in laboratory analysis samples of raw and calcined petroleum coke by atomic absorption spectroscopy. 1.2 The elemental concentration ranges for which this test method is applicable and the limits of detection of this test method are listed in Table 1. 1.3 The values stated in SI units are to be regarded as the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For warning statements, see Sections 9 – 11. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Trace Metals in Petroleum Coke by Atomic Absorption
- ICS
- 75.160.10
- CCS
- 发布
- 2022-10-01
- 实施
本文件规定了PMC新型固体燃料的产品特性、原料、成分、质量指标、检验方法、检验规则、标识、运输和贮存。
PMC new solid fuel
- ICS
- 75.160.10
- CCS
- C252
- 发布
- 2022-09-28
- 实施
- 2022-09-28
