91.100.23 标准查询与下载

EN ISO 10545-16:2012 瓷砖.第16部分:细小色差测定

This part of ISO 10545 describes a method for utilizing colour measuring instruments for quantifying the smallcolour differences between plain coloured ceramic tiles, which are designed to be of uniform and consistentcolour. It permits the specification of a maximum acceptable value, which depends only on the closeness ofmatch and not on the nature of the colour difference.

Ceramic tiles - Part 16: Determination of small colour differences

EN ISO 10545-4:2012 瓷砖.第4部分:断裂模数和破坏强度的测定

This part of ISO 10545 specifies a test method for determining the modulus of rupture and breaking strength ofall ceramic tiles.

Ceramic tiles - Part 4: Determination of modulus of rupture and breaking strength

EN 14411:2012 瓷砖-定义,分类,特点,评价整合和标记

This European Standard defines terms and specifies characteristics for ceramic tiles produced by extrusion and dry-pressing techniques, used for internal and/or external floorings (including stairs) and walls. Furthermore, it provides the level of requirements for these characteristics and references to the test methods applied (see Note) as well as provisions for evaluation of conformity and marking. NOTE The series of standards EN ISO 10545 describe the test procedures required to determine most of the product characteristics listed in this European Standard. The series is divided into 16 parts, each describing a specific test procedure or related matter. This European Standard does not cover: ceramic tiles made by processes other than extrusion or dry-pressing; dry-pressed unglazed ceramic tiles with water absorption greater than 10 %; ceramic tiles used for floorings on external road finishes; ceramic tiles used in ceiling finishes or suspended ceilings.

Ceramic tiles - Definitions, classification, characteristics, evaluation of conformity and marking

TIS 2528.3-2010 预应力混凝土轨枕.第3部分:预应力混凝土轨枕的试验方法

Prestressed concrete sleepers.part 3: methods of test for prestressed concrete sleepers

TIS 2528.2-2010 预应力混凝土轨枕.第2部分:预应力混凝土轨枕的取样方法

Prestressed concrete sleepers.part 2: methods of sampling for prestressed concrete sleepers

TIS 2528.1-2010 预应力混凝土轨枕.第1部分:与预应力混凝土轨枕相关的术语定义

Prestressed concrete sleepers.part 1: definition of terms relating to prestressed concrete sleepers

ISO 10545-6:2010 瓷砖.第6部分:无釉砖耐磨深度的测定

This part of ISO 10545 specifies a test method for determining the resistance to deep abrasion of all unglazed ceramic tiles used for floor coverings.

Ceramic tiles - Part 6: Determination of resistance to deep abrasion for unglazed tiles

ISO 10545-16:2010 瓷砖.第16部分:小色差的测定

This part of ISO 10545 describes a method for utilizing colour measuring instruments for quantifying the small colour differences between plain coloured ceramic tiles, which are designed to be of uniform and consistent colour. It permits the specification of a maximum acceptable value, which depends only on the closeness of match and not on the nature of the colour difference. This part of ISO 10545 is not applicable to colour variations produced for artistic purposes.

Ceramic tiles - Part 16: Determination of small colour differences

ASTM C126-10 陶瓷上釉结构用饰面砖、面砖以及实心砖石砌块标准规范

1.1 This specification covers structural clay load-bearing facing tile and facing brick and other “solid masonry units” made from clay, shale, fire-clay, or mixtures thereof, with or without the addition of grog or other mixtures, having a finish consisting of a ceramic glaze fused to the body at above 1500°F (655°C) making them inseparable, excluding natural salt-glazed ware. Two grades, based on permissible variation in face dimensions, and two types are covered, as follows: 1.1.1 Grade S (select), for use with comparatively narrow mortar joints.

Standard Specification for Ceramic Glazed Structural Clay Facing Tile, Facing Brick, and Solid Masonry Units

SANS 1449:2008 陶瓷墙面和铺地砖

Specifies the requirements for glazed and unglazed ceramic wall and floor tiles. Does not cover unglazed dust-pressed tiles that have a water absorption exceeding 10%.

Ceramic wall and floor tiles

ANSI A118.12-2008 薄集瓷砖和规格石料裂纹绝缘薄膜的安装规范

This specification describes the testing and physical properties required for a membrane to be classified as meeting A118.12. These membranes are designed to isolate the tile and stone from minor in-plane cracking in the substrate. This specification measures the membranes' ability to perform in this manner. The crack isolation test jig is also described.

Specifications for Crack Isolation Membranes for Thin-Set Ceramic Tile and Dimension Stone Installations

BS EN 14891:2007 用于瓷砖下部、胶粘剂粘合的防水渗透的液体产品 要求、试验方法、一致性评估、分类和标记

This European Standard applies to all liquid-applied water impermeable products, based on polymer modified cementitious mortars, dispersions and reaction resin coatings, used beneath ceramic tiling, for internal and external tile installations on walls and floors. This European Standard gives the terminology concerning the products and specifies the test methods and the values of performance requirements for liquid-applied water impermeable products associated with tile adhesives. This European Standard specifies the evaluation of conformity and the classification and designation of liquidapplied water impermeable products beneath ceramic tiling. This European Standard does not contain recommendations for the design and installation of ceramic tiles and grouts in combination with water impermeable products.

Liquid applied water impermeable products for use beneath ceramic tiling bonded with adhesives - Requirements, test methods, evaluation of conformity, classification and designation

DS/EN ISO 10545-15:2007 瓷砖 第15部分：釉面砖释放的铅和镉的测定

This part of ISO 10545 specifies a method for the determination of lead and cadmium given off by the glaze of ceramic tiles.

Ceramic tiles - Part 15: Determination of lead and cadmium given off by glazed tiles

DIN EN 14411 Berichtigung 1:2007 瓷砖.定义、分级、特性和标记.DIN EN 14411-2007技术勘误

Ceramic tiles - Definitions, classification, characteristics and marking; German version EN 14411:2006, Corrigenda to DIN EN 14411:2007-03

GSO ISO 10545-5:2007 瓷砖 第5部分：通过测量回弹系数估算抗冲击性

This part or ISO 10545 specifies test method for determining the impact resistance of ceramic tiles by measuring the coefficient of restitution.

Ceramic tiles –Part 5 : Determination of impact resistance by measurement of coefficient of restitution

GSO ISO 10545-12:2007 瓷砖 第12部分：抗冻性的测定

This part of ISO 10545 specifies a method for determining the frost resistance of all ceramic tiles intended for use in the presence of water.

Ceramic tiles –Part 12 : Determination of frost resistance

GSO ISO 10545-7:2007 瓷砖 第7部分：评估抛光砖的表面耐磨性

This part or ISO 10545 specifies a method for determining the resistance to surface abrasion of all unglazed ceramic tiles used for floor covering.

Ceramic tiles –Part 7 : Determination of resistance To surface abrasion for glazed tiles

GSO ISO 10545-11:2007 瓷砖 第11部分：评估抛光砖的抗裂性

This part of ISO 10545 defines a test method for determining the crazing resistance of all glazed ceramic tiles except when the crazing is an inherent decorative feature of the product. NOTE 1 ISO 13006:__,Cermic tiles __ Definitions, classification, characteristics and marking (to be published), provides property requirements for tiles and other useful information on these products.

Ceramic tiles –Part 11 : Determination of crazing resistance for glazed tiles

BS EN 14411:2007 瓷砖 定义、分类、特性和标记

Ceramic tiles. Definitions, classification, characteristics and marking

BS EN 14411:2006 瓷砖.定义、分类、特性和标记

This European Standard defines and gives terms, specifies requirements and marking criteria for ceramic tiles (produced by extrusion and dry-pressing techniques) of the best commercial quality (first quality). Tiles not of first commercial quality are also covered following the provisions of Annex Q. This European Standard does not cover tiles made by other than the normal processes of extrusion or drypressing nor decorative accessories or trim (such as edges, corners, skirting, capping, coves, beads, steps, curved tiles and other accessory pieces) or mosaics (i.e. any piece that can fit into a 7 cm × 7 cm area, see custom nomenclature).

Ceramic tiles - Definitions, classification, characteristics and marking