91.140.30 通风和空调 标准查询与下载

T/WSJD 25-2022 集中空调系统清洗消毒规程

本文件规定了集中空调系统机组、通风管道、风机盘管、冷却水塔等的清洗与消毒操作步骤，以及清洗消毒效果、污物处理、安全措施、个人防护、质量控制和清洗技术能力基本要求。 本文件适用于集中空调系统，其他类型空调系统可参照执行。

Centralized air conditioning system cleaning and disinfection procedures

T/WSJD 26-2022 水中嗜肺军团菌检验方法——酶底物法

本文件规定了水中嗜肺军团菌酶底物检验方法的原理、设备试剂、检测步骤、结果报告、质量控制等。  本文件适用于非饮用水中嗜肺军团菌的测定，生活饮用水可参照执行。

Method for the detection of Legionella pneumophila in water - enzyme substrate method

BS EN ISO 29462:2022 通过颗粒尺寸和气流阻力对一般通风过滤装置和系统进行原位去除效率的现场测试

1   Scope This document describes a procedure for measuring the performance of general ventilation air cleaning devices in their end use installed configuration. The performance measurements include removal efficiency by particle size and the resistance to airflow . The test procedures include the definition and reporting of the system airflow. The procedure describes a method of counting ambient air particles of 0,3 μm to 5,0 μm upstream and downstream of the in-place air cleaner(s) in a functioning air handling system. The procedure describes the reduction of particle counter data to calculate removal efficiency by particle size . Since filter installations vary dramatically in design and shape, a protocol for evaluating the suitability of a site for filter evaluation and for system evaluation is included. When the evaluated site conditions meet the minimum criteria established for system evaluation, the performance evaluation of the system can also be performed according to this procedure. This document also describes performance specifications for the testing equipment and defines procedures for calculating and reporting the results. This document is not intended for measuring performance of portable or movable room air cleaners or for evaluation of filter installations with an expected filtration efficiency at or above 99 % or at or below 30 % when measured at 0,4 μm.

Field testing of general ventilation filtration devices and systems for in situ removal efficiency by particle size and resistance to airflow

T/CAB 0176-2022 人工环境舒适性产品 第1部分：房间微气候调节器

本文件规定了房间微气候调节器的术语和定义、产品分类、技术要求、试验、检验规则、标志、包装、运输和贮存等。

Artificial atmosphere comfort products part 1: miniature-climate room air conditioner

T/CAB 0167-2022 电子电器风险评估指南 家用电冰箱

针对家用电冰箱复现（疑似）风险问题点，指导开展风险识别、分析和评价等工作，为降低产品风险或进行缺陷分析和风险研判提供信息和依据。

Risk assessment guideline for electronics and electrical appliances - Household refrigerators

T/CAB 0170-2022 电子电器风险评估指南 房间空气调节器

针对房间空气调节器复现（疑似）风险问题点，指导开展风险识别、分析和评价等工作，为降低产品风险或进行缺陷分析和风险研判提供信息和依据。

Risk assessment guideline for electronics and electrical appliances - Room air conditioner

T/CAB 0168-2022 电子电器风险评估指南 多联式空调（热泵）机组

针对多联式空调（热泵）机组复现（疑似）风险问题点，指导开展风险识别、分析和评价等工作，为降低产品风险或进行缺陷分析和风险研判提供信息和依据。

Risk assessment guideline for electronics and electrical appliances—Multiple air conditioning (heat pump) units

T/CAB 0169-2022 电子电器风险评估指南 家用和类似用途电动洗衣机

针对洗衣机复现（疑似）风险问题点，指导开展风险识别、分析和评价等工作，为降低产品风险或进行缺陷分析和风险研判提供信息和依据。

Risk assessment guideline for electronics and electrical appliances - Household and similar electric washing machines

T/CECS 1166-2022 户式辐射空调技术规程

本规程共分7章和2个附录，主要内容包括：总则、术语、设计、设备与材料、施工安装、调试与验收、运行与维护等。

Residential Radiant Air Conditioning Technical Regulations

22/30427567 DC BS ISO 23139 用于处理空气和其他气体的生物设备 污水处理厂除臭应用指南

BS ISO 23139. Biological equipment for treating air and other gases. Application guidance for deodorization in wastewater treatment plants

EN ISO 29462:2022 粒度和耐空气流现场去除效率用全面通风过滤设备和系统的实地测试

This document describes a procedure for measuring the performance of general ventilation air cleaning devices in their end use installed configuration. The performance measurements include removal efficiency by particle size and the resistance to airflow. The test procedures include the definition and reporting of the system airflow. The procedure describes a method of counting ambient air particles of 0,3 μm to 5,0 μm upstream and downstream of the in-place air cleaner(s) in a functioning air handling system. The procedure describes the reduction of particle counter data to calculate removal efficiency by particle size. Since filter installations vary dramatically in design and shape, a protocol for evaluating the suitability of a site for filter evaluation and for system evaluation is included. When the evaluated site conditions meet the minimum criteria established for system evaluation, the performance evaluation of the system can also be performed according to this procedure. This document also describes performance specifications for the testing equipment and defines procedures for calculating and reporting the results. This document is not intended for measuring performance of portable or movable room air cleaners or for evaluation of filter installations with an expected filtration efficiency at or above 99 % or at or below 30 % when measured at 0,4 μm.

Field testing of general ventilation filtration devices and systems for in situ removal efficiency by particle size and resistance to airflow (ISO 29462:2022)

EN ISO 16890-2:2022 一般通风用空气过滤器.第2部分:分数效率和气流阻力的测量

This document specifies the aerosol production, the test equipment and the test methods used for measuring fractional efficiency and air flow resistance of air filters for general ventilation. It is intended to be used in conjunction with ISO 16890‑1, ISO 16890‑3 and ISO 16890‑4. The test method described in this document is applicable for air flow rates between 0,25 m3/s (900 m3/h, 530 ft3/min) and 1,5 m3/s (5 400 m3/h, 3 178 ft3/min), referring to a test rig with a nominal face area of 610 mm × 610 mm (24.0 inches × 24.0 inches). This document refers to particulate air filter elements for general ventilation having an ePM1 efficiency less than or equal to 99 % and an ePM10 efficiency greater than 20 % when tested as per the procedures defined within the ISO 16890 series. NOTE The lower limit for this test procedure is set at a minimum ePM10 efficiency of 20 % since it is very difficult for a test filter element below this level to meet the statistical validity requirements of this procedure. This document is not applicable to filter elements used in portable room-air cleaners.

Air filters for general ventilation - Part 2: Measurement of fractional efficiency and air flow resistance (ISO 16890-2:2022)

EN ISO 16890-4:2022 一般通风用空气过滤器.第4部分:测定最小分数试验效率的调节方法

This document establishes a conditioning method to determine the minimum fractional test efficiency. It is intended to be used in conjunction with ISO 16890‑1, ISO 16890‑2 and ISO 16890‑3, and provides the related test requirements for the test device and conditioning cabinet as well as the conditioning procedure to follow. The conditioning method described in this document is referring to a test device with a nominal face area of 610 mm × 610 mm (24 inches × 24 inches). This document refers to particulate air filter elements for general ventilation having an ePM1 efficiency less than or equal to 99 % and an ePM10 efficiency greater than 20 % when tested according to the procedures defined within the ISO 16890 series. NOTE The lower limit for this test procedure is set at a minimum ePM10 efficiency of 20 % since it will be very difficult for a test filter element below this level to meet the statistical validity requirements of this procedure. Filter elements used in portable room-air cleaners are excluded from the scope of this document.

Air filters for general ventilation - Part 4: Conditioning method to determine the minimum fractional test efficiency (ISO 16890-4:2022)

DB11/T 1832.15-2022 建筑工程施工工艺规程 第15部分：通风与空调安装工程

Construction technology specification for construction engineering Part 15: Ventilation and air-conditioning installation engineering

T/CECS 1141-2022 既有办公建筑通风空调系统节能调适技术规程

本规程共分7章和6个附录，主要内容包括：总则、术语、基本规定、调适流程及目标、调查评估、调适实施、调适验收等。

Technical regulations for energy-saving adjustment of ventilation and air-conditioning systems of existing office buildings

T/CPQS E00031.2-2022 国际健康驿站 智能电器 空气净化器

本文件规定了国际健康驿站空气净化器（下文简称“净化器”）的术语和定义、技术要求、试验方法和标志、使用说明、包装、运输及贮存。

International health station—Smart appliances—Air purifier

T/JSCTS 14-2022 地铁车站通风空调系统智能化运维技术规范

本文件确立了地铁车站智能运维管理系统的组成和功能，并规定了通风空调系统监控、系统运行与节能控制、能效监测与专家系统、故障报警、信息化管理、施工安装、系统调试及竣工验收的要求。 本文件适用于包括埋深大于50m的各种型式的地铁车站的通风空调系统智能化运维的设计、施工、调式和验收，其他类型轨道交通车站可参照执行。

Specification for intelligent operation and maintenance of ventilation and air conditioning system in subway station

ISO 16890-2:2022 一般通风用空气过滤器.第2部分:分数效率和气流阻力的测量

This document specifies the aerosol production, the test equipment and the test methods used for measuring fractional efficiency and air flow resistance of air filters for general ventilation. It is intended to be used in conjunction with ISO 16890-1, ISO 16890-3 and ISO 16890-4. The test method described in this document is applicable for air flow rates between 0,25 m3/s (900 m3/h, 530 ft3/min) and 1,5 m3/s (5400 m3/h, 3178 ft3/min), referring to a test rig with a nominal face area of 610 mm × 610 mm (24.0 inches × 24.0 inches). This document refers to particulate air filter elements for general ventilation having an ePM1 efficiency less than or equal to 99 % and an ePM10 efficiency greater than 20 % when tested as per the procedures defined within the ISO 16890 series. NOTE The lower limit for this test procedure is set at a minimum ePM10 efficiency of 20 % since it is very difficult for a test filter element below this level to meet the statistical validity requirements of this procedure. This document is not applicable to filter elements used in portable room-air cleaners.

Air filters for general ventilation — Part 2: Measurement of fractional efficiency and air flow resistance

ISO 29462:2022 通过粒度和气流阻力对现场去除效率的一般通风过滤装置和系统进行现场试验

This document describes a procedure for measuring the performance of general ventilation air cleaning devices in their end use installed configuration. The performance measurements include removal efficiency by particle size and the resistance to airflow. The test procedures include the definition and reporting of the system airflow. The procedure describes a method of counting ambient air particles of 0,3 μm to 5,0 μm upstream and downstream of the in-place air cleaner(s) in a functioning air handling system. The procedure describes the reduction of particle counter data to calculate removal efficiency by particle size. Since filter installations vary dramatically in design and shape, a protocol for evaluating the suitability of a site for filter evaluation and for system evaluation is included. When the evaluated site conditions meet the minimum criteria established for system evaluation, the performance evaluation of the system can also be performed according to this procedure. This document also describes performance specifications for the testing equipment and defines procedures for calculating and reporting the results. This document is not intended for measuring performance of portable or movable room air cleaners or for evaluation of filter installations with an expected filtration efficiency at or above 99 % or at or below 30 % when measured at 0,4 μm.

Field testing of general ventilation filtration devices and systems for in situ removal efficiency by particle size and resistance to airflow

ISO 16890-4:2022 一般通风用空气过滤器.第4部分:测定最小分数试验效率的调节方法

This document establishes a conditioning method to determine the minimum fractional test efficiency. It is intended to be used in conjunction with ISO 16890-1, ISO 16890-2 and ISO 16890-3, and provides the related test requirements for the test device and conditioning cabinet as well as the conditioning procedure to follow. The conditioning method described in this document is referring to a test device with a nominal face area of 610 mm × 610 mm (24 inches × 24 inches). This document refers to particulate air filter elements for general ventilation having an ePM1 efficiency less than or equal to 99 % and an ePM10 efficiency greater than 20 % when tested according to the procedures defined within the ISO 16890 series. NOTE The lower limit for this test procedure is set at a minimum ePM10 efficiency of 20 % since it will be very difficult for a test filter element below this level to meet the statistical validity requirements of this procedure. Filter elements used in portable room-air cleaners are excluded from the scope of this document.

Air filters for general ventilation — Part 4: Conditioning method to determine the minimum fractional test efficiency