97.020 家政 标准查询与下载

DB4401/T 47-2020 家庭服务业服务规范

Domestic Service Industry Service Standards

T/CAS 402-2020 健康保鲜功能电冰箱技术要求和测试方法

本标准规定了健康保鲜功能电冰箱的技术要求和试验方法。

Technology requirements and test methods for the refrigerators with healthy and food preservation function

KS C IEC 60335-2-68-2019 家用和类似用途电器 安全 第2-68部分：商用喷雾萃取机的特殊要求

Household and similar electrical appliances — Safety — Part 2-68: Particular requirements for spray extraction machines, for commercial use

DB43/T 1709-2019 竹质烧烤签通用技术要求

General technical requirements for bamboo barbecue sticks

DB43/T 1710-2019 日用竹筷通用技术要求

General technical requirements for bamboo chopsticks for daily use

T/ZZB 1484-2019 竹展平砧板

本标准规定了竹展平砧板的术语和定义、基本要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存以及质量承诺。 本标准适用于以竹展平板为主要材料制成的板面无任何胶水的砧板。

Flattened bamboo cutting board

T/HSFJJ 4-2019 感应垃圾桶

外观、耐腐蚀性、气味、容量偏差、盛装性能、内桶提手强度、内桶跌落性能、操作性能、放置稳定性能、开盖稳定性、耐温性能、耐潮湿性、防水性能、控制距离误差、感应性能、抗干扰性能、感应寿命

Induction trash can

CSA/ANSI Z21.54:19 • CSA 8.4-2019 用于便携式户外燃气器具的燃气软管连接器

1 Scope 1.1 This Standard applies to gas hose connectors (See Clause 3 Definitions), hereinafter referred to as connectors. They are conduits for conveying gas and depend for gas-tightness on the wall structure of the hose material. Such connectors are: a) newly produced and constructed entirely of new, unused parts and materials; and b) equipped with a fitting at each end provided with standard taper pipe threads. 1.2 Connectors covered by this Standard are intended for: a) connection of portable outdoor gas-fired appliances to the gas supply piping; b) use in unconcealed outdoor locations; c) use only in locations where they will not be likely to be subject to excessive temperatures [above 200°F (93.5 °C)]; d) use with natural gas, manufactured gas, mixed gases, propane and LP gas-air mixtures; and e) use on gas piping systems having fuel gas pressures not in excess of 1/2 psi (3.45 kPa). 1.3 All references to psi throughout this Standard are to be considered gauge pressure unless otherwise specified. 1.4 Annex A contains provisions that are unique to Canada. 1.5 Clause 2 contains a list of standards specifically referenced in this Standard and sources from which these reference standards may be obtained. 1.6 This Standard contains SI (Metric) equivalents to the yard/pound quantities, the purpose being to allow the standard to be used in SI (Metric) units. (IEEE/ASTM SI 10 is used as a guide in making metric conversion from yard/pound quantities.) If a value for a measurement and an equivalent value in other units, the first stated is to be regarded as the requirement. The given equivalent value may be approximate. If a value for a measurement and an equivalent value in other units, are both specified as a quoted marking requirement, the first stated unit, or both shall be provided. 1.7 In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that within the limits of the standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.

Gas hose connectors for portable outdoor gas-fired appliances

T/ZZB 1005-2019 竹制盛器

本标准规定了竹制盛器的术语和定义、基本要求、技术要求、试验方法、检验规则、标识、使用说明、注意事项、包装、运输和贮存以及质量承诺。 本标准适用于以竹材为主要原料，经胶合、刨削、砂铣、涂饰后制成的放置常温食物的日用器具。

Bamboo container

DB3301/T 0270-2018 养老机构保护性用具使用规范

本标准规定了养老机构内保护性用具的使用范围、使用原则、工作流程和操作流程。 本标准适用于杭州市内养老机构保护性用具的使用和操作管理。

Specifications for the use of protective equipment in nursing homes

T/CSHSA 001-2018 母婴生活护理服务质量规范

　本标准规定了母婴生活护理的术语和定义、母婴生活护理服务组织的基本要求、资源管理、合同文本的要求、服务评价与管理制度、母婴生活护理员的从业基本要求、个人素质要求、个人业务能力要求、个人等级管理。

Quality Standards for Maternal and Infant Life Nursing Services

CSA/ANSI C22.2 No.339-2018 手持式电动工具 安全 链梁锯的特殊要求

1 Scope This clause of Part 1* is applicable, except as follows. * For the purposes of this Standard, the term "Part 1" means "CAN/CSA-C22.2 No. 62841-1 (first edition)/ UL 62841-1 (first edition)". Note: When this Standard states “addition”, “modification”, or “replacement”, the relevant text in Part 1 is to be adapted accordingly. Addition: This Standard applies to chain beam saws for cutting wood or similar material and designed for use by one person. This Standard does not cover chain beam saws that can be installed with more than one guide bar length. This Standard does not cover chain beam saw attachments that convert a circular saw or a chain saw into a chain beam saw. This Standard does not cover a) chain saws as defined in CAN/CSA-C22.2 No. 60745-2-13/UL 60745-2-13; b) chain saws for tree service as defined in CSA Z62.1; or c) pole cutters and pruners as defined in CSA C22.2 No. 147 or UL 82.

Hand-held motor-operated electric tools — Safety — Particular requirements for chain beam saws

T/ZZB 0346-2018 工艺竹木筷

本标准规定了工艺竹木筷的术语和定义、产品分类、基本要求、技术要求、试验方法、检验规则、标识、包装、运输、贮存及质量承诺。 本标准适用于以竹材或木材为主要原料，经镂铣、雕刻、涂饰、热转印等相关加工工艺制成的可多次使用的竹筷或木筷。

Craft bamboo and wooden chopsticks

ASTM F946-85(2018) 建立安全印章控制和责任流程的标准指南

1.1 This guide covers procedures for maintaining a continuous line of accountability for security seals from the time of manufacture to destruction of the seal subsequent to its use. 1.2 The procedures contained herein are applicable to usage of security seals that are coded or numbered in a manner to make each seal unique. See also Classification F832. 1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Guide for Establishing Security Seal Control and Accountability Procedures

IEC 60065:2014/COR3:2018 音频、视频和类似电子设备.安全要求

Audio, video and similar electronic apparatus - Safety requirements

KS G 3704-2017 家用除湿剂

Dehumidifying agent for home use

T/CAQI 33-2017 空气净化器气态污染物净化性能分级 第1部分 甲醛

空气净化器性对气态污染物中甲醛的净化性能分级的术语、定义和评定方法。 气态污染物空气净化器的安全和性能要求。 洁净空气量(CADR甲醛 )、累积净化量(CCM甲醛 )、累积净化量（CCM甲醛）、甲醛去除率（?）、噪声的检测测算方法。 气态污染物净化性能分级评定。

Graduation for gaseous pollutants purifying performance of air cleaner Part 1：Formaldehyde

ASTM F760-93(2017) 食品服务设备手册的标准规范

1.1 This specification covers requirements for manuals for food service equipment which shall contain, as a minimum, complete installation, operating, preventive maintenance and service instructions, including applicable charts and diagrams and an illustrated parts data section. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements see Section 4. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Food Service Equipment Manuals

EN ISO 25649-2:2017 水上和水中用浮动娱乐项目.第2部分:消费者信息

Floating leisure articles for use on and in the water - Part 2: Consumer information

GSO IEC 60335-2-68:2016 家用和类似用途电器安全 第2-68部分：工业和商业用喷雾抽气器具的特殊要求

IEC 60335-2-68:2012+A1:2016 deals with the safety of electrical portable, non-self-propelled motor-operated spray extraction machines with or without attachments and with or without electrical heating elements, intended for commercial indoor use. This standard applies to machines for commercial use. The following list, although not comprehensive, gives an indication of locations that are included in the scope: - public use areas such as hotels, schools, hospitals; - industrial locations, for example factories and manufacturing shops; - retail outlets, for example shops and supermarkets; - business premises, for example offices and banks; - rental services for those machines and all uses other than normal housekeeping purposes. They are not equipped with a traction drive. The following power systems are covered: mains powered motors up to a rated voltage of 250 V for single-phase appliances and 480 V for other appliances and battery powered motors. This standard applies to machines in which the pressure of the employed cleaning agent does not exceed 2,5 MPa, and in which the product of the pressure (in MPa) and the flow of cleaning agent (in litres per minute) does not exceed 100, and in which the temperature of the cleaning agent at the spray nozzle outlet does not exceed 85 °C. This fourth edition cancels and replaces the third edition published in 2002 and its Amendments 1 (2005) and 2 (2007). It constitutes a technical revision. The principal changes in this edition as compared with the third edition of IEC 60335-2-68 are as follows (minor changes are not listed): - the title has been changed for better distinction with regard to IEC 60335-2-72; - the scope has been revised editorially to avoid misunderstandings; - terms and definitions has been revised with regard to the requirements revised; - the standard has been revised in general and updated regarding state-of-the-art, as far as necessary, in particular some changes has been made to Clauses 15, 22 and 25; - the markings and instructions (Clause 7) have been revised basically; - a new Annex AA 'Emission of acoustical noise' was added; - and a new Annex BB 'Emission of vibration' was added. Keywords: Spray extraction machines; cleaning agent. This publication is to be read in conjunction with IEC 60335-1:2010. This consolidated version consists of the fourth edition (2012) and its amendment 1 (2016). Therefore, no need to order amendment in addition to this publication.

Household and similar electrical appliances-Safety-Part2-68:Particular requirements for spray extraction appliances,for industrial and commercial use