97.220.20 标准查询与下载

OENORM ISO 7331:2021 高山滑雪和旅游滑雪用滑雪杖 要求和测试方法（ISO 7331:2020）

Ski-poles for alpine and touring skiing - Requirements and test methods (ISO 7331:2020)

DIN ISO 23223:2021 具有改进步行鞋底的高山滑雪靴 与高山滑雪固定器的接口 要求和测试方法（ISO 23223:2021）

This document specifies the requirements, test methods and marking of ski-boots which are used with current systems of alpine ski-bindings with attachment at the boot toe and boot heel, the proper release function of which depends on the dimensions and design of the interfaces. A

Alpine ski boots with improved walking soles - Interface with alpine ski-bindings - Requirements and test methods (ISO 23223:2021)

KS G 5728-2021 高山滑雪板

Alpine skis

ASTM F472-11(2021) 高山滑雪板几何形状的标准术语

1.1 This terminology covers the terms required to describe the geometry of Alpine skis and does not cover special purpose skis. 1.2 The terms are presented in a sequence considered to be the most logical, with definitions presented later calling upon those presented earlier. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Terminology for Geometry of Alpine Skis

DIN ISO 7331:2021 高山滑雪和旅游滑雪用滑雪杖 要求和测试方法（ISO 7331:2020）

This document defines the minimum requirements for safety in poles for alpine and touring skiing. It specifies test methods to check conformity with these requirements. It is applicable to ski-poles for alpine and touring skiing in the following ranges of total length: - group A,

Ski-poles for alpine and touring skiing - Requirements and test methods (ISO 7331:2020)

DIN ISO 6005:2021 高山滑雪板 滑雪板固定螺钉 测试方法（ISO 6005:2019）

The document specifies methods of test for screws used for fastening ski bindings to alpine skis.

Alpine skis - Ski binding screws - Test methods (ISO 6005:2019)

BS ISO 23223:2021 阿尔卑斯山滑雪靴，鞋底改良 与高山滑雪板绑定的接口 要求和测试方法

Alpine ski boots with improved walking soles. Interface with alpine ski-bindings. Requirements and test methods

ISO 23223:2021 改进步行鞋底的高山滑雪靴.与高山滑雪板连接的接口.要求和试验方法

This document specifies requirements, test methods and marking for alpine ski-boots with improved walking soles that are used with systems of alpine ski-bindings for improved walking soles with attachment at the boot front and boot rear, the proper release function of which depends on the dimensions and design of the interfaces. Alpine ski boots with improved walking soles are intended to a better walkability without affecting the function of the alpine ski binding designed for improved walking soles. This document is applicable to ski-boots of sizes 15,0 and larger (Types A (Adults) and C (Children)) in the Mondo point system (see Annex A).

Alpine ski boots with improved walking soles - Interface with alpine ski-bindings - Requirements and test methods

SN ISO 9838:2021 高山和旅游滑雪板固定器 用于滑雪固定器测试的测试鞋底

Alpine and touring ski-bindings - Test soles for ski-binding tests

SN ISO 9523:2021 成人旅游滑雪靴 旅游滑雪固定装置的接口 要求和测试方法

Touring ski-boots for adults - Interface with touring ski-bindings - Requirements and test methods

T/CSGF 010-2021 移动真冰场技术规范

本文件规定了移动真冰场的术语和定义、要求、试验方法、标志和使用说明。 本文件适用于冰球、自由滑冰、花样滑冰等冰上运动项目的训练、教学、业余比赛及娱乐等活动。 本文件不适用于专业训练及专业比赛用的移动真冰场。

Technical specification for removable skating rink

ASTM F1722-15(2021) 确定高山滑雪板质量和惯性矩的标准测试方法

1.1 This test method covers test measurement methods for mass and moment of inertia of adult Alpine skis.2 1.2 No limitation to ski size is proposed. This test method is applicable to all adult Alpine skis. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Determining Mass and Moment of Inertia of Alpine Skis

GOST R 58843-2021 用于冰球运动的防护装备 一般规格

Protective equipment for use in ice hockey. General specifications

GOST R 58846-2021 用于冰球运动的防护装备 守门员头面部防护要求及试验方法

Protective equipment for use in ice hockey. Requirements and test methods for head and face protection for goalkeepers

GOST R 58845-2021 用于冰球运动的防护装备 滑冰运动员面部防护要求及试验方法

Protective equipment for use in ice hockey. Requirements and test methods of face protection for skaters

GOST R 58847-2021 用于冰球运动的防护装备 运动员颈部撕裂保护器的要求和试验方法

Protective equipment for use in ice hockey. Requirements and test methods for neck laceration protectors for players

OENORM ISO 5355:2020 高山滑雪靴 要求和测试方法（ISO 5355:2019）

Alpine ski boots - Requirements and test methods (ISO 5355:2019)

NF S52-701:2020 高山滑雪和旅游滑雪用滑雪杆. 要求和试验方法

Domaine d'applicationLe présent document définit les exigences minimales relatives à la sécurité des bâtons de ski alpin et de ski de randonnée. Il spécifie les méthodes d'essai destinées à vérifier la conformité à ces exigences.Il s'applique aux bâtons de ski alpin et de ski de

Ski-poles for alpine and touring skiing - Requirements and test methods

BS ISO 7331:2020 用于高山滑雪和旅游滑雪的滑雪杖 要求及测试方法

What is ISO 7331 about?    ISO 7331 discusses skiing equipment. ISO 7331 defines the minimum requirements for safety in poles for alpine and touring skiing. ISO 7331 specifies test methods to check conformity with these requirements.   ISO 7331 is applicable to ski-poles for alpine and touring skiing in the following ranges of total length, l T :  

Ski-poles for alpine and touring skiing. Requirements and test methods

ISO 7331:2020 高山和旅游滑雪用滑雪杆.要求和试验方法

This document defines the minimum requirements for safety in poles for alpine and touring skiing. It specifies test methods to check conformity with these requirements. It is applicable to ski-poles for alpine and touring skiing in the following ranges of total length, lT: — group A, lT ≥ 1050 mm (adults' poles); — group B, 1050 mm > lT ≥ 700 mm (junior poles); — group C, lT < 700 mm (children's poles).

Ski-poles for alpine and touring skiing — Requirements and test methods